Crystalline titanium dichloride—an active catalyst in ethylene polymerization. II. Polymer structure,polymerization variables,and scope

Polymerization of ethylene with ball-milled titanium dichloride leads to a completely linear polymer with terminal unsaturation corresponding to approximately one carbon–carbon double bond per molecule. Polymerization rate is first-order in both monomer and catalyst concentration at 140°C. Due to a thermal deactivation of the catalyst, the polymerization rate falls sharply with temperature above 180°C. Propylene and butene-1 will copolymerization with ethylene in this system, propylene more efficiently than butene-1. Evidence for copolymerization of trans-2-butene, but not of the cis-isomer or of isobutene, in trace concentrations is presented. Propylene is homopolymerized to a product low in isotactic content. The significance of the structural and (limited) kinetic data in terms of the mechanism of polymerization are discussed.     

Gradient corrections in density functional theory calculations for surfaces: Co on Pd{110}

Ab initio total energy calculations have been performed for CO chemisorption on Pd{110}. Local density approximation (LDA) calculations yield chemisorption energies which are significantly higher than experimental values but inclusion of the generalised gradient approximation (GGA) gives better agreement. In general, sites with higher coordination of the adsorbate to surface atoms lead to a larger degree of overbinding with LDA, and give larger corrections with GGA. The reason is discussed using a first-order perturbation approximation. It is concluded that this may be a general failure of LDA for chemisorption energy calculations. This conclusion may be extended to many surface calculations, such as potential energy surfaces for diffusion.     

Instrumental neutron activation analysis of large samples: A pilot experiment

A large sample INAA (LS-INAA) was conducted based on available experimental conditions. Four different materials, e.g., a quartz-sand and three wastes from an incineration plant were analyzed on sample size of 1 kg. The neutron flux spatial distribution was determined by irradiation of flux monitors in the sample. The gamma-ray apparent counting efficiency was evaluated based on the effective-solid angle concept, using linear attenuation coefficients calculated from an iteration process. The k ₀- and the modified monostandard methods were modified for the LS-INAA. To check the LS-INAA performance, a conventional small sample INAA was carried out for the quartz sand and a waste. All detected elements in the LS-INAA are presented and the discussion is conducted to explore the sources of errors in the LS-INAA. As a pilot experiment, the information from this work will be used in constructing irradiation and counting devices for the new FRM-II neutron source in Garching, Germany.     

Direct injection of plasma to determine pseudoephedrine by high performance liquid chromatography with column switching

An HPLC method has been developed for the determination of pseudoephedrine in plasma using column switching. Preparation of the sample was simple in that only 1000 microL of water was added to 200 microL of plasma before injection. A 900 microL aliquot was injected onto the precolumn. Double distilled water was used to elute and remove proteins and polar components in the sample. The components retained on the precolumn were flushed forward onto the analytical column by the mobile phase (acetonitrile-0.2 mol/L ammonium sulphate, 10:90 v/v) with automated column switching. The limit of determination of pseudoephedrine in plasma was 12 ng/mL. The relative standard deviations of intra- and inter-assay for the determination of pseudoephedrine in plasma were 1.2-9.8% over the concentration range 1020-21.8 ng/mL. The mean recovery by on-line solid phase extraction was 94.76% (RSD = 1.1%).     

Differential determination of arsenic (III) and total arsenic with L-cysteine as prereductant using a flow injection non-dispersive atomic absorption device

Speciation of arsenic in environmental samples gains increasingly importance, as the toxic effects of arsenic are related to its oxidation state. A method was developed for the determination of trace amounts of arsenic (III) and total arsenic by flow injection hydride generation coupled with an in-house made non-dispersive AAS device. The total arsenic is determined after prereduction of arsenic (V) to arsenic (III) with L-cysteine in a low concentration of hydrochloric, acetic or nitric acid. The conditions for the prereduction, hydride generation and atomization were systematically investigated. A quartz tube temperature of 800 degrees C was found to be optimum in view of peak shape and baseline stability. Pb(II), Ni(II), Fe(III), Cu(II), Ag(I), Al(III), Ga(II), Se(IV), Bi(III) were checked for interfering with the 2 microg/L As(V) signal. A serious signal depression was only observed for Se(IV) and Bi(III) at a 150-fold excess. With the above system, arsenic was determined at a sampling frequency of about 1/min with a detection limit (3sigma) of 0.01 microg/L using a 0.5 mL sample. The reagent blank was 0.001+/-0.0003 absorbance units and the standard deviation of 10 measurements of the 2 microg/l As signal was found to be 1.2%. Results obtained for standard reference materials and water samples are in good agreement with the certified values and those obtained by ICP-MS     

Native and stearic acid modified ceria-zirconia supports in normal and reversed-phase HPLC

Porous ceria-zirconia composite with narrow particle size distribution and large specific surface area was synthesized by a sol-gel process. Chromatographic properties of the native supports was investigated in normal phase mode for the separation of test mixtures of basic, neutral and acidic compounds. The new packing material exhibited polar and basic properties, which are suitable for the separation of basic compounds. Lypophilic packing has been obtained by the modification of the ceria-zirconia with stearic acid, which exhibited strong hydrophobicity relative to the native packing. Therefore, the modified ceria-zirconia behaves as a reversed-phase packing material. Different selectivity towards basic compounds was observed on the new packing compared to the native ceria-zirconia and conventional ODS stationary phase.     

An immune algorithm for resolution of multicomponent overlapping chromatograms

A novel immune algorithm for resolution and quantitative determination of the components in overlapping chromatograms was proposed by imitating biological immune systems. The algorithm takes an overlapping chromatogram as its input and subtracts the chromatograms of standard samples from the input by iteration of a network. When the residual does not change, the network will converge and chromatographic information of the components in overlapping chromatogram will be obtained. Both simulated and experimental data sets were investigated by the method. Results showed that both resolved results and recoveries of quantitative determination are satisfactory. Comparing with conventional least-square method, the immune algorithm is fast in calculation.     

Determination of buprenorphine by high-performance liquid chromatography with fluorescence detection: application to human and rabbit pharmacokinetic studies.

A rapid, sensitive, precise and accurate high-performance liquid chromatographic assay with fluorescence detection was developed for the determination of buprenorphine in human, rabbit, pig and dog plasma. It is comprised of only a one-step extraction procedure with hexane-isoamyl alcohol at pH 9.25 and reversed-phase chromatography on a muPorasil column. The recoveries of buprenorphine and nalbuphine (internal standard) were greater than 90%. Calibration graphs were linear over the concentration range 3-300 ng/ml with a coefficient of variation, both within-day and between-day, of less than 9% at any level. The limit of detection was 1.0 ng/ml of plasma based on a signal-to-noise ratio of 3. Eight other clinically used narcotics were investigated to check for potential interferences and their analytical conditions. The possible decomposed compounds of buprenorphine were also checked for the specificity of this assay. The method has been successfully applied to the stability and pharmacokinetic studies of buprenorphine. Buprenorphine in plasma did not decompose significantly at -20 degrees C for four weeks. Pharmacokinetic application in six rabbits and a surgical patient revealed that buprenorphine followed a linear three-compartment model with two distribution phases. The two distribution and elimination half-lives and the clearance of buprenorphine were 1.32, 24.8 and 230 min and 224 ml/min in human plasma, and 0.94, 12.5 and 232 min and 30 ml/min in rabbit plasma.     

Simultaneous determination of neodymium, erbium and holmium in rare earth mixtures with 2-phenyltrifluoroacetone and octylphenol poly(ethyleneglycol) ether by third-derivative spectrophotometry

The complexes of the rare earth metals with 2-phenyltrifluoroacetone in the presence of TX-100 are reported. The characteristic absorbances of neodymium, holmium and erbium complexes can be increased by factors of 8.5, 31 and 15 respectively, compared to those of the cholrides. The third-derivative spectra have been used to eliminate the interference of cerium, and the sensitivities are increased again by factors of 7.4, 5.5 and 6.5. A method for the direct determination of neodymium, erbium and holmium in rare earth mixtures is proposed.