Method development for the determination of iron in milligram amounts of rice plants (Oryza sativa L.) from cultivation experiments using graphite furnace atomic absorption spectrometry

The amount of sample that is available for analysis in laboratory plant cultivation experiments is usually very limited. Highly sensitive analytical techniques are therefore required, even for elements that are present in the plants at mg g^–1 concentrations, and graphite furnace atomic absorption spectrometry (GFAAS) was chosen in this work because of its micro-sampling capability, and its relatively simple operation. Four micro-methods were investigated for the determination of iron in roots and leaves of rice plants: i) a micro-digestion with nitric and hydrochloric acids, ii) a slurry procedure using tetramethylammonium hydroxide (TMAH) tissue solubilizer, iii) a slurry prepared in 1.4 mol L^–1 nitric acid, and treated in an ultrasonic bath, and iv) the direct analysis of solid samples. The micro-digestion was suffering from high blank values and contamination problems, so that it could not be recommended for routine purposes. The TMAH method exhibited poor precision and occasional low recoveries, particularly for real samples. Direct solid sampling analysis gave results similar to those obtained with the slurry technique with ultrasonic agitation for the determination of iron in certified reference materials with iron content up to about 100 g g^–1, but was too sensitive for the investigated rice plants, which had an iron content up to several mg g^–1. The slurry technique with ultrasonic treatment of the samples, suspended in dilute nitric acid, was finally adopted as the method of choice.The method was then applied for the determination of iron in the leaves and in different compartments of the roots of two rice cultivars, one sensitive to iron toxicity, an important nutritional disorder, and the other one resistant to iron toxicity. The results suggest that the higher resistance to iron toxicity of the second cultivar is due to a smaller uptake of iron from the soil, resulting in lower iron levels in all compartments of the plant.     

Fractal calibration in size-exclusion chromatography I. An introduction

The elution behaviour of different polymer-solvent systems in three types of organic columns for SEC has been compared and interpreted. The experimental data show that the classical universal calibration is not accomplished. Deviations from a unique curve are observed due to the binary and ternary interactions between the components of the system (solvent, polymer and gel) which results on secondary mechanisms accompanying the main pure or "ideal" SEC separation mechanism. Both, enthalpic and entropic effects are interpreted in terms of the swelling and crosslinking degrees of the gel packings, and are also related with the fractal characteristics of their surfaces, such as the fractal dimension and the available pore size. Moreover, a relationship between the fractal dimension of the pore surface and the chromatographic distribution coefficient is proposed.     

Formation of bridging alkene and conjugated dialkenes exclusively generated from alkynes on the [3,3'-Co(1,2-C2B9H11)2]- platform. The unique hydroboration role of [3,3'-Co(1,2-C2B9H11)2]-

The unprecedented metal-mediated transformation of an alkyne into a B,B' bridging alkene is reported. Also, the unprecedented synthesis of a conjugated dialkene derivative of [3,3'-Co(1,2-C2B9H11)2]- generated only from an alkyne, contrary to the usual case where an alkyne and an alkene are needed, is described. This has been possible through the singular capacity of a B-H to produce hydroboration.     

Molecular structure-activity relationships for the oxidation of organic compounds using mesoporous silica catalysts derivatised with bis(halogeno)dioxomolybdenum(VI) complexes

Mo K-edge XAFS spectra have been measured for ordered mesoporous silica MCM-41 grafted with the complexes [MoO2X2(thf)2] (X=Cl, Br). For grafting reactions in the absence of triethylamine, materials with 1 wt. % Mo are obtained; the Mo K-edge EXAFS results indicate the co-existence of isolated surface-fixed monomeric species [MoO2[(-O)3SiO]2(thf)(n)] and [MoO2[(-O)3SiO]X(thf)(n)]. When Et3N is used in the grafting reactions, materials with 4 wt. % Mo are obtained. The EXAFS data for the material prepared using [MoO2Cl2(thf)2] and Et3N indicate the presence of dinuclear species with two Mo(VI) centres, each with two Mo=O groups and each linked by one or two oxo bridges (Mo...Mo 3.27 A). The molybdenum centres in the material prepared using the dibromo complex comprise mainly isolated four-coordinate dioxomolybdenum(VI) and trioxomolybdenum(VI) monomeric species, with a small contribution from dimeric species. All materials were further characterised in the solid state by powder X-ray diffraction, N2 adsorption analysis, MAS NMR (13C, 29Si) and FTIR spectroscopy. The derivatised MCMs perform differently as catalysts in the liquid-phase oxidation of various olefins and alcohols with tert-butyl hydroperoxide. The highest alkene epoxidation activity was recorded for the catalysts with low metal loading, whereas the material containing oxo-bridged dimers had the highest activity for oxidation of alcohols. The recyclability of all the catalysts was tested: the catalytic activity of the derivatised materials tended to stabilize with ageing.     

Evidence of a Photo‐Radical Pathway Responsible of the Rearrangement of a Manganese(III)‐Schiff Base Complex in Solution

A new Mn^III‐Schiff base complex, [MnL(OH₂)](ClO₄) ( 1 ) (H₂L = N, N′‐bis‐(3‐Br‐5‐Cl‐salicylidene)‐1, 2‐diimino‐2‐methylethane), an inorganic model of the catalytic center (OEC, Oxygen Evolving Complex) in photosystem II (PSII), has been synthesized and characterized by elemental analysis, IR and EPR spectroscopy, mass spectrometry, magnetic susceptibility measurement and the study of its redox properties by cyclic and normal pulse voltammetry. This complex mimics reactivity (showing a relevant photolytic activity), and also some structural characteristics (parallel‐mode Mn^III EPR signal from partially assembled OEC cluster) of the natural OEC. The complex 1 was found to rearrange in solution into a crystallographically solved square‐pyramidal complex, [MnLL′] ( 2 ) (HL′ = 6‐bromo‐4‐chloro‐2‐cyanophenol), through a process, which probably liberates radical species (detected by EPR), and provokes a C—N bond cleavage in the ligand. A photo‐radical mechanism is discussed to explain this rearrangement.     

A dinuclear manganese(II) complex with the [Mn(2)(mu-O(2)CCH(3))(3)](+) core: synthesis, structure, characterization, electroinduced transformation, and catalase-like activity

Reactions of Mn(II)(PF(6))(2) and Mn(II)(O(2)CCH(3))(2).4H(2)O with the tridentate facially capping ligand N,N-bis(2-pyridylmethyl)ethylamine (bpea) in ethanol solutions afforded the mononuclear [Mn(II)(bpea)](PF(6))(2) (1) and the new binuclear [Mn(2)(II,II)(mu-O(2)CCH(3))(3)(bpea)(2)](PF(6)) (2) manganese(II) compounds, respectively. Both 1 and 2 were characterized by X-ray crystallographic studies. Complex 1 crystallizes in the monoclinic system, space group P2(1)/n, with a = 11.9288(7) A, b = 22.5424(13) A, c =13.0773(7) A, alpha = 90 degrees, beta = 100.5780(10 degrees ), gamma = 90 degrees, and Z = 4. Crystals of complex 2 are orthorhombic, space group C222(1), with a = 12.5686(16) A, b = 14.4059(16) A, c = 22.515(3) A, alpha = 90 degrees, beta = 90 degrees, gamma = 90 degrees, and Z = 4. The three acetates bridge the two Mn(II) centers in a mu(1,3) syn-syn mode, with a Mn-Mn separation of 3.915 A. A detailed study of the electrochemical behavior of 1 and 2 in CH(3)CN medium has been made. Successive controlled potential oxidations at 0.6 and 0.9 V vs Ag/Ag(+) for a 10 mM solution of 2 allowed the selective and nearly quantitative formation of [Mn(III)(2)(mu-O)(mu-O(2)CCH(3))(2)(bpea)(2)](2+) (3) and [Mn(IV)(2)(mu-O)(2)(mu-O(2)CCH(3))(bpea)(2)](3+) (4), respectively. These results have shown that each substitution of an acetate group by an oxo group is induced by a two-electron oxidation of the corresponding dimanganese complexes. Similar transformations have been obtained if 2 is formed in situ either by direct mixing of Mn(2+) cations, bpea ligand, and CH(3)COO(-) anions with a 1:1:3 stoichiometry or by mixing of 1 and CH(3)COO(-) with a 1:1.5 stoichiometry. Associated electrochemical back-transformations were investigated. 2, 3, and the dimanganese [Mn(III)Mn(IV)(mu-O)(2)(mu-O(2)CCH(3))(bpea)(2)](2+) analogue (5) were also studied for their ability to disproportionate hydrogen peroxide. 2 is far more active compared to 3 and 5. The EPR monitoring of the catalase-like activity has shown that the same species are present in the reaction mixture albeit in slightly different proportions. 2 operates probably along a mechanism different from that of 3 and 5, and the formation of 3 competes with the disproportionation reaction catalyzed by 2. Indeed a solution of 2 exhibits the same activity as 3 for the disproportionation reaction of a second batch of H(2)O(2) indicating that 3 is formed in the course of the reaction.     

Comparison of Several Calibration Procedures for Glass Electrodes in Proton Concentration

Several reported procedures for calibrating glass electrodes in proton concentration are compared. Some recommendations for non-experts are also given. The examined procedures can be classified into two broad categories, namely: those based on direct potential difference measurements of solutions of known proton concentration and those that use one or several pH standards to calibrate the electrode and subsequently measure the pH of solutions containing known proton concentrations. With a single buffer, the two types of procedures lead to equivalent results. However, if two pH buffers are used, the slope of the calibration graph in proton concentration will differ from the real electrode slope to an extent proportional to the difference between the liquid junction potentials of the two buffers. Therefore, any other method is preferable under these circumstances.     

Polyelectrolyte-surfactant complexes with long range order

Mixtures of carboxymethyl cellulose (CMC) or hydrophobically modified CMC with an oppositely charged surfactant (benzyldimethyltetradecylammonium chloride) in water were prepared. When the global polymer concentration is 0.18% by weight and the surfactant content is high enough, a precipitate with hexagonal order is formed. The precipitate composition shows practically constancy in its water content and a slight diminution in polymer concentration when the global surfactant content is varied between 0.9 and 23 wt%. The lattice parameter in this phase decreases when the polymer/surfactant ratio in the phase increases; this variation is faster with CMC than with the hydrophobically modified CMC. In this way electrostatic and hydrophobic interactions are far from being additive. From the extrapolation to infinite dilution, the global interaction seems to depend on the substitution degree in the polymer. Additionally, the comparison between the radius at the polar-apolar interface in the cylinders and the lattice parameter as a function of polymer/surfactant ratio in the hexagonal phase is compatible with some of the alkyl chains belonging to the hydrophobically modified CMC being present in the aqueous zone.     

Study of negative thermal expansion and shift in phase transition temperature in Ti4+- and Sn4+-substituted ZrW2O8 materials

The negative-thermal-expansion material ZrW(2)O(8) is known to undergo an order-disorder phase transition which affects its expansion behavior. In this study, Ti(4+) and Sn(4+) are examined as possible substituting ions for the Zr(4+) position in ZrW(2)O(8). This substitution leads to a decrease in cell parameters, as the ionic radii of the substituents are smaller than the Zr(4+) ionic radius. A remarkable decrease in transition temperature is noticed. DSC is used to quantify the enthalpy and entropy changes during the phase transition in order to reveal the mechanisms behind this decrease. It is shown that the strength of the M-O bond plays an important role, as it is a partner in the rigid unit mode motion and the order-disorder transition mechanism.     

pH-Dependent Hydration Change in a Gd-Based MRI Contrast Agent with a Phosphonated Ligand

The heptadentate ligand L was shown to form an extremely stable Gd complex at neutral pH with a pGd value of 18.4 at pH 7.4. The X-ray crystal structures of the complexes formed with Gd and Tb displayed two very different coordination behaviors being, respectively, octa- and nonacoordinated. The relaxometric properties of the Gd complex were studied by field-dependent relaxivity measurements at various temperatures and by ¹⁷O NMR spectroscopy. The pH-dependence of the longitudinal relaxivity profile indicated large changes around neutral pH leading to a very large value of 10.1 mm ⁻¹⋅s⁻¹ (60 MHz, 298 K) at pH 4.7. The changes were attributed to an increase of the hydration number from one water molecule in basic conditions to two at acidic pH. A similar trend was observed for the luminescence of the Eu complex, confirming the change in hydration state. DOSY experiments were performed on the Lu analogue, pointing to the absence of dimers in solution in the considered pH range. A breathing mode of the complex was postulated, which was further supported by ¹H and ³¹P NMR spectroscopy of the Yb complex at varying pH and was finally modeled by DFT calculations.