Analysis of the disaccharides derived from hyaluronic acid and chondroitin sulfate by capillary electrophoresis with sample stacking

CE conditions for monitoring the unsaturated disaccharides of hyaluronic acid (di-HA) and chondroitin sulfate (di-CS) using an alkaline tetraborate buffer, electrokinetic sample injection, and UV absorption detection at 232 nm are reported. Separations were performed in an uncoated fused-silica capillary having reversed polarity and reversed electroosmosis generated with the addition of CTAB to the buffer. The influence of various separation parameters, including the concentration of CTAB, buffer pH, concentration of tetraborate, and applied voltage, on the resolution of the two disaccharides was investigated. Baseline separation was obtained with 25 mM tetraborate at pH 10.0 and having 0.05 mM CTAB. Chloride and phosphate in the sample are beneficial for the stacking of the disaccharides, with di-HA forming a much sharper peak than di-CS. Using samples prepared in 25 mM Tris-HCl (pH 7.5) and electrokinetic injection at the cathode at -10 kV for 40 s, linear relationships between the corrected peak area and the concentration of the disaccharides have been found in the ranges of 1.0-400.0 and 0.1-1.0 microg/mL (0.2-1.0 microg/mL for di-CS), with correlation coefficients being >0.9933 in all cases. The RSDs of detection times and corrected peak areas were between 1.13-1.24 and 1.57-2.13%, respectively. Applied to human serum samples that were prepared by ethanol precipitation and depolymerization of the two polysaccharides with chondroitinase ABC reveals comigration of endogenous compounds with di-HA and a sample-dependent detection time. The di-HA content in the serum sample can be estimated via subtraction of the blank peak that is obtained without enzymatic hydrolysis.     

共沉淀CuO-ZrO2复合氧化物分散态结构研究

用XRD、EXAFS、XPS表征了共沉淀法制备的CuO-ZrO2复合氧化物的分散态结构. 500 ℃焙烧的样品在一定组成范围内形成大体均匀的无定形态固溶体. CuO含量超过其在ZrO2中溶解度时，多余的CuO以CuO晶体形式存在；当ZrO2含量超过其在CuO中溶解度时，多余的ZrO2以四方相ZrO2晶体形式存在.焙烧温度达到800 ℃时，样品由单斜相ZrO2和CuO晶体组成.     

Pore size distributions in low‐k dielectric thin films from X‐ray porosimetry

X‐ray reflectivity has been used to determine the mass uptake of probe molecules in porous thin films supported on thick silicon wafers. The adsorption occurs by capillary condensation when the films are exposed to probe vapor at controlled partial vapor pressures. The probe solvent partial pressure was varied by mixing saturated air and dry air at constant temperature or by changing sample temperature at a constant vapor concentration. Pore size distribution in the films can be calculated from the probe uptake with typical porosimetric approaches such as the application of the Kelvin equation to convert partial pressure into pore size. For illustration, the pore size distribution of three different nanoporous thin films, the primary candidate of ultra‐low‐k interlevel dielectrics in the next generation of integrated circuit chips, was determined with this technique. These samples represent different generations of low‐k dielectrics developed by industry. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2170–2177, 2002     

Simultaneous analysis of oxidized and reduced glutathione in cell extracts by capillary zone electrophoresis

Glutathione (GSH) and glutathione disulfide (GSSG) levels in cells constitute a thiol redox system. They can be used as an indicator of oxidative stress of the cell. In this study, a capillary zone electrophoresis (CZE) method is described that enables quantitation of GSH and GSSG from cellular extracts. The CZE buffer used was 20 mM ammonium acetate containing 5% (v/v) acetic acid at pH 3.1 in conjunction with a polybrene coated capillary operated in reverse polarity mode. Effects of different acids used to prepare cell samples were investigated on CZE performance. The acids include meta phosphoric acid (MPA), trichloroacetic acid (TCA), phosphoric acid (PA) and sulfosalicylic acid (SSA) and are used to stabilize GSH and GSSG before performing CZE analysis. The method features a limit of detection of 4 microM and a limit of quantitation of 12 microM for both GSSG and GSH and recoveries of 94% for GSH and 100% for GSSG. Quantitative analysis of GSSG and GSH in HaCaT cell extracts (5% SSA, w/v) was performed with this method and changes in the ratio of GSH to GSSG in N-ethylmaleimide treated cell sample was observed by comparing with control cell samples.     

六甲基环三硅氧烷非平衡聚合的研究

六甲基环三硅氧烷(D_3)在为催化剂,二甲亚砜为促进剂的情况下聚合,得到了分子量分布窄且没有大环体的聚二甲基硅氧烷。本文指出了反应溶液中溶解的氧会降低催化剂的活性。在除去了溶液中的氧以后,聚合反应速度大为加快,D_3转化率几乎达100％,而且得到的聚合物是活性高分子,可以继续进行聚合。同时还研究了在除氧以后D_3非平衡聚合反应的特点。     

Deposition of Oral Bacteria and Polystyrene Particles to Quartz and Dental Enamel in a Parallel Plate and Stagnation Point Flow Chamber

The aim of this paper is to determine to what extent (i) deposition of oral bacteria and polystyrene particles, (ii) onto quartz and dental enamel with and without a salivary conditioning film, (iii) in a parallel plate (PP) and stagnation point (SP) flow chamber and at common Peclet numbers are comparable. All three bacterial strains showed different adhesion behaviors, and even Streptococcus mitis BMS, possessing a similar cell surface hydrophobicity as polystyrene particles, did not mimic polystyrene particles in its adhesion behavior, possibly as a result of the more negative ζ potentials of the polystyrene particles. The stationary endpoint adhesion of all strains, including polystyrene particles, was lower in the presence of a salivary conditioning film, while also desorption probabilities under flow were higher in the presence of a conditioning film than in its absence. Deposition onto quartz and enamel surfaces was different, but without a consistent trend valid for all strains and polystyrene particles. It is concluded that differences in experimental results exist, and the process of bacterial deposition to enamel surfaces cannot be modeled by using polystyrene particles and quartz collector surfaces.     

Radiation Effects on Concentrated Potassium Hexacyanoferrate(III) Solutions

The neutron irradiated potassium hexacyanoferrate(III) solutions were analyzed for Fe(CN)₆^4?, Fe(CN)₆^3?, and Prussian blue. The retention values (1.1%) were constant throughout the pH and concentration ranges studied, and did not change with the length of irradiation. The complex behavior of the radiochemical yield of the Fe(CN)₆^4? and Prussian blue was attributed to the competition of the various reactions involved in the irradiation.     

Preparation of polymide-imides by direct polycondensation with triphenyl phosphite. V. Aliphatic-aromatic polyamide-imides based on N,N′-bis(ω-carboxyalkyl) benzophenone-3,3′,4,4′-tetracarboxylic diimides

Five diimide-dicarboxylic acids were prepared from benzophenone-3,3′,4,4′-tetracarboxylic dianhydride and glycine, β-analine, 4-aminobutyric acid, 6-aminocaproic acid, and 11-aminoundecanoic acid. New aromatic-aliphatic polyamide-imides were prepared by the direct polycondensation of these diacids with aromatic diamines using triphenyl phosphite in N-methyl-2-pyrrolidone (NMP)–Pyridine solution in the presence of calcium chloride. The resulting polymers were characterized by inherent viscosity, infrared spectra, elemental analyses, solubility, differential scanning calorimetry (DSC), thermogravimetry, and wideangle x-ray diffraction measurements.     

Preparation and electrochemistry of azobenzene self-assembled monolayers on gold--long range tunneling and end-group hydrogen bonding effect

A series of thiol-functionalied azobenzene derivatives (RAzoCnSH: R=H for n=3-6, abbreviated as AzoCnSH; R=CH(3)CONH for n=4, abbreviated as aaAzoC4SH) on gold electrodes were prepared and their self-assembly and electrochemical properties were studied by cyclic voltammetry. They all formed uniform and reproducible self-assembled monolayers (SAMs) on gold and showed well-behaved voltammetric responses in aqueous solution. Both the length of the alkyl chain spacer and the H-bonding of the end acetamino group had effects on the stability and the electrochemical kinetics of the SAMs, and the effect of the H-bonding was dominant. The surface coverage of the SAMs (AzoCnSH) is gradually increased with an increase of the alkyl chain spacer length, whereas the presence of the terminal acetamino group leads to a greater increase of the surface coverage. At a low scan rate, voltammetric responses corresponding to an irreversible two-electron, two-proton reduction/oxidation of the trans-azobenzene redox center were obtained in the range of +300 mV and -800 mV, which exhibited very large peak-to-peak splitting. At a high scan rate of 500 mV/s, two steps of reversible one-electron, one-proton reduction/oxidation corresponding to the cis-isomer in azobenzene-thiol SAMs (n is odd) was clearly observed between +300 and -200 mV. The apparent electron-transfer rate is decreased with increasing distance between the azobenzene redox center and the gold electrode. The existence of the end acetamino group which restricted the conformational change during the redox process also led to a decrease of the standard rate constant, and this restriction effect is more predominant than the distance effect.     

Studies on mass production of transformed Panax ginseng hairy roots in bioreactor

The growth properties of Panax ginseng hairy roots transformed by Agrobacterium rhizogenes were compared between flask and aerated column or stirred bioreactor. In flask cultures, sucrose, initially 30 g/L, was nearly exhausted after 45 d of culture. The pH of the medium dropped from 5.5 to 4.96 after 10 d, but afterward it gradually increased to 6.4. After 45 d, hairy roots grew about 16-folds. The growth rate of hairy roots in air-bubble column or stirred bioreactor cultures was 1.13 (1.11) to 1.23 (1.20) g fresh wt (dry wt)/(g of cells·d), respectively. For both bioreactors, growth was about three times as high as in the flask cultivation.