Fluoride-facilitated deuterium exchange from DMSO-d6 to polyamide-based cryptands

Multiple deuterium exchange between DMSO-d6 and amide hydrogens in two hexaamido cryptand fluoride receptors has been verified by 19F and 2H NMR and FAB mass spectral studies. Structural results for one of the complexes indicate a tricapped trigonal prism hydrogen bond coordination geometry around an encapsulated fluoride, with hydrogen bonds from fluoride to six amide and three phenyl hydrogens.     

Synthesis and Structures of Titanosiloxane Cage Compounds

Reaction of (triphenylmethyl)silanetriol (1) with cyclopentadienyltitanium trichloride (CpTiCl₃) in the presence of triethylamine as a HCl scavenger gave both compounds of a partial open-cage type {[Ph₃CSiO(OH)]₃(Ph₃CSiO_3/2)(CpTiO_3/2)₄} (2) and cube type (Ph₃CSiO_3/2CpTiO_3/2)₄ (3). The 1:1 reaction of 1 and CpTiCl₃ in toluene solvent at reflux temperature for 3 d afforded compounds 2 (22%) and 3 (36%). When 1 is reacted with a 1.5 fold excess of CpTiCl₃ under the same conditions, compound 3 was obtained in high yield (81%) along with 2 in trace quantities. Compounds 2 and 3 were fully characterized by the analyses of ¹H, ¹³C, ²⁹Si NMR, IR, and FAB MS data. The solid-state structure of 3 was determined by a single crystal X-ray diffraction study. Compound 3 had shown to have catalytic activity for the oxidation of alkenes such as 1-octene, cyclooctene, and norbornene with t-butyl hydrogen peroxide. The effect of solvent was observed in this epoxidation reaction. The order of reactivity were decreased as follows: CHCl₃ > hexane THF.     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

Swelling kinetics and release characteristic of crosslinked chitosan: Polyether polymer network (semi-IPN) hydrogels

The aqueous swelling kinetics of a series of crosslinked chitosan (cr-CS) with glutaraldehyde (GA) interpenetrating polyether hydrogels have been studied as functions of pH, the N-deacetylation degree of chitosan, the amount of crosslinking agent, the electrolyte composition in solution, temperature, and gel composition. Based on these results, the swelling mechanism of the hydrogels was discussed. The release profiles of chlorhexidini acetas from the semi-IPN were also investigated. © 1994 John Wiley & Sons, Inc.     

Stereochemistry of cytidine: conformational analysis and hydrogen bonding

The energy calculations using the INDO molecular orbital method and classical potential function show that the syn conformation of pyrimidine nucleosides having the C_(2')-endo or C_(2')-endo-C_(3')-endo sugar ring puckering is as stable as the corresponding anti form.The O_(2')-O_(2') base-ribose hydrogen bonding significantly alters the Φ_CN conformation by confining the allowed Φ_CN ranges to about 150–210°.     

Surface composition and property of film prepared with aqueous dispersion of polyurethaneurea-acrylate including fluorinated block copolymer

The aqueous dispersion of polyurethaneurea-acrylate (PUA) including small amount of fluorinated block copolymers containing carboxyl groups (PATF), which can be dissolved in water, was used to make films and the surface properties of these films were examined. The experimental data show that the modified PUA film exhibits a hydrophobic surface property, although the original surface of PUA film is hydrophilic. The surface composition of the modified PUA film was measured by ATR and XPS. The results indicate that there is a concentration gradient of the fluorine groups along the lines of thickness of the modified film and towards the outmost surface layer, resulting from the migration of fluorinated blocks to the air side surface of the modified PUA film during the film formation process. However, the PUA film can not be modified effectively by adding the sodium salt of PATF, since the urethane groups in the system are easy to occupy on the surface of the film.     

Copper corrosion in buffered and non-buffered synthetic seawater: a comparative study

The electrochemical behaviour of copper in neutral buffered and non-buffered synthetic seawater and in pure chloride solutions has been studied by cyclic voltammetry, weight loss measurements, open circuit potential and scanning electron microscopy (SEM). Values of the repassivation potentials of Cu in non-buffered and buffered synthetic seawater, at 50 mV s^–1, were 0.12 and 0.46 V vs. SCE, respectively. The sharpness, heights and location of the different peaks as well as their charges were shown to be influenced by the composition of the solution, buffering conditions, deoxygenation, polarization potential and time. High chloride concentrations lead to higher oxidation charges. The anodic and the cathodic charges were shown to increase as the chloride concentration increases. The open circuit potential transients of copper in non-deoxygenated, non-buffered synthetic seawater indicate pitting from the beginning of the exposure, while in buffered solutions the pitting appeared only after a quite long exposure period, i.e. after 40 days. Corrosion rates of Cu samples after 3 months of immersion were higher in solutions of pure chloride (0.5 M) than in synthetic seawater. After six months the differences were even more noticeable. SEM images have showed a somewhat higher density of pits on copper samples immersed in the chloride solution (0.5 M), in comparison with those in synthetic seawater.     

Studies on the Complexes of N,N′-Bis[o-(diphenylphosphino)benzylidene]ethylenediamine with Transition Metal Ions

The thermodynamic parameters for the interaction of Cu²⁺, Ni²⁺, Co²⁺, Cd²⁺, andAg⁺ with the new title ligand have been determined by titration calorimetry in 50% THF–methanol (V/V) at 25 °C.Ag⁺ exhibited remarkably higher complexation selectivity.Ag⁺ and several transition metal ions have been transportedusing this ligand as carrier in a bulk liquid membrane. CompetitiveAg⁺–M²⁺ transport studies have also beencarried out for the same system. In this membrane transport study, high transport of Ag⁺ was observed in both single and competitiveAg⁺–M²⁺ transport studies. The complexformation of N,N-bis[o-(diphenylphosphino)benzylidene]ethylenediamine (P₂N₂) with silver,[Ag(P₂N₂)] (NO₃), (1) is reported. Complex 1 has been characterized by X-ray crystallography. 1 ismonoclinic, space group P2_1/n (No. 14), with cell dimensionsa = 13.398(4) , b=12.577(5) , c = 21.521(4) , =100.14(2) , V = 3570(2) ³ and Z = 4.     

Synthesis and reactivity of 1,2-bis(chlorodimethylgermyl)carborane and 1,2-bis(bromodimethylstannyl)carborane

The 1,2-bis(chlorogermyl)- (1) and 1,2-bis(bromostannyl)carborane (2) have been prepared by the reaction of dilithio-o-carborane with Me(2)GeCl(2) and Me(2)SnBr(2), respectively. Compounds 1 and 2 are found to be good precursors for the synthesis of a variety of cyclization compounds. The Wurtz-type coupling reaction of 1 and 2 using sodium metal afforded the four-membered digerma compound 3 and five-membered tristanna compound 4, respectively. The salt elimination reactions of 1 and 2 using Li(2)N(t)Bu and Li(2)PC(6)H(5) afforded the cyclic products [structure: see text]. The 1,2-bis(dimethylgermyl)carborane 9 and 1,2-bis(dimethylstannyl)carborane 10 were prepared by the reaction of 1 and 2 with sodium cyanoborohydride. The reactions of 9 and 10 with Pd(PPh(3))(4) afforded the bis(germyl)palladium 12 and bis(stannyl)palladium 13 complexes, respectively.     

Mixed-metal tellurites: synthesis, structure, and characterization of Na1.4Nb3Te4.9O18 and NaNb3Te4O16

Two new mixed-metal tellurites, Na1.4Nb3Te4.9O18 and NaNb3Te4O16, have been synthesized by standard solid-state techniques using Na2CO3, Nb2O5, and TeO2 as reagents. The structures of Na1.4Nb3Te4.9O18 and NaNb3Te4O16 were determined by single-crystal X-ray diffraction. Both of the materials exhibit three-dimensional structures composed of NbO6 octahedra, TeO4, and TeO3 polyhedra. The Nb5+ and Te4+ cations are in asymmetric coordination environments attributable to second-order Jahn-Teller (SOJT) effects. The Nb5+ cations undergo an intraoctahedral distortion toward a corner (local C4 direction), whereas the Te4+ cations are in distorted environments owing to their nonbonded electron pair. Infrared and Raman spectroscopy, UV-vis diffuse reflectance spectroscopy, thermogravimetric analysis, and dielectric measurements were also performed on the reported materials. Crystal data: Na1.4Nb3Te4.9O18, monoclinic, space group C2/m (No. 12), with a = 32.377(5) A, b = 7.4541(11) A, c = 6.5649(9) A, beta = 95.636(5) degrees, V = 1576.7(4) A3, and Z = 4; NaNb3Te4O16, monoclinic, space group P2(1)/m (No. 11), with a = 6.6126(13) A, b = 7.4738(15) A, c = 14.034(3) A, beta = 102.98(3) degrees, V = 675.9(3) A3, and Z = 2.