Column-switching high-performance liquid chromatographic analysis of carbamazepine and its principal metabolite in human plasma with direct sample injection using an alkyl-diol silica (ADS) precolumn

In this paper, the on-line coupling of solid-phase extraction, based on a restricted-access support with high-performance reverse phase chromatography for the analysis of carbamazepine (CBZ) and carbamazepine-10,11-epoxide (CBZ-E) in human plasma samples is described. A precolumn packed with 25 mum C(18) alkyl-diol support is used for direct plasma injection. Using column-switching techniques, the analytes were enriched on the precolumn by a 5 mM phosphate buffer (pH 7) with 2% of methanol solution at a flow-rate of 0.8 ml min(-1), while proteins and endogenous hydrophilic substances in plasma were washed off to waste. The enriched analytes were then back-flushed onto the analytical C(18) column, separated by a mixture of 10 mM phosphate buffer (pH 7) acetonitrile (70:30 v/v) solution at a flow-rate of 1.0 ml min(-1) and detected by the ultraviolet absorbance set at 212 and 285 nm and without transfer loss. Linear calibration graphs were obtained for sample injection volumes of 50 (0.2-4.0 of mug of CBZ ml(-1) and 0.1-5.0 mug of CBZ-E ml(-1), respectively), and 20 mul (5.0-20.0 mug of CBZ ml(-1)); in either case the r-value was >0.9963. Recoveries from spiked plasma samples were quantitative for both analytes and the coefficients of variation were below 3.83%. The lowest samples concentrations that can be quantified with acceptable accuracy and precision was 0.2 mug CBZ ml(-1) and 0.1 mug CBZ-E ml(-1) when a sample volume of 50 mul was injected. Concentrations of 0.08 and 0.05 mug ml(-1) of CBZ and CBZ-E were considered the limit of detection for a signal-to-noise ratio of 3. Furthermore, the developed column-switching method was successfully applied to the determination of CBZ and CBZ-E in plasma samples of patients submitted to CBZ therapy.     

Preparation and characterization of silicate gel glasses containing Cr2O3

The effect of thermal treatment on the structural incorporation of Cr₂O₃ in xCr₂O₃·(100 – x)SiO₂ and 5R _n O·xCr₂O₃·(95 – x)SiO₂ (where x=0.01–1 mol.% and R=Li, Na and Ca) gel glasses was studied by optical absorption spectrophotometry, DTA-TG, XRD and electron microscopy.Samples heat treated at 60°C have green color due to the presence of Cr³⁺ in octahedral coordination. The optical transmission, and color (yellow, orange or ambar), of the samples heat treated between 200 and 700°C prove that Cr³⁺ (octahedrally coordinated) and Cr⁶⁺ (tetrahedrally coordinated) are both present. Segregation of Cr₂O₃ take place at temperatures above 800°C.In reducing conditions the gel glasses were green due to the presence of a high content of Cr³⁺ ions. Samples containing Li or Na show crystalline phases at temperatures below 850°C.     

Electrical conductivities of halide salts in aqueous formamide solutions

The electrical conductivities of sodium chloride and sodium iodide solutions in formamide-water mixtures of different composition have been measured at 25°C. From these data, the limiting equivalent conductances for these salts have been determined. The correspondingWalden products are compared together with the one reported for sodium bromide in the same solvent mixtures, and they are analysed as functions of the anion size. Further, the limiting ionic equivalent conductances are estimated for the different ions. The variation of the ionicWalden products with solvent composition is discussed in terms of ionic solvation and solvent structure.

---

Elektrische Leitfähigkeit von Halogensalzen in wäßrigen Formamid-Lösungen

Zusammenfassung Es wurden die elektrischen Leitfähigkeiten von Natriumchlorid- und Natriumjodidlösungen in Formamid-Wasser-Mischungen verschiedener Zusammensetzung bei 25°C gemessen. Aus diesen Daten wurden die Grenzäquivalenzleitfähigkeiten für diese Salze bestimmt. Die entsprechendenWalden-Produkte wurden mit den für Natriumbromid in den gleichen Lösungsmittelgemischen berichteten verglichen und hinsichtlich der Anionengrößen analysiert. Außerdem wurden die ionischen Grenzäquivalenzleitfähigkeiten für die einzelnen Ionen abgeschätzt. Die Variation der ionischenWalden-Produkte mit der Lösungsmittelzusammensetzung wurde bezüglich Ionensolvatation und Lösungsmittelstruktur diskutiert.

     

Accurate intermolecular ground state potential of the Ne-HCl van der Waals complex

From an accurate ground state intermolecular potential energy surface we evaluate the rovibrational spectrum of the Ne-HCl van der Waals complex. The intermolecular potential is obtained by fitting a considerable number of interaction energies obtained at the coupled cluster singles and doubles including connected triple excitations level and with the augmented correlation consistent polarized valence quintuple zeta basis set extended with a set of 3s3p2d1f1g midbond functions. This basis set is selected after a systematic basis set study carried out at geometries close to those of the three main surface stationary points. The surface is characterized by two linear minima, i.e. Ne-ClH and Ne-HCl, with distances from the Ne atom to the HCl center of mass of 3.398 and 3.833 angstroms, respectively; and binding energies of -65.10 and -66.85 cm(-1), respectively. These results agree well with the experimental data available in contrast to previous theoretical results. The rovibrational spectra calculated for the different isotopic species are also compared to the experiments.     

A comparative XAS and X-ray diffraction study of new binuclear Mn(III) complexes with catalase activity. indirect effect of the counteranion on magnetic properties

Four new binuclear Mn(III) complexes with carboxylate bridges have been synthesized: [[Mn(nn)(H(2)O)](2)(mu-ClCH(2)COO)(2)(mu-O)](ClO(4))(2) with nn = bpy (1) or phen (2) and [[Mn(bpy)(H(2)O)](2)(mu-RCOO)(2)(mu-O)](NO(3))(2) with RCOO = ClCH(2)COO (3) or CH(3)COO (4). The characterization by X-ray diffraction (1 and 3) and X-ray absorption spectroscopy (XAS) (1-4) displays the relevance of this spectroscopy to the elucidation of the structural environment of the manganese ions in this kind of compound. Magnetic susceptibility data show an antiferromagnetic coupling for all the compounds: J = -2.89 cm(-1) (for 1), -8.16 cm(-1) (for 2), -0.68 cm(-1) (for 3), and -2.34 cm(-1) (for 4). Compounds 1 and 3 have the same cation complex [[Mn(bpy)(H(2)O)](2)(mu-ClCH(2)COO)(2)(mu-O)](2+), but, while 1 shows an antiferromagnetic coupling, for 3 the magnetic interaction between Mn(III) ions is very weak. The four compounds show catalase activity, and when the reaction stopped, Mn(II) compounds with different nuclearity could be obtained: binuclear [[Mn(phen)(2)](mu-ClCH(2)COO)(2)](ClO(4))(2), trinuclear [Mn(3)(bpy)(2)(mu-ClCH(2)COO)(6)], or mononuclear complexes without carboxylate. Two Mn(II) compounds without carboxylate have been characterized by X-ray diffraction: [Mn(NO(3))(2)(bpy)(2)][Mn(NO(3))(bpy)(2)(H(2)O)]NO(3) (5) and [Mn(bpy)(3)](ClO(4))(2).0.5 C(6)H(4)-1,2-(COOEt)(2).0.5H(2)O (8).     

Determination of lead in natural waters using flow injection with on-line preconcentration and flame AAS detection

A rapid and sensitive method has been developed for the determination of lead in water samples by flame atomic absorption spectrometry using on-line preconcentration on a microcolumn packed with silica gel treated with a mixture of Aliquat 336 and nitroso-R-salt. The lead is retained at pH 5.5. The preconcentrated lead is directly eluted from the column to the nebulizer-burner system using 150 L of 0.1 mol/L hydrochloric acid. The optimum preconcentration conditions are given and the retention efficiency achieved is higher than 80%. The enrichment factor is 37 and 100 for sample volumes of 5 and 30 mL, respectively. The limits of detection are 10.0, 6.0 and 4.0 ng/mL when 5, 10 and 30 mL of water is preconcentrated.     

Unsupported gold(I)-copper(I) interactions through eta1 Au-[Au(C6F5)2]- coordination to Cu+ Lewis acid sites

The reaction of the complex [Au2Ag2(C6F5)4)N[triple bond]CCH3)2]n (1) with 1 equiv of CuCl in the presence of 1 equiv of pyrimidine ligand leads to the formation of the heteronuclear Au(I)-Cu(I) organometallic polymer [Cu{Au(C6F5)2}(N[triple bond]CCH3)(mu2-C4H4N2)]n (2) through a transmetalation reaction. Complex 2 displays unprecedented unsupported Au(I)...Cu(I) interactions of [Au(C6F5)2]- units with the acid Cu(I) sites in a [Cu(N[triple bond]CCH3)(mu2-pyrimidine)]n+(n) polymeric chain. Complex 2 has a rich photophysics in solution and in the solid state.     

Synthesis of monoacyl A-ring precursors of 1alpha,25-dihydroxyvitamin D3 through selective enzymatic hydrolysis

An efficient synthesis of monoacylated 1alpha,25-dihydroxyvitamin D3 A-ring precursors 15, 16, 18, and 19 has been described through an enzymatic hydrolysis process. Candida antarctica A lipase (CAL-A) hydrolyzes the C-5 acetate ester in trans stereoisomers 9 and 13, with complete and high selectivity, respectively. In the case of cis isomers 11 and 14, Chromobacterium viscosum lipase (CVL) is the enzyme of choice, exhibiting opposite selectivity for these two enantiomers. This lipase selectively catalyzes the hydrolysis at the C-3 acetate in diester 11 and at C-5 position in diester 14. It is noteworthy that through a hydrolysis reaction CAL-A and CVL allow the synthesis of the four A-ring monoacetylated precursors of 1alpha,25-dihydroxyvitamin D3, precursors which are complementary to those obtained by the enzymatic acylation process. In addition, with excellent yield CVL selectively hydrolyzes the C-3 chloroacetate ester instead of the C-5 acetate in diester 22, a key intermediate in the synthesis of new A-ring modified 1alpha,25-dihydroxyvitamin D3 analogues.     

Evaluation of surface- and ground-water pollution due to herbicides in agricultural areas of Zamora and Salamanca (Spain)

The pollution of agricultural land due to herbicides was assessed in the Guare?a and Almar river basins, situated in the provinces of Zamora and Salamanca (Spain). A set of fifteen herbicides, including triazines, ureas, amides and others, was selected owing to their frequency of use, the amounts used, their toxicity and their persistence in the environment. Solid-phase extraction with polymeric cartridges, followed by HPLC with diode-array detection, were used to monitor the herbicides. This technique was chosen owing to the wide range of functionality and polarity of the analytes under study. The detection limits obtained were in the 0.004-0.025 microg/l range (lambda=220 nm). Surface and ground waters, taken from different locations in the basins, were analyzed over a 6-month period. The presence of six out of the fifteen herbicides monitored--chlortoluron, atrazine, terbutryn, alachlor, diflufenican and fluazifop-butyl--was detected in several samples at levels ranging from the detection limit to 1.2 microg/l. The relationship of these herbicides to the agricultural activities of the zone is discussed.     

Synthesis, solid-state structure, and bonding analysis of the beryllocenes [Be(C5Me4H)2], [Be(C5Me5)2], and [Be(C5Me5)(C5Me4H)

The beryllocenes [Be(C(5)Me(4)H)(2)] (1), [Be(C(5)Me(5))(2)] (2), and [Be(C(5)Me(5))(C(5)Me(4)H)] (3) have been prepared from BeCl(2) and the appropriate KCp' reagent in toluene/diethyl ether solvent mixtures. The synthesis of 1 is facile (20 degrees C, overnight), but generation of decamethylberyllocene 2 demands high temperatures (ca. 115 degrees C) and extended reaction times (3-4 days). The mixed-ring beryllocene 3 is obtained when the known [(eta(5)-C(5)Me(5))BeCl] is allowed to react with K[C(5)Me(4)H], once more under somewhat forcing conditions (115 degrees C, 36 h). The structures of the three metallocenes have been determined by low-temperature X-ray studies. Both 1 and 3 present eta5/eta1 geometries of the slip-sandwich type, whereas 2 exhibits an almost regular, ferrocene-like, sandwich structure. In the mixed-ring compound 3, C(5)Me(5) is centrally bound to beryllium and the eta(1)-C(5)Me(4)H ring bonds to the metal through the unique CH carbon atom. This is also the binding mode of the eta(1)-ring of 1. To analyze the nature of the bonding in these molecules, theoretical calculations at different levels of theory have been performed on compounds 2 and 3, and a comparison with the bonding in [Be(C(5)H(5))(2)] has been made. As for the latter molecule, energy differences between the eta5/eta5 and the eta5/eta1 structures of 2 are very small, being of the order of a few kcal mol(-1). Constrained space orbital variations (CSOV) calculations show that the covalent character in the bonding is larger for [Be(C(5)Me(5))(2)] than for [Be(C(5)H(5))(2)] due to larger charge delocalization and to increased polarizability of the C(5)Me(5) fragment.