煤粉再燃对600 MW锅炉NOx排放的影响

在国内某台燃用褐煤的600 MW机组锅炉上进行了煤粉再燃技术示范并进行了工业试验.机组在600 MW负荷下运行时,NOx排放可控制在274 mg/m3(烟气中氧量折算到6%,下同)的水平,比改造前下降了65.36%,同时燃烧效率没有降低.进行了常规通风、空气分级和煤粉再燃三个工况下的试验,结果表明,煤粉再燃对NOx的控制效果最好,其次为空气分级.再燃煤粉比例对NOx排放也有明显的影响,在试验条件下,随着再燃燃料比例的增加,NOx排放呈降低趋势.     

近红外光谱分析技术

介绍了近红外光谱分析技术的工作原理,阐述了其数学模型的建立及分析过程,总结了现有常用的化学计量学方法及各自的优点,最后简单的概括了近红外光谱分析技术的应用,尤其是在制药方面的应用.     

掺杂对CH样品Rayleigh-Taylor不稳定性增长的影响

在神光II激光装置上进行了辐射驱动不同掺杂样品的单模Rayleigh-Taylor(RT)不稳定性实验.结果显示:与纯碳氢(CH)样品相比,掺Br的CH样品的扰动更早、更快地进入非线性区,产生二次谐波,并且掺Br比例越高,CH样品扰动进入非线性区的时间越早,相同时刻扰动的二次谐波的幅度越高.这是因为密度梯度效应抑制了二次谐波的产生,掺Br比例越高,密度梯度标长越小;同时密度梯度效应还抑制三次谐波对基模增长的负反馈,造成基模具有更大的线性增长,导致线性饱和幅值大于经典值0.1λ.     

TDDFT study on the excited‐state hydrogen bonding of N‐(2‐hydroxyethyl)‐1,8‐naphthalimide and N‐(3‐hydroxyethyl)‐1,8‐naphthalimide in methanol solution

The time‐dependent density functional theory method was performed to investigate the excited‐state hydrogen‐bonding dynamics of N‐(2‐hydroxyethyl)‐1,8‐naphthalimide (2a) and N‐(3‐hydroxyethyl)‐1,8‐naphthalimide (3a) in methanol (meoh) solution. The ground and excited‐state geometry optimizations, electronic excitation energies, and corresponding oscillation strengths of the low‐lying electronically excited states for the complexes 2a + 2meoh and 3a + 2meoh as well as their monomers 2a and 3a were calculated by density functional theory and time‐dependent density functional theory methods, respectively. We demonstrated that the three intermolecular hydrogen bonds of 2a + 2meoh and 3a + 2meoh are strengthened after excitation to the S₁ state, and thus induce electronic spectral redshift. Moreover, the electronic excitation energies of the hydrogen‐bonded complexes in S₁ state are correspondingly decreased compared with those of their corresponding monomer 2a and 3a. In addition, the intramolecular charge transfer of the S₁ state for complexes 2a + 2meoh and 3a + 2meoh were theoretically investigated by analysis of molecular orbital. Copyright © 2014 John Wiley & Sons, Ltd.     

换个角度看近地人造卫星的运动

将卫星的近地轨道运动等效为无阻力条件下物体沿地球内两相互垂直的直径轨道的简谐振动的合运动,从而解释了它们的运动周期相同这一事实.     

确定磁性体在绝热磁化过程中达到最高温度的方法

在磁性体磁化过程中, 决定其能够达到的最高温度, 对磁热材料的优化选取是重要的. 本文以钆镓石榴石(Gd₃Ga₅O₁₂) 为例, 根据高磁场下趋近饱和定律的思想, 给出了低温、超强磁场下, Gd₃Ga₅O₁₂晶体等效磁化率的定量形式. 在外磁场从0---40 T范围内, 计算了该晶体的磁熵变、声子熵变以及磁性体温度随外磁场的变化, 结果均与实验值符合较好. 利用声子熵变与饱和磁熵变曲线交点的唯一性, 给出了在磁性体磁化过程中, 确定其温度达到最大值的方法, 预言了Gd₃Ga₅O₁₂晶体在绝热磁化过程中达到的最高温度为64.7K. 该方法还可以对所加外磁场大小进行预言或估计.     

A facile method for the synthesis of large‐size Ag nanoparticles as efficient SERS substrates

Silver nanoparticles (Ag NPs) enjoy a reputation as an ultrasensitive substrate for surface‐enhanced Raman spectroscopy (SERS). However, large‐scale synthesis of Ag NPs in a controlled manner is a challenging task for a long period of time. Here, we reported a simple seed‐mediated method to synthesize Ag NPs with controllable sizes from 50 to 300 nm, which were characterized by scanning electron microscopy (SEM) and UV–Vis spectroscopy. SERS spectra of Rhodamine 6G (R6G) from the as‐prepared Ag NPs substrates indicate that the enhancement capability of Ag NPs varies with different excitation wavelengths. The Ag NPs with average sizes of ~150, ~175, and ~225 nm show the highest SERS activities for 532, 633, and 785‐nm excitation, respectively. Significantly, 150‐nm Ag NPs exhibit an enhancement factor exceeding 10⁸ for pyridine (Py) molecules in electrochemical SERS (EC‐SERS) measurements. Furthermore, finite‐difference time‐domain (FDTD) calculation is employed to explain the size‐dependent SERS activity. Finally, the potential of the as‐prepared SERS substrates is demonstrated with the detection of malachite green. Copyright © 2016 John Wiley & Sons, Ltd.     

一种可用于酚类化合物检测的酶传感器

利用溶胶-凝胶法将辣根过氧化物酶(HRP)固定化于二氧化硅凝胶网络中构建了可用于酚类化合物检测的酶传感器。对二氧化硅载体材料进行了结构表怔。二氧化硅多孔材料的平均孔径为2.95 nm。孔径小于5 nm占总数的84.068%。由于辣根过氧化物酶的分子尺寸远远大于二氧化硅的凝胶网络的平均孔径,因此不会泄露到溶液中去,而尺寸较小的底物可以发生反应。包埋的辣根过氧化物酶在H₂O₂的存在下,能够催化氧化苯酚与4-氨基安替比林反应生成醌亚胺有色化合物。通过紫外-可见光谱测定醌亚胺有色化合物的吸光度,即可以确立苯酚的含量。对于象含氯酚类的重要污染物, 如邻氯酚、间氯酚、2,4-二氯酚,这种方法也同样适用。此外,对多次测定以后的酶的活性下降的问题进行了讨论,结果表明酶传感器可以重复使用10次以上。但响应时间会变长。     

Optimized growth and dielectric properties of barium titanate thin films on polycrystalline Ni foils

Barium titanate(BTO) thin films were deposited on polycrystalline Ni foils by using the polymer assisted deposition(PAD) technique.The growth conditions including ambient and annealing temperatures were carefully optimized based on thermal dynamic analysis to control the oxidation processing and interdiffusion.Crystal structures,surface morphologies,and dielectric performance were examined and compared for BTO thin films annealed under different temperatures.Correlations between the fabrication conditions,microstructures,and dielectric properties were discussed.BTO thin films fabricated under the optimized conditions show good crystalline structure and promising dielectric properties with εr～ 400 and tan δ < 0.025 at 100 kHz.The data demonstrate that BTO films grown on polycrystalline Ni substrates by PAD are promising in device applications.     

Ab initio investigation into the structural, electronic and elastic properties of AlCu2TM (TM = Ti, Zr and Hf) ternary compounds

The Al-Cu-TM (TM = transition metal) alloy system has attracted great attention for both excellent glass-forming ability and its interesting physical properties. In this work, an investigation into the crystal, electrical and elastic properties of the AlCu₂TM (TM = Ti, Zr, and Hf) compounds has been conducted by first-principles calculations based on density-functional theory. The fully relaxed structure parameters of the AlCu₂TM compounds are in good agreement with previous experimental and other theoretical results. Besides, the cohesive energies of all the AlCu₂TM compounds have been evaluated. The energy band and densities of state of these compounds are also obtained. According to the calculated single crystal elastic constants, all the compounds are mechanically stable. The polycrystalline bulk moduli, shear moduli, Young’s moduli and Poisson’s ratio have been deduced by using Voigt-Reuss-Hill (VRH) approximations. The calculated negative Cauchy pressure and ratio of bulk modulus to shear modulus indicated that the AlCu₂TM compounds are ductile materials. The Debye temperatures of the AlCu₂TM compounds decrease with increasing the TM (Ti, Zr, and Hf) atomic number.