Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006     

The magnetic properties of Be-codoped GaMnN grown via molecular beam epitaxy

GaMnN and Be-codoped GaMnN were grown via molecular beam epitaxy using a single GaN precursor and their structural and magnetic properties were examined. X-ray diffraction and superconducting quantum interference device (SQUID) measurements revealed that the grown layers are homogeneous without precipitates. The saturation magnetization of GaMnN has increased from ∼4 to ∼16 emu/cm³ via codoping of Be. The d–d exchange interaction between Mn atoms was discussed for the ferromagnetism of GaMnN.     

Photodecomposition of several compounds commonly used as sunscreen agents

The photolysis reactions of three compounds commonly used as a sunscreen agents, Parsol 1789 (1-[4-(1,1-dimethylethyl)phenyl]-3-(4-methoxyphenyl)-1,3- propanedione), Oxybenzone ((2-hydroxy-4-methoxyphenyl)phenyl-methanone) and Padimate O (2-ethylhexyl-4-(dimethylamino)benzoate), were investigated to provide a chemical background to aid in the understanding of the photosensitization of the sunscreen agents. Photolysis was carried out in cyclohexane for 70–140 h using a mercury vapor lamp (450W) without excluding oxygen.

Irradation of Parsol 1789 in cyclohexane yielded tert-butylbenzene, p-tert-butylbenzoic acid and p-methoxybenzoic acid; products obtained from the combination of the sunscreen with the solvent included the cyclohexyl esters of p-methoxybenzoic acid, p-tert-butylbenzoic acid and methanoic acid; products obtained from the solvent included cyclohexanol, cyclohexanone and dicyclohexyl ether.

Irradiation of Oxybenzone in the cyclohexane for 100 h produced no detectable products by either gas or liquid chromatographic analysis. Oxybenzone was recovered unchanged and no products were observed from the photoinitiated reaction of oxygen with the solvent.

Irradiation of Padimate O in cyclohexane yielded the ethylhexyl esters of p-aminobenzoic acid, p-monomethylaminobenzoic acid and p-dimethylamino (o/m)-methylbenzoic acid, as well as products from the photoinitiated reaction of oxygen with the solvent.     

Magnetotransport and magnetic properties of InAs/Mn digital alloys

We have investigated the magnetic and magneto-transport properties of a systematic sequence of five InAs/Mn digital alloys grown by a combination of molecular beam epitaxy and atomic layer epitaxy. The samples consist of 30 periods of Mn fractional monolayers (ML) (0.17–0.5 ML) separated by 14 ML thick InAs spacer layers in a superlattice configuration. Four samples show n-type electrical conduction while the fifth (0.25 ML Mn) is p-type. Squid magnetization measurements performed on these samples show remnant magnetization above room temperature, which is apparently related to a second phase.     

In situ transmission electron microscopy study of the nucleation and grain growth of Ge2Sb2Te5 thin films

The nucleation and grain growth of the Ge₂Sb₂Te₅ (GST) thin films were studied using high voltage electron microscope operated at 1250 kV. As a result, we have found that 2 nm-sized nucleus forms as a cluster which atoms are arranged regularly at the stage of nucleation prior to the formation of grains having crystal structure. The high-resolution transmission electron microscopy study and fast-Fourier transformations revealed that coexistence of face-centered-cubic (FCC) and hexagonal structure occurs, and formation of twin defect is found in the hexagonal structure during the grain growth as the annealing temperature is increased. GST grain having the hexagonal structure grow from the surface, and the growth proceeded perpendicular to the [0 0 0 1], namely the path parallel to the (0 0 0 1) plane. Consequently, grain growth to a large-scale result in a lengthened shape.     

The Two-Point Codes with the Designed Distance on a Hermitian Curve in Even Characteristic

In Homma M and Kim SJ [2], the authors considered two-point codes on a Hermitian curve defined over fields of odd characteristic. In this paper, we study the geometry of a Hermitian curve over fields of even characteristic and classify the two-point codes whose minimum distances agree with the designed ones.