Single-longitudinal-mode linear-cavity fiber laser using multiple subring-cavities

A single-longitudinal-mode selection is realized in a linear-cavity fiber laser construction using a loop-back optical circulator and a partial reflectance fiber Bragg grating as the cavity ends. At 1551 nm wavelength, the measured signal-to-noise-ratio is 56 dB and with a line width less than 1 MHz obtained using multiple subring cavities as mode filters. The pumping efficiency is 10% improved by recycling the residual pump power to gain medium.     

Deposition and electrostatic removal of gaseous organic contaminants on substrate surfaces

The adhesion behavior of di-n-butyl phthalate (DBP) onto different substrates (quartz, glass, and silicon) used as wafer surfaces was studied by using an in situ UV spectrophotometric technique. The results from the closed cell experiments revealed that greatest extent of DBP adhesion occurred on the quartz chip (0.154 μg cm⁻²), followed in the order by the glass (0.054 μg cm⁻²) and silicon (0.039 μg cm⁻²). By means of the in situ spectrophotometric observation, application of an electrical field at 290 V cm⁻¹ in the cell proved to be effective in inducing charging of DBP aerosols, which were consequently attracted towards the electrodes. This method can be applied to wafer storage and transport equipments to prevent wafer contamination from material outgassing representative by DBP.     

Impact of an indium oxide/indium-tin oxide mixed structure for GaN-based light-emitting diodes

An interesting GaN-based light emitting diode (LED) using a 50 nm indium oxide (In₂O₃)/250 nm indium-tin oxide (ITO) mixed structure to replace the commonly used ITO (250 nm) current spreading layer is fabricated and studied. Use of the In₂O₃ layer could reduce the contact resistance of p-GaN in LEDs. In addition, this highly-resistive In₂O₃ layer, below the ITO layer could improve the current spreading performance. Experimentally, at room temperature, using this mixed structure, the luminous and EL intensities are enhanced by 17.7 and 17.1%, respectively.     

Synthesis of Novel N‐Pyridylcantharidinimides by Using High Pressure

The recently described pressure reaction in the presence of trithylamine with subsequent thermal (200°C) cyclization provided 13N‐pyridylcantharidinimides 4a‐4m from aminopyridines and cantharidin in yields of 15–83%. 2‐Amino‐3,5‐dichloropyridine failed to yield 4n .     

Regioselective reduction of 3-sulfonyl glutarimides to 3,4-dihydro-5-sulfonylpyridin-2-ones. Formal synthesis of the indolizidine 8a-epi-dendroprimine

Sodium borohydride regioselectively reduced various 3-sulfonyl glutarimides 1 to hydroxy piperidones 2, which were further dehydrated to 3,4-dihydro-5-sulfonylpyridin-2-ones 3 in the presence of boron trifluoride. Formal synthesis of 8a-epi-dendroprimine (4) possessing an indolizidine ring system has been accomplished via intramolecular radical cyclization of cyclic vinyl sulfone 5.     

CsMBi(3)Te(6) and CsM(2)Bi(3)Te(7) (M = Pb, Sn): new thermoelectric compounds with low-dimensional structures

The new materials CsPbBi(3)Te(6) and CsPb(2)Bi(3)Te(7) were discovered through reactions of CsBi(4)Te(6) with PbTe, whereas the isostructural materials CsSnBi(3)Te(6) and CsSn(2)Bi(3)Te(7) were discovered through corresponding reactions with SnTe. The compounds can also be prepared from stoichiometric mixtures of Cs(2)Te, Pb (Sn), Bi, and Te. The crystal structures show a layered architecture of NaCl-type slabs alternating with layers of Cs atoms. This group of compounds offers a new quaternary system, Cs-M-Bi-Te (M = Pb and Sn), available for thermoelectric investigations, including fine-tuning of compositions and doping.     

A polymerized calix[6]arene monolayer having gas permeation selectivity that exceeds Knudsen diffusion

A polymerized monolayer of 5,11,17,23,29,35-hexamercaptomethyl-37,38,40,41,42-hexakis-(1-n hexadecyloxy)calix[6]arene (1) has been synthesized on the surface of an ca. 15 mum-thick film derived from poly[1-(trimethylsilyl)-1-propyne] (PTMSP). This monolayer exhibits a permeation selectivity toward He and SF6 that exceeds Knudsen diffusion. Analogous membranes made from a calix[6]arene that contains amidoxime headgroups (i.e., 2) showed Knudsen diffusion characteristics.     

Left ventricular 4D echocardiogram motion and shape analysis

The article describes the methodology and the processes of modeling the function and the motion of left ventricle using transesophageal echocardiograph. The parameters can be used in studying the functionality of left ventricle, the status of abnormality of myocardial, and the geometric and morphological of left ventricle in shape analysis. The parameters describes the motion of left ventricle are the left ventricular (LV) floating long axis, the morphological parameters. The LV morphological parameters describe the wall motion, the LV chamber cavity variation, the effective R-ratio of endomyocardial chamber of LV, the area surface curvature, and the global surface curvature circularity. The parameters such as stroke volume, ejection fraction used in evaluation of LV functions are also extracted.     

Energy levels in As from the As(p,d) As reaction

The ⁷⁵As(p, d) ⁷⁴As reaction has been used to identify 23 excited states in ⁷⁴As. The l_n values, or mixture of l_n values, to 19 levels have been determined from DWBA fits. The spectroscopic sum rules show a neutron shell filling which is consistent with other N = 42 isotones.