超子中子星性质的温度效应

从相对论平均场理论出发,考虑核子、超子和介子的相互作用,研究了温度对中子星组成粒子、状态方程和中子星质量等的影响.发现温度越高,超子在中子星内部出现时的重子数密度越低.当密度较高时,中子星的核心区主要由超子组成,即中子星转变成以奇异粒子为主要成分的超子星,并且这种转变受到温度的影响,温度越高,转变密度越低.由于超子的出现,中子星核心高密度区域的状态方程,对于不同温度,差别不大,所以有限温度中子星的最大质量都在1.8M_⊙附近.这与观测结果相符.     

激光溅射Ni等离子体与气相CH3OH团簇的反应

用激光溅射 分子束技术研究了气相中Ni的等离子体与甲醇分子团簇的反应 .观察到Ni+ (CH3 OH) n、NiO+ (CH3 OH) n、H+ (CH3 OH) n、H3 O+ (CH3 OH) n 四个种类的团簇正离子和CH3 O-(CH3 OH) n(n≤ 2 5 )一种团簇负离子 .详细考察了激光烧蚀等离子体作用于脉冲分子束的不同位置时 ,对团簇产物种类和团簇尺寸大小的影响 .发现NiO+ (CH3 OH) n 是由Ni+ (CH3 OH) n 团簇内的脱甲烷反应生成的 ,而H+ (CH3 OH) n、H3 O+ (CH3 OH) n主要是激光等离子体中的电子与甲醇团簇碰撞电离产生的     

17N+197Au反应中碎片与中子的符合测量

在3?3?.4MeV/u ¹⁷N束轰击¹⁹⁷Au靶产生的反应中,利用放置于不同角度组合的17个中子探测器(4°—83°)和14个半导体望远镜(2.3°—9.0°)对反应产物碎片与中子进行了符合测量.经对所得实验角分布积分得到Z=3—6元素的同位素产额分布.在参加者-旁观者模型框架下,采用¹⁷N原子核内部的不同密度分布计算了同位素产额分布并与实验数据做比较.     

A duality relation for busy cycles inGI/G/1 queues

Using a generalization of the classical ballot theorem, Niu and Cooper [7] established a duality relation between the joint distribution of several variables associated with the busy cycle inM/G/1 (with a modified first service) and the corresponding joint distribution of several related variables in its dualGI/M/1. In this note, we generalize this duality relation toGI/G/1 queues with modified first services; this clarifies the original result, and shows that the generalized ballot theorem is superfluous for the duality relation.     

SHS等离子喷涂制备FeAl2O4-Al2O3-Fe纳米复合涂层的研究

利用SHS等离子喷涂技术,将经过机械团聚法制备的Fe2O3-Al复合粉体送入等离子焰流,沉积出厚度约为400 μm的复合涂层.利用XRD,SEM 和TEM等检测手段对涂层的成分和组织进行了分析,测定了涂层的显微硬度、断裂韧性以及耐磨性.结果表明涂层为具有纳米结构的FeAl2O4-Al2O3-Fe纳米复合组织;涂层的显微硬度为HV100g870;断裂韧性是普通Al2O3涂层的2倍;无润滑磨损的耐磨性是普通Al2O3涂层的2.5倍.     

Searching for a counterfeit coin with b-balance

We consider the classical problem of searching for a heavier coin in a set of n coins, n-1 of which have the same weight. The weighing device is b-balance which is the generalization of two-arms balance. The minimum numbers of weighings are determined exactly for worst-case sequential algorithm, average-case sequential algorithm, worst-case predetermined algorithm, average-case predetermined algorithm.We also investigate the above search model with additional constraint: each weighing is only allowed to use the coins that are still in doubt. We present a worst-case optimal sequential algorithm and an average-case optimal sequential algorithm requiring the minimum numbers of weighings.     

Titanium carbonitride films on cemented carbide cutting tool prepared by pulsed high energy density plasma

Hard films prepared by pulsed high energy density plasma (PHEDP) are characterized by high film/substrate adhesive strength, and high wear resistance. Titanium carbonitride (TiCN) films were deposited onto YG11C (ISO G20) cemented carbide cutting tool substrates by PHEDP at room temperature. XRD, XPS, SEM, AES, etc. were adopted to analyze the phases (elements) composition, microstructure and the interface of the films, respectively. The results show that, the uniform dense films are composed of grains ranging from 70 to 90 nm. According to the AES result, there is a broad transition layer between the film and the substrate, due to the ion implantation effect of the PHEDP. The transition layer is favorable for the film/substrate adhesion.     

离子束引起的在Al／Cr双层薄膜界面处的原子混合

用600keV的Kr~ 离子轰击Al/Cr双层薄膜样品进行界面原子反应及相互混合的研究。实验样品是在单晶硅上蒸镀约500nm厚的铝膜,相继再蒸上所需厚度的铬膜而制成的。轰击剂量为2.0×10~(15)-2.5×10~(16)Kr~ /cm~2。用2.0MeVa粒子对轰击前后的样品进行了卢瑟福背散射(RBS)分析,发现界面处有明显的原子混合存在;当轰击剂量≥1.0×10~(16)Kr~ /cm~2时,RBS谱出现有明显的坪台,经拟合计算和x射线衍射(XRD)测量证实确有化合物Al_(13)Cr_2存在;还分别得到了原子混合量及混合效率与轰击剂量的关系;最后对界面处的原子混合机制进行了讨论。