Towards molecular-imprint based SPE of local anaesthetics

Summary Solidago canadensis L., Canadian goldenrod (Asteraceae) has been used in European phytotheraphy for centuries as a component of urological and antiphlogistical remedies. High-performance liquid chromatography (HPLC) coupled with diode-array detection (DAD) and online mass spectrometry (MS) has been used for the separation and quantification of phenolics (chlorogenic acid, caffeic acid, kaempferol-3-O-α-L-rutinoside (nicotiflorin), quercetin-3-O-β-D-rutinoside (rutin), quercetin-3-O-β-D-galactoside (hyperoside), quercetin-3-O-β-D-glucoside (isoquercitrin), quercetin-3-O-β-D-rhamnoside (quercitrin), kaempferol-3-O-α-L-rhamnoside (afzelin) and quercetin from Solidaginis herba. Extracts have been obtained using different technologies. Three aqueous and three alcoholic extracts were studied separately. Reversedphase high-performance liquid chromatography separation of polyphenols on octadecyl sorbent Hypersil was performed, using acetonitrile: acetic acid 2.5 v/v % as eluent in gradient elution. Our results confirm previous reports concerning the presence of several flavonoids. Quantification of the main quercetin glycosides in pharmaceuticals is also reported. Presented at Balaton Symposium '01 on High-Performance Separation Methods, Siófok, Hungary, September 2–4, 2001     

Deviation from Ohm's law in electric field assisted capillary liquid chromatography

Earlier studies of electric field assisted LC (EF-LC) have shown that the effect on charged analytes of the application of an electric field over a capillary LC column is relatively small. Charged analytes can only be affected by the electric field while present in the mobile phase, which makes the effective time for influence of the electric field t(0) independent of retention time. Because the charged analytes only can be affected for a short time the electric field strength ought to be high in order to increase the impact of the electric field on the separation. We have, however, found that only a relatively low electric field strength can be used in EF-LC when pressure is used as main driving force. The useful field strength was limited by a dramatic increase in the current. This increase in current was found to origin from an increased concentration of buffer ions that have an electrophoretic mobility towards the pumped flow.     

Biosynthesis of anthecotuloide,an irregular sesquiterpene lactone from Anthemis cotula L. (Asteraceae) via a non-farnesyl diphosphate route

Retrobiosynthetic analysis of the allergenic sesquiterpene lactone, anthecotuloide, suggested that this natural product could be formed either by head to head condensation of geranyl diphosphate with dimethylallyl diphosphate, or from farnesyl diphosphate (FPP), the accepted regular sesquiterpene precursor via the rearrangement of a germacranolide precursor. Isotopic labelling of anthecotuloide has now been achieved by feeding [1-(13)C]-glucose, [U-13C6]-glucose and [6,6-(2)H2]-glucose to aseptically grown plantlets of Anthemis cotula(family Asteraceae). Analysis of labelling patterns and absolute 13C abundances using quantitative 13C NMR spectroscopy showed that the isoprene building blocks of this sesquiterpene are formed exclusively via the MEP terpene biosynthetic pathway. This was supported by results from an experiment using [U-13C6]-glucose. A deuterium labelling experiment using [6,6-(2)H2]-glucose supported the original proposal and showed that anthecotuloide is formed from a non FPP precursor. Isotope ratio mass spectrometry suggested that there were two pathways for sesquiterpene biosynthesis in A. cotula.     

Methods for research on immune complement activation on modified sensor surfaces

We have developed a methodological system consisting of a new surface sensitive quartz crystal microbalance with dissipation monitoring (QCM-D) sensor surfaces together with different surface modification methods for the investigation of surface associated complement activation in human sera. The QCM-D surface, 10 mm in diameter, was modified by spin-coating of poly(urethane urea) (PUUR) and polystyrene (PS). Some sensor surfaces were also sputtered with titanium (Ti) or modified by hydrophobic self-assembled monolayer (SAM) of an 18-carbon alkane thiol with a ---CH₃ end group. The amount of surface deposited complement protein was investigated by incubation of the modified sensor surfaces in human sera, followed by incubation with antibodies directed against complement factor 3c (C3c). The amounts of bound anti-C3c were then used as an arbitrary measure of surface induced complement activation. The order of complement activation of the different surfaces, as judged by three separate measurements per surface modification, was PUUR>PS=SAM>Ti. The Ti surface had a similar low degree of anti-C3c binding as the negative controls (heat inactivated sera). The novel QCM-D methodology was found to be very simple, accurate, sensitive and well suited as a screening method for complement activation and protein adsorption on different materials. We also compared the sensitivity of QCM-D method with surface plasmon resonance (SPR) for the quantification of protein adsorption and complement activation on gold sensor surfaces. The QCM-D method was equally sensitive as the SPR for the detection of protein adsorption from a solution independently if low flow rate (5 μl/min) was used. A slight increase in sensitivity was found at higher flow rate (30 μl/min). However, we found it difficult to use the SPR method on the Ti, PS and PUUR surfaces due to decreased light penetration of the modified SPR sensor chip.     

Complete 1H and 13C NMR assignments of aurasperone A and fonsecinone A, two bis-naphthopyrones produced by Aspergillus aculeatus

Complete assignments of 1H and 13C NMR chemical shifts of the polyketides aurasperone A and fonsecinone A were made by means of nuclear Overhauser enhancement and heteronuclear NMR correlation experiments. These compounds were isolated for the first time from Aspergillus aculeatus, an endophytic fungus obtained from leaves of Melia azedarach(Meliaceae).     

Dissociative recombination cross section and branching ratios of protonated dimethyl disulfide and N-methylacetamide

Dimethyl disulfide (DMDS) and N-methylacetamide are two first choice model systems that represent the disulfide bridge bonding and the peptide bonding in proteins. These molecules are therefore suitable for investigation of the mechanisms involved when proteins fragment under electron capture dissociation (ECD). The dissociative recombination cross sections for both protonated DMDS and protonated N-methylacetamide were determined at electron energies ranging from 0.001 to 0.3 eV. Also, the branching ratios at 0 eV center-of-mass collision energy were determined. The present results give support for the indirect mechanism of ECD, where free hydrogen atoms produced in the initial fragmentation step induce further decomposition. We suggest that both indirect and direct dissociations play a role in ECD.     

Dry deposition of elemental iodine on skin,hair, and clothing from air

Hairless rats, clothes, human hair, filter paper and water were exposed to gaseous elemental iodine in a glass chamber for 60–120 minutes. The deposition of gaseous elemental iodine on skin and lung of rats, human hair, water, clothes and paper were investigated by measuring iodine content in the exposed material by epithermal neutron activation analysis (ENAA). For measurement of the iodine concentration in the chamber air, elemental iodine in the air was collected by continuously sucking air through an active charcoal column. The trapped iodine in the active charcoal was then determined by ENAA. The measured deposition velocity in the test chamber of gaseous elemental iodine on skin, clothing, hair and water ranges from 0.006 on filter paper and water to about 0.05 cm/s on skin and clothes. The variation of elemental iodine concentration in air of the glass chamber was investigated by collecting and analyzing air samples at various time intervals. The results show that the variation with time in the concentration of the iodine can be described by an exponential function.