基于交叉共轭结构的功能材料

近年来,人们对交叉共轭体系的制备、性能以及理论研究方面产生了极大的兴趣。本文综述了近期国内外在交叉共轭体系研究方面取得的一些最新进展,重点介绍了其在自组装、有机电致发光和离子检测等方面的最新发展动态。最后还对本课题组在交叉型p-n双嵌段寡聚物方面的研究作了详细的介绍,并对一些热点问题作了展望。     

实验室废液的回收及效果评价——以“铬废液回收及评价”为例

This paper introduces an experiment about waste liquid recovery and effect evaluation in laboratory. Through this experiment, the basic operations of crystal preparation, chemical analysis and instrumental analysis are further consolidated. At the same time, it allows students to experience a series of possible problems of condition selection and control in the process of waste liquid treatment. We hope to improve the students' ability to analyze and solve problems, enhance their interest in learning, and strengthen their humanistic education.     

Synthesis and characterization of perfluoro[1-(2-fluorosulfonyl)ethoxy]ethyl end-capped styrene oligomers

Styrene oligomers with perfluoro[1-(2-fluorosulfonyl)ethoxy]ethyl end-groups have been synthesized with moderate to high yields (52-97%) via radical oligomerization by using perfluoro[2-(2-fluorosulfonyl)ethoxy]propyonyl peroxide (PPP) at various reactant ratios of styrene over PPP (80, 160, 240, 300, 360 and 420) and different temperatures (33, 37 and 42 °C), and characterized by FTIR, ¹H NMR and ¹⁹F NMR. The molecular weight of the oligomers measured by gel permeation chromatography (GPC) is dependent on the reactant ratio and reaction temperature. The polydispersity of the oligomers varies from 1.99 to 3.30. The oligomer obtained at the reactant ratio of 300 has the maximum yield (97%) and much broader polydispersity (3.30). The contact angles of water, θ_H2O, on the oligomer films are much bigger than that of polystyrene (PS). The glass transition temperature of the oligomers, T_g, increases with the increase of molecular weight and is lower than that of the parent polymer.     

Hydrogen bonded layer-by-layer assembly of poly(2-vinylpyridine) and poly(acrylic acid): Influence of molecular weight on the formation of microporous film by post-base treatment

This article describes the buildup of hydrogen bonded multilayer film of poly(2-vinylpyridine) (P2VP) and poly(acrylic acid) (PAA), and the influence of polymer molecular weight on the formation of microporous film by post-base treatment. The formation of a microporous film involved a two-step mechanism: the release of PAA from P2VP/PAA multilayer, and the reorganization of the remaining P2VP on the substrate. Fourier transform infrared spectroscopy (FT-IR) indicated that the release of PAA from hydrogen bonded multilayer was a rapid process, which was almost independent of the molecular weight of PAA. Furthermore, the molecular weight of P2VP had a great effect on micropore formation by immersing the P2VP/PAA multilayer in basic solution. The rate of micropore formation increased with increasing molecular weight. We anticipate that a comparative study on P2VP/PAA films containing high or low molecular weight polymer provides a way to control the surface morphology, and will be helpful and constructive for the forthcoming discussion about the formation of the microporous film.     

由聚苯胺粒子组成的电流变液的研究

由经碱处理的掺杂态聚苯胺（ＰＡｎ）制得高介电常数的半导体ＰＡｎ粒子，将其悬浮于电绝缘油可组成电流变液，讨论了电流变（ＥＲ）液的静态屈服应力（τ＿ｓ），电流密度等性能与ＰＡｎ的介电常数（ε＿ｐ），导电率（σ），体积分数和应用电场强度的关系。对导电率相同的ＰＡｎ粒子，用氨水处理的ＰＡｎ粒子ε＿ｐ较用ＮａＯＨ液处理的高，前者在σ足够低如σ≤１．０×１０￣（－７）／ｃｍ时，ＥＲ液的τ＿ｓ随偶极系数的平方（β￣２）的增大而呈现非线性增加；后者ＥＲ液的τ＿ｓ随β￣２的增大出现一最大值．结果表明：由聚苯胺粒子可组成高电流变活性的无水ＥＲ液．     

钙钛矿型LaNiO3、LaMnO3的形成条件

用混合硝酸盐分解法和柠檬酸络合法分别制取了单一钙铁矿型多晶粉末LaNiO_3和LaMnO_3. XRD分析表明LaNiO_3的形成经历了混合氧化物转化为LaNiO_3的同相反应; 而LaMnO_3晶相直接由无定形相转化而来。根据DTA、TG、IR分析两者的形成, NO_3~-离子都起了重要作用. 同时讨论了络合剂柠檬酸的作用.     

Solvation of acylium fragment ions in electrospray ionization quadrupole ion trap and Fourier transform ion cyclotron resonance mass spectrometry

In electrospray ionization (ESI) quadrupole ion trap and Fourier transform ion cyclotron resonance mass spectrometry, certain fragment ions (e.g. acylium ions) generated either during the ion transportation process (in the source interface region) or in the ion trap are found to undergo ion--molecule reactions with ESI solvent molecules (water, acetonitrile and aliphatic alcohols) to form adduct species. These unexpected solvated fragment ions severely complicate the interpretation of mass spectrometic data. High-resolution accurate mass measurements are important in establishing the elemental compositions of these adduct species and preventing erroneous data interpretation.     

紫荆花红色素开发利用的研究

首次报道紫荆花红色素的提取纯化方法及红色素的理化性质，并与玫瑰茄红色素作对比研究，证实同属于花青甙类化合物，又经急性毒性试验证明其毒性极低，故紫荆花天然红色素具有开发利用的价值。     

Multilevel structure of sludge flocs

In this work, the structure of two kaolin sludges and a waste activated sludge are investigated using both light-scattering and free-settling methods. Fractal dimensions estimated by the light-scattering and free-settling techniques (D(S) and D(F) respectively) differ significantly and support the hypothesis that naturally occurring aggregates possess a multilevel structure. A two-level floc structural model comprised of (i) a primary floc (of fractal dimension D(S)) consisting of primary particles and (ii) a secondary floc (of fractal dimension D(F)) consisting of the microflocs is proposed to interpret the experimental findings. The structural changes of sludge flocs before and after cationic flocculation are interpreted using the proposed two-level model.