Flow injection analysis for calcium in serum,water and waste waters by spectrophotometry and by ion-selective electrode

The Flow Injection technique is shown to provide fast, reliable and sensitive methods for the determination of calcium in various aqueous as well as serum samples; spectrophotometric or potentiometric detection can be used. At sampling rates of 100–110 samples per hour, with 30-μl sample injections, high reproducibility of measurement and low reagent consumption are achieved in both methods. In the spectrophotometric method, the analytical readout is available within 12 s after sample injection at a total reagent consumption of 0.75 ml per analysis. The potentiometric measurement of the calcium activity in serum is placed on a reliable basis by alternating measurements of serum samples and aqueous standards without incurring any non-reproducible changes in potential between aqueous and serum solutions. This permits the simultaneous determination of pH and pCa, the analytical readout being available within XXX s of sample injection. The good agreement between the results obtained with the Flow Injection method and those attained by atomic absorption and EDTA titrations as well as pCa stat-measurements show that the new methods are potentially suitable for routine analysis.     

Hybridization in some macrocyclic polyacetylenes

The hybridization in several cyclic polyacetylene compounds has been calculated by the maximum overlap method, assuming planar and non-planar geometries of the molecules. In the planar configuration the hybrids describing the molecular skeleton deviate from the corresponding bond directions. We have a few “bent” bonds, but in contrast to the situation in small rings, here the deviation angles are negative, i.e., the hybrids point toward the inside of the ring. Non-planar structures in which acetylene groups are kept in a plane and CCH₂ or CH₂ groups are displaced out of the plane show less deviation from the bond directions of bent bonds. Furthermore, the deviation angles decrease with an increase in the out-of-plane displacement of methylene groups. Finally, when the angle of bending of the molecules approaches 50°, the deviation vanishes, predicting a puckered conformation for the molecules. Correlation between CC stretching vibration frequencies and the corresponding CC bond overlap is discussed.     

Papierchromatographische Trennung und Identifizierung der Polyäthylenglykole und ihrer Monoäther

Zusammenfassung Es wurde eine chromatographische Methode zur Auftrennung und Identifizierung der Polyäthylenglykole und ihrer Monoäther nach Über-führung in die Ester der 3,5-Dinitrobenzoesäure ausgearbeitet. Es wurden entweder Lösungsmittelsysteme mit Dimethylformamid oder Formamid als stationäre und Hexan, Cyklohexan, Benzol, Chloroform und ihre Gemische als mobile Phase oder mit Paraffinöl imprägnierte Papiere und das Gemisch Dimethylformamid—Methylalkohol—Wasser als mobile Phase angewendet.

---

Summary A Chromatographic method has been developed for the separation and identification of the polyethylene glycols and their mono-ethers after conversion into the esters of 3,5-dinitrobenzoic acid. The solvent systems employed consisted of dimethylformamide or formamide as stationary phase and hexane, cyclohexane, benzene, chloroform and their mixtures as mobile phase, or papers impregnated with paraffin oil and the mixture of dimethyl-formamide-methyl alcohol were used as the mobile phase.

---

Résumé On a élaboré une méthode chromatographique de séparation et d'identification des polyéthylèneglycols et de leurs monoéthers après leur transformation en ester de l'acide dinitro-3,5 benzoïque. On a employé soit les systèmes de solvants avec le diméthylformamide ou le formamide comme phase stationnaire, et l'hexane, le cyclohexane, le benzène, le chloroforme et leurs mélanges comme phase mobile, ou des papiers imprégnés d'huile de paraffine et le mélange diméthylformamide-alcool méthylique-eau comme phase mobile.

---

---

Herrn Dipl.-Ing.J. Kami aus unserem Institut danken wir für die Darstellung und Reinigung einiger angewandter Verbindungen.     

Effect of selenium oxidation state on cadmium translocation in chamomile plants

Syntheses and spectral characteristics of cadmium(II) compounds (CdSeO₄, CdSeO₃, and Cd(NCSe)₂(nia)₂) containing selenium in oxidation states (VI), (IV), and (-II) are described. In Cd(NCSe)₂(nia)₂, nicotinamide (nia) and selenocyanate anions are bonded to Cd atom as N-donor monodentate ligands. Nicotinamide is coordinated through the ring nitrogen atom. The effects of these selenium compounds as well as Cd(NCS)₂(nia)₂ on the growth and Cd accumulation in roots and shoots of hydroponically cultivated chamomile plants (cultivar Lutea) were studied. In the applied concentration range (12–60 μmol dm⁻³) Cd(NCS)₂(nia)₂ affected neither the length nor the dry mass of roots and shoots. Other compounds applied at 24 μmol dm⁻³ and 60 μmol dm⁻³ significantly reduced dry mass of roots and shoots. Selenium oxidation state in the cadmium compounds affected Cd accumulation in plant organs as well as Cd translocation within the plants, which was reflected in the values of bioaccumulation (BAF) and translocation factors (S/R). Cd amount accumulated by shoots was lower than that in the roots. The highest BAF values determined for Cd accumulation in shoots were obtained with CdSeO₄. Substitution of S with Se in the Cd(NCX)₂(nia)₂ (X = Se or S) caused an increase of Cd translocation into the shoots. Presented at the XVIIIth Slovak Spectroscopic Conference, Spišská Nová Ves, 15–18 October 2006.     

Determination of imazalil by on-line coupled capillary isotachophoresis with capillary zone electrophoresis

A simple, rapid and reproducible capillary isotachophoretic on-line coupled with capillary zone electrophoresis (CITP-CZE) method for the determination of IMz in food packaging extracts and its residues in apples is described. A good separation of the IMZ from other sample constituents was achieved within 15 minutes without any sample clean up. Method characteristics (linearity, accuracy, intra-assay and detection limit) were determined. Less amount of time involved, sufficient sensitivity and low running cost are the important attributes of CITP-CZE method.     

Charge transfer across a polymer gel/liquid interface: determination of ionophores

An electrochemical method for the determination of the ionophores monensin and lasalocid was developed, based on the polarization of an agar gel/nitrobenzene electrolyte interface. The measured current corresponding to the facilitated ion transfer across this interface is directly proportional to the concentration of an ionophore dissolved in the organic phase. Using cyclic voltammetry in a three-electrode system the detection limit for both ionophores is about 3 × 10^?5 M.     

Investigation of isothermal bulk polymerization ofo-alkyaryl methacrylates by DSC

The kinetics of the AIBN-initiated free radical bulk polymerization of fiveo-alkylphenyl methacrylates was studied by means of DSC in the temperature range 353–373 K, and the enthalpy of polymerization, the overall reaction rate constant and the activation energy were determined. The results were compared with those published recently on correspondingp-alkylaryl methacrylates. All measured reaction rate constants were found to increase with increasing temperature and to decrease with increasingo-alkyl substituent mass and size. It was shown thato-substituents influence the rates of polymerization to a greater extent thanp-substituents. At about 373 K, all differences in rate, most probably resulting from steric hindrance caused by the alkyl groups, disappear in both series, a phenomenon earlier observed for dimethyl phenyl methacrylates.This work was supported by the Ministry of Science of the Republic of Serbia.     

Über Reaktionen von Nitrosophenolen, 4. Mitt.: Reaktion von Nitrosonaphtholen mit Naphtholen

Zusammenfassung Die Reaktion von 1-Nitroso-2-naphthol mit 1-und 2-Naphthol sowie die Reaktion von 2-Nitroso-1-naphthol mit 2-Naphthol in Äthanol und in Äther bei Anwesenheit von HNO₃ gibt 5H-Dibenzo[a,j]phenoxazon-(5) (I), 5H-Dibenzo[a,j]phenoxazon-(5)-14-oxid (II), 5H-Dibenzo[a,h]phenoxazon-(5) (III) sowie 5H-Dibenzo[a,h]phenoxazon-(5)-14-oxid (IV). Es wurde ein Reaktionsmechanismus vorgeschlagen und die Konstitution der hergestellten Verbindungen spektrophotometrisch und potentiometrisch bestimmt.

---

The reaction of 1-nitroso-2-naphthol with 2-and 2-naphthol and the reaction of 2-nitroso-1-naphthol with 2-naphthol in ethanol or ether in the presence of nitric acid have been studied. The main reaction products isolated were the dibenzophenoxazones I–IV. The reaction mechanism for their formation is proposed.

---

---

Mit 4 Abbildungen     

The effect of mechanical activation on the thermal decomposition of chalcopyrite

Experimental results on the influence of preliminary mechanical activation on the thermal decomposition of chalcopyrite are presented and discussed. The following experimental facts were found:

Peroxides of higher aliphatic ethers

The oxidation of higher aliphatic ethers with oxygen at 50° yields two peroxides as the main oxidation products for each ether, namely a dihydroperoxy-dialkyl ether and a dihydroperoxy-dialkyl peroxide. The mass spectra of these compounds are recorded and the main fragmentation pattern is discussed.