Incremental evolution of induced anisotropy

The aim of this article is to define a model that describes the evolution of the yield surface during plasticity. We propose a modelisation that is completely different from the classical approach as far as conception is concerned. It consists of describing the yield surface evolution with the help of velocity. The yield function is not directly known but is obtained by integrating a differential law starting from an initial surface. A very simple evolution law is used; the complexity of the induced anisotropy is obtained by incremental accumulation.     

Algorithms for ham-sandwich cuts

Given disjoint setsP ₁,P ₂, ...,P _d inR ^d withn points in total, ahamsandwich cut is a hyperplane that simultaneously bisects theP _i . We present algorithms for finding ham-sandwich cuts in every dimensiond>1. Whend=2, the algorithm is optimal, having complexityO(n). For dimensiond>2, the bound on the running time is proportional to the worst-case time needed for constructing a level in an arrangement ofn hyperplanes in dimensiond−1. This, in turn, is related to the number ofk-sets inR ^d−1 . With the current estimates, we get complexity close toO(n ^3/2 ) ford=3, roughlyO(n ^8/3 ) ford=4, andO(n ^d−1−a(d) ) for somea(d)>0 (going to zero asd increases) for largerd. We also give a linear-time algorithm for ham-sandwich cuts inR ³ when the three sets are suitably separated. A preliminary version of the results of this paper appeared in [16] and [17]. Part of this research by J. Matoušek was done while he was visiting the School of Mathematics, Georgia Institute of Technology, Atlanta, and part of his work on this paper was supported by a Humboldt Research Fellowship. W. Steiger expresses gratitude to the NSF DIMACS Center at Rutgers, and his research was supported in part by NSF Grants CCR-8902522 and CCR-9111491.     

Novel optical techniques for the analysis of polymer surfaces and thin films

Summary We report on novel optical techniques, based on evanescent waves, for the characterization of polymer surfaces and thin films. We first describe photo-ablation studies with polysilane films investigated by surface plasmon microscopy, a technique which is particularly well-suited for ultrathin samples. Thicker films that are homogeneous enough to carry optical waveguide modes can be characterized with high lateral resolution by the recently developed waveguide microscopy. We demonstrate this for a thin film of a solid polyelectrolyte. Finally, we report on surface plasmon field-enhanced Raman-spectroscopic and -imaging investigations of ultrathin Langmuir-Blodgett-Kuhn-layers of cadmium arachidate.W. Hickel is now with HOECHST AG, Angewandte Physik, W-6230 Frankfurt 80     

μSR in oxygen deficient YBa2Cu3O x (6.5⩽x⩽7.0)

A systematic μSR study of the local magnetic field distribution in a series of oxygen deficient YBa₂Cu₃O _x samples with 6.5⩽x⩽7.0 is reported. Special attention was given to perform the experiments under the same conditions, so that the oxygen content of the measured samples was the only parameter varied. The behavior of the depolarization rate σ as a function of the oxygen contentx was found to have strong similarities with the behavior of the critical temperatureT _c as a function ofx. In particular, two step-like increases of σ were observed abovex=6.7 and 6.9. The temperature dependence of the normalized depolarization rate σ(T)/σ(0) is well described by the two-fluid model forx⩾6.781(1) and clearly deviates from this behavior forx⩽6.704(1). Our results are compared to those obtained by other groups.     

The Cern (g-2) measurements

Measurements of the anomalous magnetic moment of the muon are reviewed. The emphasis is put on the first one of a series of three CERN experiments which led to an experimental value ofa=1165922.9 (8.5)·10⁻⁹ (±7.2ppm), and which compares well with the present theoretical resulta=1165919.2 (1.8)·10⁻⁹ (±1.5ppm).     

A RAPID APPROXIMATION FOR PREDICTING THE HYDROCARBON DISCOVERY RATE: PART 1. ASSESSING THE ACCURACY

The hydrocarbon discovery prediction problem is important to firms having to make decisions about the deployment of scarce exploration resources. Traditional methods for estimating the discovery rate rely on the completion of time consuming simulation experiments. A rapid approximation that does not require the completion of simulation exists and has been shown to have some promise as a prediction tool. This paper investigates the accuracy of the approximation method under a wide variety of distributional and drilling efficiency assumptions. The results indicate that the approximation produces predictions close to those of simulation under most of the tested conditions. This suggests that resource exploration firms could conveniently use the method for a wide variety of planning purposes without incurring the same costs in time and personnel required for simulation.