Nuclear orientation and NMRON studies of tetrahydrate manganese salts

Two tetrahydrate manganese salts, MnBr₂·4H₂O and Mn(COOCH₃)₂·4H₂O have been studied by nuclear orientation. Two⁵⁴Mn NMRON lines were observed in the bromide at 499.75(4) MHz and 501.6 (1) MHz allowing hyperfine parameters to be estimated. The spin-flop transition was also observed in this salt. Although considerable -ray anisotropy was observed in the acetate no resonances have yet been observed.     

High-spin structure of yrast-band in 78Kr

Lifetime of levels up to 22⁺, have been measured in ⁷⁸Kr and an oblate shape is assigned to the ground state using the CSM and the configuration dependent shell correction calculations. Calculations further show that ⁷⁸Kr is highly γ-soft nucleus. The experimental Q _t values coupled with theoretical calculations indicate an oblate shape for ⁷⁸Kr at low spins and triaxial shape at higher spins     

Magnetic structure determined by nuclear orientation

Conclusion In conclusion we suggest that nuclear orientation is a useful technique for determining nuclear spin structures. For a known hyperfine interaction atomic magnetic structures may also be deduced. Measurements on antiferromagnets and the rare earth magnet holmium demonstrate the method, although in the latter case the turn angle cannot be determined because of the limitation of L2 radiation. These experiments show that nuclear orientation can at least complement neutron diffraction and at best furnish information about magnetic structure when the latter technique is not applicable. We intend to study other rare earth magnets and more complicated antiferromagnetic structures.     

Routine analysis by high precision gas chromatography/mass selective detector/isotope ratio mass spectrometry to 0.1 parts per mil

Stable isotope methods are potentially quite useful for validating natural or enhanced mineral degradation of contaminants. For this reason, a continuous flow gas chromatograph (GC), isotope ratio mass spectrometer (IRMS) has been coupled with a quadrupole mass selective detector (MSD) to allow simultaneous mass spectral and stable carbon isotope ratio data to be obtained from a single chromatographic analysis. This allows the target contaminant and any extra-cellular degradation intermediates to be both qualified and quantified. Previously acceptable limits of precision (0.3 parts per mil) are undesirable given the small fractionation observed during aerobic degradation. To further understand the fate of organic contaminants and to gain information about the metabolic degradative pathway employed by a microorganism, routine isotopic analyses on a range of analytes have been performed. Quantities of sample producing mass-44 ion beam signal (I(44)) of 2 x 10(-10) to 1 x 10(-8) A were analysed. When the IRMS was tuned for high sensitivity, ion source nonlinearities were overcome by peak height correction from an algorithm that was produced using known isotopic standards of varying concentrations. This led to sample accuracy of <0.01 per thousand and sample precision of 0.1 per thousand. Copyright 1999 John Wiley & Sons, Ltd.     

Investigation of the quantitative properties of the quadrupole orthogonal acceleration time-of-flight mass spectrometer with electrospray ionisation using 3,4-methylenedioxymethamphetamine

This paper describes the investigation of the potential of a quadrupole orthogonal acceleration time-of-flight mass spectrometer (Q-TOF) equipped with an atmospheric pressure ionisation interface for quantitative measurements of small molecules separated by reversed phase liquid chromatography. To this end, the detection limits and linear dynamic range in particular were studied in an LC/MS/MS experiment using 3,4-methylenedioxymethamphetamine standards and 3,4-methylenedioxyethylamphetamine for internal standardisation. In a second phase, the experiment was repeated with real biological extracts (whole blood, serum, and vitreous humour). A calibration for 3,4-methylenedioxymethamphetamine and its metabolite 3,4-methylenedioxyamphetamine was prepared in each of these matrices again using 3,4-methylenedioxyethylamphetamine as internal standard. The resulting quantitative data were compared with those obtained by liquid chromatography with fluorescence detection for the same extracts. The Q-TOF results revealed excellent sensitivity and a linear dynamic range of nearly four decades (2-10 000 pg on-column, r(2) = 0.9998, 1/x weighting). Furthermore, all the calibration curves prepared in biological material were superimposable, LC/MS/MS and LC-fluorescence, and the quantitative results for actual samples compared very favourably. It was concluded that the Q-TOF achieves a linear dynamic range for quantitative LC/MS/MS work exceeding that of fluorescence detection and at much better absolute sensitivity. Copyright 1999 John Wiley & Sons, Ltd.     

Microstructures and structural properties of sol-gel silica foams

Silica xerogels were synthesized and annealed at 1000 degrees C for different durations to yield stable silica materials. The samples were prepared through base-catalyzed hydrolysis and condensation of tetramethyl orthosilicate in methanol. After aging and drying steps, clear and solid xerogels exhibiting a narrow pore size distribution were achieved. The annealing treatment of these xerogels was performed at 1000 degrees C and proved in the present study to lead to a monolithic glass when a progressive heat-treatment procedure was employed to attain 1000 degrees C. In addition to the expected glass, silica foams and ordered phases were observed when the samples were instantaneously heat-treated at 1000 degrees C. Raman spectra of the foamed materials exhibit the classical features of amorphous silica, whereas transmission electronic microscopy pictures reveal the presence of crystallized domains within the vitreous matrix. These crystallites are prone to nucleation and growth processes, which jeopardize the believed stability of the silica foam. The assessment of the hydroxyl content by IR spectroscopy reveals the role played by the latter polycondensation of silanols. The occurrence of foaming process was thus found to result from two competitive phenomena occurring at 1000 degrees C: evacuation of water-related species and viscous sintering.     

Infrared spectra of DCl in liquid alkanes

Preliminary results are reported on the effect of solute-solvent interactions on the form of the DCl fundamental infrared absorption band. It is found that the band shape varies as a function of alkane chain length and isomerism. The results are interpreted in terms of the correlation function for DCl reorientation.