Studies of the reactions between indole-2,3-diones (isatins) and 2-aminobenzylamine

Reflux of equimolecular amounts 2-aminobenzylamine and isatins in acetic acid produced indolo[3,2-c]quinolin-6-ones in good yields. A proposed mechanism involving initial formation of a spiro compound is given. This isolable intermediate subsequently rearranges via a sequential isocyanate ring opening and a cyclisation process to a urea derivative which finally cyclized to the indolo[3,2-c]quinolin-6-ones. The urea derivative could be prepared separately and cyclized selectively to indolo[3,2-c]quinolin-6-one. Reaction of N-acetylisatin with 2-aminobenzylamine at room temperature yielded the 1,4-benzodiazepinone 3-(2-acetamidophenyl)-1,5-dihydro-1,4-benzodiazepin-2-one whereas its isomer 2(2-acetamidophenyl)-4,5-dihydro-1,4-benzodiazepin-3-one was obtained from 2-(2-acetylaminophenyl)-N-(2-aminobenzyl)-2-oxoacetamide in acetic acid at room temperature.The previously unknown linear isomer of indolo[3,2-c]quinolin-6-one, i.e. indolo[2,3-b]quinolin-11-one, has been prepared by thermal (260°C) cyclization of methyl 2-phenylamino indole-3-carboxylate, which in turn was prepared in two steps from methyl indole-3-carboxylate.     

Monitoring of ethanol during fermentation using a microbial biosensor with enhanced selectivity

The present study is concerning the construction of ferricyanide-mediated Gluconobacter oxydans cell ethanol biosensor. The size exclusion effect of a cellulose acetate membrane was used for elimination of glucose interferences during ethanol assays in real samples. A typical response time of the biosensor was 13 s with a high sensitivity of 3.5 microA mM(-1). The microbial biosensor exhibits a very low detection limit of 0.85 microM and a wide linear range from 2 to 270 microM. The operational stability was excellent. During 8.5 h of repetitive ethanol assays, no decrease in the sensor sensitivity was observed. The biosensor was successfully used in the off-line monitoring of ethanol fermentation with a good agreement with HPLC measurements (R(2)=0.998).     

Compehensive two-dimensional gas chromatography (GC×GC) and its applicability to the characterization of complex (petrochemical) mixtures

In general, petrochemical products contain only a limited number of chemical classes of compounds (sample dimensionality). The enormous number of individual components within these classes, however, soon puts limitations upon a single chromatographic technique when it comes to adequate characterization of these products. Comprehensive two-dimensional gas chromatography (GC×GC) clearly opens the possibility of estimating the composition of hydrocarbon mixtures in a far more detailed fashion than hitherto possible. Although the emphasis of papers of GCxGC thus far almost exclusively applies to the unsurpassed peak-capacity, in the oil industry there is a need for characterization, rather than for analyzing all the individual compounds. In principle a GCxGC system can provide an almost perfect match between its intrinsic properties and the dimensionality of oil samples. To establish the applicability of GCxGC towards petrochemical analytical challenges, a commercially aavailable prototype instrument was subjected to an exhaustive characterization of a typical hydrocarbon precess stream and a fast characterization of a light gas oil. Although there are no fundamental limitations towards the quantitative aspects of a GCxGC system, this paper confines itself to qualitative results only. Quantitative aspects of GCxGC will be published in a forthcoming paper.     

Analysis of anthracycline antitumour drugs in tissues and body fluids using liquid chromatography

Anthracyclines, with doxorubicin as the major representative, are amongst the most important chemotherapeutic agents used in cancer therapy. In order to reduce the severe side effects associated with their use, and to increase therapeutic efficacy, analogue development still continues, and analytical requirements change concomitantly. The available methods for bioanalysis of anthracyclines are summarized, with emphasis on high-performance liquid chromatography. Attention is paid to sample pretreatment, the possibilities of liquid—liquid and solid-phase extraction, and the chromatographic behaviour of the anthracyclines.     

Amperometry with two polarizable electrodes. XVI

Summary Conditions for the magnesium determination in alkaline solution by EDTA titration with biamperometric indication were examined. The most preferable pH range was found to be above 9.6. A reliable determination can be carried out in the presence of Ca, Ni, Cu and Co up to the ratio of 11. In the case of higher concentrations of Cu and Ni masking with potassium cyanide can be used. In this case, however, a change of the titration curves occurs.A new method for the determination of water-hardness by biamperometric indication is proposed. It is rapid and accurate and meets the requirements of routine and research work (error: ±1%).

---

Zusammenfassung Die Bedingungen für die Magnesiumbestimmung in alkalischer Lösung durch Titration mit ÄDTA bei biamperometrischer Endpunktsanzeige wurden untersucht. Der günstigste pH-Bereich liegt über 9,6. Zuverlässige Bestimmungen können in Gegenwart von Ca, Ni, Cu und Co bis zum Verhältnis 11 ausgeführt werden. Höhere Konzentrationen an Cu oder Ni können mit KCN maskiert werden, wobei allerdings eine Umkehrung der Kurven auftritt.Ein Verfahren zur Wasserhärtebestimmung mit biamperometrischer Indikation wird vorgeschlagen, das schnell durchzuführen ist und genaue Werte liefert (Fehler ±1%).

---

---

Part XV: Vorlíek, J., and P. Peták: Microchem. J. 12, 466–471 (1967).     

The synthesis of 4‐amino‐3‐(2‐pyridyl)pyrazolo[5,1‐c][1,2,4]triazine and some of its derivatives

A mixture of both geometrical isomers of hydrazones 3a‐3e was obtained by the coupling reactions of pyrazole‐3‐diazonium salts 2a‐2d and benzenediazonium chloride 2e with 2‐pyridylacetonitrile 1 . Hydrazones 3a‐3d were cyclized to the corresponding 4‐amino‐3‐(2‐pyridyl)pyrazolo[5,1‐c][1,2,4]triazines 4a‐4d.     

Kinetic parameters of the In(III)/In(I) electrode reaction in bromide medium

The electrode kinetic parameters of the In(III)/In(I) couple in acidic 4M bromide solution have been determined by means of the rotating disc electrode technique.

---

Die elektrochemisch-kinetischen Parameter des In(III)/In(I)-Redoxsystems in Bromidlösung (Kurze Mitteilung)

Zusammenfassung Die elektrochemisch-kinetischen Parameter am In(III)/In(I)-Redoxsystem wurden in saurer 4-M-Bromidlösung mittels der rotierenden Scheibenelektrode bestimmt.

     

The reaction of N-Acylpyridinium salts with indole

Depending on the solvent used and the ratio of the reactants, N-acylpyridinium salts condense with indole to give 3-(N-acyl-1,4-dihydro-4-pyridyl)indole ( 1 ) or 4-(N-acyl-3-indolyl)pyridinium chloride ( 3 ). Compound 1 is an intermediate in the formation of compound 3 . The reaction mechanism has been studied, and a hydrogen transfer reaction is suggested as a key step. Alkaline hydrolysis, e.g., of 4-(N-acetyl-3-indolyl)pyridinium chloride ( 3a ), gave 3-(4-pyridyl)indole ( 2a ). The reaction of α-chlorosubstituted acyl halides with indole, in the presence of pyridine constitutes a convenient synthesis of 3-chloroacylindoles.