Antioxidative properties of <Emphasis Type="Italic">Sambucus nigra</Emphasis> extracts

Potential protective effects of elderberry (Sambucus nigra) extracts against oxidative degradation of hyaluronan (HA) were detected in vitro. To induce free-radical-mediated HA degradation, Weissberger’s biogenic oxidative system, which mimics the situation of acute inflammation, was applied. Time- and dose-dependent changes of dynamic viscosity of the HA solutions in the presence and absence of two elderberry extracts produced in 2006 and 2012 were recorded by rotational viscometry (RV). Radical scavenging capacity of both extracts was investigated by the spectrocolorimetric ABTS [2,2′-azinobis(3-ethylbenzothiazoline-6-sulfonic acid) diammonium salt] assay and the “inverted” ABTS assay. Oxygen consumption of the system oxidizing HA either in the absence or presence of the elderberry extracts was determined. The results of RV revealed that an addition of the newer extract (2012) promoted the inhibition of HA degradation more markedly compared to the older extract (2006). The same effect of both extracts on ABTS^·+ scavenging was observed. Inverted ABTS assay demonstrated that colorful substances were not responsible for the radical-scavenging activity. Results of oximetry demonstrated that the effect of the extract from 2006 was more significant than that of the extract from 2012.     

Preparation of Lewis acid ionic liquids for one-pot synthesis of benzofuranol from pyrocatechol and 3-chloro-2-methylpropene

Several Lewis acid ionic liquids (LAILs) with different acidic scales were synthesised and used as catalysts for the synthesis of benzofuranol by condensation of pyrocatechol and 3-chloro-2-methylpropene in one pot. The catalytic activity of these ionic liquids was correlated with their Lewis acidity. Low to moderate conversion with excellent selectivity to benzofuranol was obtained in the presence of the appropriate LAILs. Compared to the two-step synthetic method currently used in industry, a higher yield plateau (81.1%) of benzofuranol was achieved in the presence of [BMIm][AlCl₄] IL as catalyst at 418 K after 4 h. Furthermore, the catalyst is readily separated from the resultant products via decantation and could be reused after treatment in vacuum.     

Robust model-based predictive control of exothermic chemical reactor

A case study of the robust model-based predictive control (MPC) of an exothermic continuous stirred tank reactor (CSTR) with uncertain parameters is presented. Three robust MPC approaches are considered and the simulation results are compared in terms of quality of control performance and total consumption of coolant. The results reveal the main benefits of the considered approaches and confirm that the robust MPC can bring about a reduction in consumption of the coolant.     

Effect of alkylated diphenylamine on thermal-oxidative degradation behavior of poly-<Emphasis Type="Italic">α</Emphasis>-olefin

An oil-soluble antioxidant, alkylated diphenylamine (ADPA), was prepared by alkylation of diphenylamine. The influence of ADPA on the thermal-oxidative stability of poly-α-olefin (PAO8) was evaluated by thermogravimetry (TG). For comparison, the thermal-oxidative stability of PAO8 with zinc dialkyl dithiophosphate (ZDDP) was also investigated. Activation energy (E_a)of the corresponding thermal-oxidative degradation process was evaluated by the Flynn-Wall-Ozawa (FWO) and Kissinger-Akahira-Sunose (KAS) methods. To demonstrate the reliability of the kinetic study, the antioxidant performance of ADPA and ZDDP in PAO8 was also studied by the pressure drop (PDT) and accelerated oxidation (AOT) tests. The results indicate that ADPA has better antioxidant ability than ZDDP in increasing the E_a value and enhancing the oxidative stability of PAO8. Good correlation between the applied test methods was established.     

Density of lithium fluoride—lithium carbonate-based molten salts

The density of the LiF-Li₂CO₃ melts system was measured using the Archimedean method. Using the quadratic regression orthogonal design with two factors, a regression equation for the density of LiF-Li₂CO₃ melts was obtained in which the concentration of LiF and temperature were considered. The results indicated that the density of the LiF-Li₂CO₃ melts decreased with either increasing the concentration of LiF or increasing temperature; a linear relation was observed between density and temperature. In addition, the influences of NaF, KF, NaCl, and KCl additives on the densities of the given systems were studied. The addition of NaF and KF increased the density of the melts, whereas NaCl and KCl resulted in an initial increase and subsequent decrease with an increasing additive concentration. The density attained a maximum at NaCl and KCl mass fraction of approximately 15%.     

Efficient method for the synthesis of polysubstituted 2,6-dicyanoanilines by one-pot three-component tandem reaction of malononitrile with <Emphasis Type="Italic">α</Emphasis>,<Emphasis Type="Italic">β</Emphasis>-unsaturated imines

A facile and efficient one-pot synthesis of polysubstituted benzenes was achieved via the Michael addition of malononitrile with α,β-unsaturated imines and a sequential tandem reaction. This reaction generates polysubstituted 2,6-dicyanoanilines in high yields (15 examples, isolated yields of 57–91 %), and proceeds under mild reaction conditions (60°C, 10 min). In addition, a possible mechanism accounting for the reaction is proposed.     

Synthesis and characterization of nano Ag end capped L-cysteine bridged diblock copolymer

The target of the present investigation is synthesis and characterization of an amphiphilic diblock copolymer with antibacterial property. Ring opening polymerization (ROP) of ε-caprolactone (CL) and tetrahydrofuran (THF) was carried out under inert atmosphere by using L-cysteine as a bridging agent in the presence of stannous octoate (SO) as a catalyst. The nano silver end capped diblock copolymer was synthesized by in situ method. Thus obtained nano silver end capped L-cysteine bridged diblock copolymer was characterized by various analytical methods like Fourier transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) spectroscopy, circular dichroism (CD), fluorescence spectroscopy, gel permeation chromatography (GPC), X-ray photoelectron spectroscopy (XPS), thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), field emission scanning electron microscopy (FESEM), high resolution transmission electron microscopy (HRTEM) and zeta potential. The antimicrobial property of the nano silver end capped diblock copolymer against e-coli was tested.     

Surface Treatment of Polyimide Substrates Using Dielectric Barrier Discharge Reactors Based on L-Shaped Electrodes

Plasma Chemistry and Plasma Processing - Two dielectric barrier discharge reactors, based on L-shaped electrodes, were designed and fabricated for in-line surface treatment of polyimide (PI)...     

The significance of a second adsorption phase with weakly adsorbed species for the calculation of the surface concentrations of a mixture: methanol–DME and methanol–ethene adsorption in SAPO-34

With the calorimetric (adsorption heat versus coverage) curve also measured together with the adsorption isotherm, the simultaneous use of both curves showed that there were two phases of adsorption in the adsorption of methanol, dimethyl ether, ethene and propane in SAPO-34. The dual-site Langmuir equation gave good fits to the adsorption data to support the interpretation that a second (type 2) adsorption phase occurred in the high-pressure region in addition to a first (type 1) adsorption phase on the acid sites at lower pressures. Adsorption experiments and calculations using binary gas mixtures showed that due to the existence of two types of adsorption, the multicomponent Langmuir isotherm equation (Langmuir competitive adsorption model) calculated incorrect surface concentrations when the concentrations were high. In contrast, the ideal adsorbed solution theory (IAST) calculated correct surface concentrations in the adsorption of mixtures.