Photodynamic Efficiency of Protoporphyrin IX: Comparison of Endogenous Protoporphyrin IX Induced by 5-Aminolevulinic Acid and Exogenous Porphyrin IX

Abstract— Photodynamic efficiency of protoporphyrin IX (PP) accumulated in HeLa cells by the incubation of PP with HeLa cells was compared with that of accumulated PP formed from 5-aminolevulinic acid (ALA) as a precursor. The ALA-induced PP was photodynamically more efficient than exogenous PP. The difference is caused by monomelic PP concentration and PP localization site in HeLa cells. Exogenous PP was accumulated mainly in plasma membrane, and the membrane was strongly damaged by irradiation. The ALA-induced PP was selectively accumulated in mitochondria and inactivated the mitochondrial function by irradiation.     

Investigation of the crystal structure and the structural and magnetic properties of SrCu2(PO4)2

SrCu2(PO4)2 was prepared by the solid-state method at 1153 K. Its structure was solved by direct methods in the space group Pccn (No. 56) with Z = 8 from synchrotron X-ray powder diffraction data measured at room temperature. Structure parameters were then refined by the Rietveld method to obtain the lattice parameters, a = 7.94217(8) A, b = 15.36918(14) A, and c = 10.37036(10) A. SrCu2(PO4)2 presents a new structure type and is built up from Sr2O16 and Cu1Cu2O8 units with Cu1...Cu2 = 3.256 A. The magnetic properties of SrCu2(PO4)2 were investigated by magnetic susceptibility, magnetization up to 65 T, Cu nuclear quadrupole resonance (NQR), electron-spin resonance, and specific heat measurements. With spin-dimer analysis, it was shown that the two strongest spin-exchange interactions between Cu sites result from the Cu1-O...O-Cu2 and Cu2-O...O-Cu2 super-superexchange paths with Cu1...Cu2 = 5.861 A and Cu2...Cu2 = 5.251 A, and the superexchange associated with the structural dimer Cu1Cu2O8 is negligible. The magnetic susceptibility data were analyzed in terms of a linear four-spin cluster model, Cu1-Cu2-Cu2-Cu1 with -2J(1)/kB = 82.4 K for Cu1-Cu2 and -2J(2)/k(B) = 59 K for Cu2-Cu2. A spin gap deduced from this model (Delta/kB = 63 K) is in agreement with that obtained from the Cu NQR data (Delta/kB = 65 K). A one-half magnetization plateau was observed between approximately 50 and 63 T at 1.3 K. Specific heat data show that SrCu2(PO4)2 does not undergo a long-range magnetic ordering down to 0.45 K. SrCu2(PO4)2 melts incongruently at 1189 K. We also report its vibrational properties studied with Raman spectroscopy.     

Palladium-catalyzed preparation of α-allyl esters and α,β-unsaturated esters from saturated esters via their silyl acetals

Reaction of ketene silyl acetals with allylic carbonates in the presence of palladium-phosphine catalyst in dioxane gives α-allyl esters in high yields. When the reaction is carried out with phosphine-free palladium catalyst in nitriles, α,β-unsaturated esters are obtained in good yields.     

Comparison of CO2 Reduction Performance with NH3 and H2O between Cu/TiO2 and Pd/TiO2

The aim of this study is to clarify the effect of doped metal type on CO₂ reduction characteristics of TiO₂ with NH₃ and H₂O. Cu and Pd have been selected as dopants for TiO₂. In addition, the impact of molar ratio of CO₂ to reductants NH₃ and H₂O has been investigated. A TiO₂ photocatalyst was prepared by a sol-gel and dip-coating process, and then doped with Cu or Pd fine particles by using the pulse arc plasma gun method. The prepared Cu/TiO₂ film and Pd/TiO₂ film were characterized by SEM, EPMA, TEM, STEM, EDX, EDS and EELS. This study also has investigated the performance of CO₂ reduction under the illumination condition of Xe lamp with or without ultraviolet (UV) light. As a result, it is revealed that the CO₂ reduction performance with Cu/TiO₂ under the illumination condition of Xe lamp with UV light is the highest when the molar ratio of CO₂/NH₃/H₂O = 1:1:1 while that without UV light is the highest when the molar ratio of CO₂/NH₃/H₂O = 1:0.5:0.5. It is revealed that the CO₂ reduction performance of Pd/TiO₂ is the highest for the molar ratio of CO₂/NH₃/H₂O = 1:1:1 no matter the used Xe lamp was with or without UV light. The molar quantity of CO per unit weight of photocatalyst for Cu/TiO₂ produced under the illumination condition of Xe lamp with UV light was 10.2 μmol/g, while that for Pd/TiO₂ was 5.5 μmol/g. Meanwhile, the molar quantity of CO per unit weight of photocatalyst for Cu/TiO₂ produced under the illumination condition of Xe lamp without UV light was 2.5 μmol/g, while that for Pd/TiO₂ was 3.5 μmol/g. This study has concluded that Cu/TiO₂ is superior to Pd/TiO₂ from the viewpoint of the molar quantity of CO per unit weight of photocatalyst as well as the quantum efficiency.     

Combinatorial synthesis of MUC1 glycopeptides: polymer blotting facilitates chemical and enzymatic synthesis of highly complicated mucin glycopeptides

The chemoselective polymer blotting method allows for rapid and efficient synthesis of glycopeptides based on a "catch and release" strategy between solid-phase and water-soluble polymer supports. We have developed a heterobifunctional linker sensitive to glutamic acid specific protease (BLase). The general procedure consists of five steps, namely (i) the solid-phase synthesis of glycopeptide containing BLase sensitive linker, (ii) subsequent deprotections and the release of the glycopeptide from the resin, (iii) chemoselective blotting of the glycopeptide intermediates in the presence of water-soluble polymers with oxylamino functional groups, (iv) sugar elongations using glycosyltransferases, and (v) the release of target glycopeptides from the polymer platform by selective BLase promoted hydrolysis. The combined use of the solid-phase chemical syntheses of peptides and the enzymatic syntheses of carbohydrates on water-soluble polymers would greatly contribute to the production of complicated glycopeptide libraries, thereby enhancing applicative research. We report here a high-throughput synthetic system for the various types of MUC1 glycopeptides exhibiting a variety of sugar moieties. It is our belief that this concept will become part of the entrenched repertoire for the synthesis of biologically important glycopeptides on the basis of glycosyltransferase reactions in automated and combinatorial syntheses.     

Structural assignment of isomeric 2-aminopyridine-derivatized oligosaccharides using negative-ion MSn spectral matching

To investigate the possibility of structural assignment based on negative-ion MS2 spectral matching, three isomeric pairs of 2-aminopyridine (PA)-derivatized non-fucosylated, fucosylated, and sialylated oligosaccharides (complex type N-glycans) were analyzed using high-performance liquid chromatography/ion trap mass spectrometry (HPLC/ITMS) with a sonic-spray ionization (SSI) source. In the SSI negative-ion mode the deprotonated molecule [M-2H]2- becomes prominent. Negative-ion MS2 spectra derived from such ions contain many fragment types (B and Y, C and Z, A, and D) and therefore are more informative than the positive-ion MS2 spectra derived from [M+H+Na]2+ ions, which usually consist mainly of B and Y fragment ions. In particular the internal ions (D- and E-type ions) provided useful information about the alpha1-6 branching patterns and the bisecting GlcNAc residue. Spectral matching based on the correlation coefficients between negative-ion MS2 spectra was performed in a manner similar to the positive-ion MS2 spectral matching previously reported. It was demonstrated that negative-ion MS2 spectral matching is as useful and applicable to the structural assignment of relatively large non-fucosylated, fucosylated, and sialylated PA-oligosaccharide isomers as its positive-ion counterpart.     

Aggregation-induced emission and thermally activated delayed fluorescence of 2,6-diaminobenzophenones

Exploration of novel organic luminophores that exhibit thermally activated delayed fluorescence (TADF) in the aggregated state is very crucial for advance of delayed luminescence-based applications such as time-gated bio-sensing and temperature sensing. We report herein that synthesis, photophysical properties, molecular and crystal structures, and theoretical calculations of 2,6-bis (diarylamino)benzophenones. Absorption spectra in solution and calculations using density functional theory (DFT) method revealed that the optical excitation took place through intramolecular charge-transfer from one diarylamino moiety to an aroyl group. While the benzophenones did not luminesce in solution, the solids of the benzophenones emitted green light with moderate-to-good quantum yields. Thus, the benzophenones exhibit aggregation-induced emission. Based on the lifetime measurement, the green emission of the solids was found to include TADF. The emergence of the TADF is supported by the small energy gap between the excited singlet and triplet states, which was estimated by time-dependent DFT calculations. Thin films of poly(methyl methacrylate) doped by the benzophenones also showed green prompt and delayed fluorescence whose lifetimes were in the order of microseconds. Linear correlation between logarithm value of TADF lifetime and temperature was observed with the benzophenone in powder, suggesting that the benzophenones can serve as molecular thermometers workable under aqueous conditions.     

Modeling of incorporation of oxygen and carbon impurities into multicrystalline silicon ingot during one-directional growth

We propose a simple numerical model for incorporation of oxygen and carbon impurities into multicrystalline Si during one-directional crystal growth in comparison with experimental results. The model includes parameters that are oxygen and carbon concentrations in the melt in the beginning of the growth, carbon flux form the atmosphere, oxygen fluxes from the crucible and to the atmosphere. Variation of oxygen and carbon concentrations in multicrystalline Si ingots with a diameter of 30 cm and a height of 7.5 cm solidified one-directionally was measured by infra red absorption spectroscopy at room temperature. By fitting the numerical results on the experimental results, the parameters were evaluated. In the modeling we found fruitful suggestions for suppressing and controlling the oxygen and carbon concentrations in multicrystalline Si for solar cells.     

Further evidence for the intramolecular charge-transfer interaction between tropylium ion and remote benzene rings in 9,10-dihydro-9,10-(1,2-tropylio)anthracene tetrafluoroborate and its methyl derivatives

A series of 9,10-dihydro-9,10-(1,2-tropylio)anthracene tetrafluoroborates

has been prepared. The intramolecular charge-transfer interactions in

were confirmed by their UV spectra and pK_R+ values. As a model compound 1,2,3,4-tetrahydro-1,4-(1,2-tropylio)naphthalene tetrafluoroborate ($\text{5}$)_was also examined.