Lifetime of living polymers in cationic polymerization. II. Living polymerization of isobutyl vinyl ether initiated by the hydrogen iodide/zinc halide systems

In the living cationic polymerization of isobutyl vinyl ether (IBVE) initiated by the hydrogen iodide/zinc halide (HI/ZnX₂; X = I, Br, Cl) systems, the concentration ([P^*]) of the living propagating species was determined by quenching with sodiomalonic ester ( 1 ). The quenching reaction was shown to be clean, instantaneous, and quantitative to give poly (IBVE) with a terminal malonate group from which [P^*] was obtained by ¹H-NMR spectroscopy. In the polymerizations in toluene below +25°C, [P^*] was constant and equal to the initial concentration ([HI]₀) of hydrogen iodide, independent of the type and concentrations of ZnX₂ as well as monomer conversion. At 0 and +25°C, however, the living species started decaying immediately after the complete consumption of monomer. In contrast, such a decay process was absent at ?15°C even in the absence of monomer until about an hour (depending on the conditions) after the end of polymerization. The deactivation reaction was first order in [P^*], and the lifetime (half-life) of the living species was longer at lower temperature and at lower ZnX₂ concentration. On the basis of these [P^*] and lifetime measurements, the HI/ZnX₂ systems were also compared with the HI/I₂ counterpart.     

Micellar liquid chromatography: suitable technique for screening analysis

The screening capability of micellar liquid chromatography (MLC) is discussed using the reported chromatographic data of several sets of compounds (amino acids, beta-blockers, diuretics, phenethylamines, phenols, polynuclear aromatic hydrocarbons, steroids and sulfonamides) and new results (sulfonamides and steroids). The chromatographic data are treated with an interpretive optimisation resolution procedure to obtain the best separation conditions. Usually, the pH and the concentration of surfactant (sodium dodecyl sulfate, SDS, or cetyltrimethylammonium bromide) for the optimal mobile phase were 2.5-3 and < 0.12 M, respectively. The nature and concentration of organic solvent depended on the polarity of the eluted compounds: a low volume fraction of propanol (approximately 1%, v/v) was useful to separate the amino acids, with log P(o/w) < -1 (where P(o/w) is the octanol-water partition coefficient). A greater concentration of this solvent (approximately 5-7%) was needed for compounds in the range -1 < log P(o/w) < 2, as with the studied diuretics and sulfonamides, and a high concentration of propanol (approximately 15%) or a low concentration of butanol (< 10%) had to be used for less polar compounds with 1 < log P(o/w) < 3, such as the beta-blockers. Pentanol (< 6%) was more suitable for the even less polar compounds with log P(o/w) > 3, such as the steroids. For basic drugs such as the phenethylamines (0 < log P(o/w) < 1.7), eluted with a micellar eluent of anionic SDS, propanol was too weak. A study is also shown for mixtures of sulfonamides (log P(o/w) = -1.2 to 1.7) and steroids (log P(o/w) = 3.0-8.1) eluted from conventional C18 columns with SDS mobile phases containing acetonitrile and 1-pentanol, respectively, which are compared with classical acetonitrile-water and methanol-water mixtures. The results complement a previous study on beta-blockers (log P(o/w) = -0.03 to 2.8) and reveal that MLC is a very competitive technique for the screening of compounds against conventional RPLC, due to its peculiar behaviour with regard to the selectivity and elution strength. The concentration of organic solvent needed to obtain sufficiently low retention times (even for highly hydrophobic steroids with log P(o/w) = 7-8) is also appreciably smaller for MLC, which reduces the environmental impact of the mobile phases.     

Dye-sensitized solar cells based on composite solid polymer electrolytes

The ionic conductivity of polymer electrolytes and their interfacial contact with dye-attached TiO2 particles were enhanced markedly by the addition of amorphous oligomer into polymer electrolytes, resulting in very high overall energy conversion efficiency.     

Syntheses of 1beta-methylcarbapenems bearing 5-methyl-4-hydroxypyrrolidinone

A new series of 1beta-methylcarbapenems 1a-d bearing 5-methyl-4-mercaptopyrrolidinone rings has been prepared and evaluated for in vitro antibacterial activity and pharmacokinetic parameters. Most compounds showed excellent antibacterial activity and high stability to dehydropeptidase-1. We have synthesized optically active 5-methyl-4-hydroxypyrrolidinones from enantiomerically pure aziridine esters.     

Technological quality determination of pharmaceutical disintegrant by DSC cooling and DSC photovisual

A number of disintegrants are available on the market. They improve tablets’ disintegration. The objective of this work is the comparison of the technological quality parameters of disintegrants using different analytical techniques. Three batches of disintegrants and their binary mixtures (water:disintegrants) were investigated. Cooling experiments were used from –30 up to 200°C. The data obtained showed calorimetric differences between the samples. In the binary mixtures water showed different crystallization behaviour from the one found in the literature. According to the results DSC technique helped the quality control of different disintegrants.     

Characterization and quantitation of mixtures of alkyl ether sulfates and carboxylic acids by capillary electrophoresis with indirect photometric detection

The separation, characterization, and determination of mixtures of alkyl ether sulfates (AES) and fatty acids (C10-C16) in background electrolytes (BGEs) containing acetonitrile (ACN)-water mixtures is addressed. Due to inhibition of the ionization of the carboxylate groups, the migration time and the resolution between the fatty acids decreased when the water content of the BGE was reduced, but efficiency and resolution between the AES oligomers improved. The migration times increased and resolution improved by substituting 5% ACN by an equivalent amount of dioxane. A complete separation of the two surfactant classes, up to the AES oligomers with 8 ethylene oxide units (EOs) with respect to C10, with excellent resolution between the AES oligomers, while preserving a satisfactory resolution between the fatty acids, was achieved with a BGE containing 5 mM trimethoxybenzoic acid, 7 mM dipentylamine, 85% ACN, 5% dioxane, and 10% water. The two surfactant classes were increasingly resolved by further reducing the water content of the BGE. Thus, C2 (acetate) was resolved from the AES oligomers up to 7 EOs using 90% ACN and 5% dioxane, but the resolution between the heavier fatty acids was poor with this BGE. Identification of the AES oligomers was eased by the excellent regularity of the successive migration times; thus, within each AES subclass or series of oligomers with the same number of carbon atoms in the alkyl chain, the migration times decreased following a mild curve as the number of EOs increased. The way how the data obtained by indirect photometry (corrected peak areas that are proportional to the molar concentrations) should be managed to avoid systematic error when the calibration curve is constructed using an AES standard with an oligomer distribution different from that of the samples is discussed and equations are given. Decyl sulfate was successfully used as internal standard. The detection limits (S/N = 3) were of ca. 2 microM for individual AES oligomers.     

New synthesis of 3′-deoxypurine nucleosides using samarium(III) iodide complex

Regio- and stereoselective iodinative cleavage of 2′,3′-anhydropurine nucleosides was achieved with samarium diiodide and ethyl bromoacetate to produce the corresponding 3′-iodopurine nucleosides, which were then converted to 3′-deoxypurine nucleosides including the natural product cordycepin.     

Lithium isotope separation by chemical exchange with polymer-bound azacrown compounds

The chromatographic separation of lithium isotopes was investigated by chemical exchange with the recently synthesized polymer-bound dibenzo pyridino diamide azacrown (DBPDA) and reduced dibenzo pyridino diamide azacrown (RDBPDA). Column chromatography was employed for the determination of the effect of solvents and ligand conformation on the separation coefficients. The maximum separation coefficients, , for the DBPDA and RDBPDA at 20.0±0.02°C with acetonitrile as eluent, were found to be 0.034±0.002 and 0.035±0.002, respectively. The isotope separation coefficient and adsorption capability of the lithium ion on the DBPDA and RDBPDA were only slightly dependent on ligand structure, but strongly dependent on the solvent. DBPDA and RDBPDA appeared to have almost the same value for the isotope separation coefficient of lithium.     

Kinetics and Mechanism of Ni(II) Chelation in Model and Real Solutions of Xylem Sap of Quercus ilex

The kinetics of formation and dissociation of Ni(II) complexes with oxalic and citric acids was studied by cyclic voltammetry in model solutions of xylem sap of Q. ilex (the dominant tree growing on serpentine soils of Northeast Portugal) using representative concentrations, pH and ionic strength. The role of magnesium on complex formation was analyzed from solutions where Mg is present at concentration levels found in the xylem sap of Q. ilex growing on both nonserpentine and serpentine soils. Kinetics studies were also done in diluted solutions of real xylem sap samples, spiked with increasing amounts of magnesium. The values obtained for the apparent rate constants were those anticipated by the proposed model. To test the validity of the methodology and mechanisms, formation rate constants, k_f (M^?1 s^?1) of Ni(II) complexes with citrate and oxalate were evaluated that compare with the values from Eigen mechanism.     

Hydrogen peroxide oxidation of di(hydroxo)platinum(II) species in carboxylic acids

A facile procedure for synthesizing the mono(hydroxo)tris(carboxylato)platinum(IV) species has been achieved. The reaction of [Pt^II(OH)₂(dmpda)] (dmpda=2,2-dimethyl-1,3-propanediamine) with a 30% aqueous solution of H₂O₂ in the presence of a carboxylic acid produces a stable [Pt^IV(OOCR)₃(OH)(dmpda)] (R=Me, Et) complex in high yield. The crystal structures of [Pt^IV(OOCMe)₃(OH)(dmpda)] . H₂O (triclinic P1 bar, a=8.761(2) Å, b=9.245(3) Å, c=10.659(2) Å, =106.25(2)°, =93.90(2)°, =98.92(2)°, V=813.1(3) ų, Z=2, R= 0.0474) and [Pt^IV(OOCEt)₃(OH)(dmpda)] (monoclinic P2₁/c, a=12.777(4) Å, b=10.514(2) Å, c=14.971(3) Å, =107.40(2)°, V=1919.2(8) ų, Z=4, R=0.0611) show that the hydroxyl group has been selectively positioned at an axial site. The intramolecular hydrogen bond between the OH and C=O moiety exists (O(H)...=C, 2.83 Å for [Pt^IV(OOCMe)₃(OH)(dmpda)] · H₂O; 2.72 Å for [Pt^IV(OOCEt)₃(OH)(dmpda)]. Formation of the axial-mono(hydroxo)tris(carboxylato)platinum(IV) species may be ascribed to a combination of `reactive-equatorial effects' with `cis-addition' in the carboxylic acid.