Fabrication of Dendrimer－like PAMAM Based on Silica Nanoparticles

A G 4.0 dendrimer-like poly (amido amine) (PAMAM) based on silica nanoparticles was fabricated via a divergent approach.It was built from γ-aminopropyi silica nanoparfides (APSN) core via repetitive addition of acrylate (MA) and hexylenediamine (HDA). FT-IR and EA were used to monitor the progress of dendrimer during each step. The amino group content of the resulting product increased from 0.49 to 3.72 mmol/g after the 4th generation. In addition, the percentage of grafting increased with increasing generation and reached to 65.9% after 4th generation. It was found that the resulting silica nanoparticles could be dispersed in methanol with a mean hydrodynamic particle diameter of 152.7 nm although the silica nanoparticles had agglomerated during the storage period.     

Substructuring preconditioners for saddle-point problems arising from Maxwell's equations in three dimensions

This paper is concerned with the saddle-point problems arising from edge element discretizations of Maxwell's equations in a general three dimensional nonconvex polyhedral domain. A new augmented technique is first introduced to transform the problems into equivalent augmented saddle-point systems so that they can be solved by some existing preconditioned iterative methods. Then some substructuring preconditioners are proposed, with very simple coarse solvers, for the augmented saddle-point systems. With the preconditioners, the condition numbers of the preconditioned systems are nearly optimal; namely, they grow only as the logarithm of the ratio between the subdomain diameter and the finite element mesh size.

     

A Promising MoO_x-based Catalyst for n-Heptane Isomerization

The increasing demand for higher-octane gasoline and the regulations limiting the amount of aromatics in the fuel motivate the interest in catalytic isomerization of n-alkanes. In the last ten years, transition metal oxides or oxycarbides based on molybdenum or tungstate have attracted much attention due to their high activity and isomerization selectivity compared to the conventional bifunctional supported platinum catalyst and high resistance to sulphur and nitrogen catalyst poisons1-5. Ma…     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

相对论平均场理论中各种有效相互作用对中子星性质的影响

基于相对论平均场理论，研究了各种相互作用参数组(NL1、NL3、NLSH、TM1和GL-97)对中子星物质的性质和中子星整体结构的影响．发现参数组NL1、NL3和NLSH所给出的中子星内部的介子场强度、物质的组成比例、物态方程和中子星的整体特点基本相同，但与TM1和GL-97之间有较大的差别．相对于其他参数组，GL-97给出的介子场强度最弱，中子星的相对数密度最大，物态方程也最软，同时采用GL-97参数组计算的中子星的最大质量也最小．     

一维粗糙表面散射特征的数值分析

使用Monte Carlo模拟的方法得出了随机粗糙表面，在Kirchhoff近似的基础上，利用数值分析的方法分析了一维随机粗糙表面的散射特征，得出了一维随机粗糙表面散射分布曲线，我们还考虑了遮蔽效应的影响，并且讨论了Kirchhoff近似的有效性。     

SPME-GC-MS快速分析炼油厂废水中痕量VOCs

采用固相微萃取-气相色谱-质谱联用(SPME-GC-MS)对炼油厂废水中痕量挥发性有机化合物(VOCs)进行了定性分析,简化了预处理过程,总分析时间为1h左右.对比处理前后的废水样品的MS定性结果,为废水处理工艺的评价以及有机物降解机理提供了依据.     

Control of LHCD on the HL-2A Tokamak

in order to study non-indutive plasma current production, the lower hybrid current drive（LHCD） experiment on the HL-2A tokamak is carried out. Simultaneously a microcomputer has been used to control the whole LHCD system. During the experiment this year, we can monitor and protect the LHCD system by use of the microcomputer control system, which will imediately switch off the microwave power to be launched into the tokamak if the plasma is disrupted. All this ensure that the microwave is injected into the equipment correctly.     

A New Cycloartane from Sphaerophysa salsula

A novel cycloartane,named sphaerophysone A,9,19-cycloart-7β,24β,25-triol-1-en-3-one,was isolated from the ethanol extract of Sphaerophysa salsula DC.The structure was elucidated on the basis of spectral evidences and confirmed by X-ray analysis,the stereochemistry of the compound was also defined by X-ray analysis.