Characterization of low molecular weight hydrocarbon oligomers by laser desorption/ionization time-of-flight mass spectrometry using a solvent-free sample preparation method.

A new solvent-free sample preparation method using silver trifluoroacetate (AgTFA) was developed for the analysis of low molecular weight paraffins and microcrystalline waxes by laser desorption/ionization time-of-flight mass spectrometry (LDI-TOFMS). Experiments show that spectral quality can be enhanced by dispersing AgTFA directly in liquid paraffins without the use of additional solvents. This preparation mixture is applied directly to the MALDI probe. Solid waxes could be examined by melting prior to analysis. The method also provides sufficiently reproducible spectra that peak area ratios between mono- and bicyclic alkane peaks indicated variations in the cycloalkane content of paraffin samples. Dehydrogenation of hydrocarbons observed during the desorption/ionization process was studied by analysis of alkane standards.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

Design of neutral, mono- or di-cationic water-soluble trihydrazidophosphoradamantanes

The versatile behavior of a trihydrazidophosphoradamantane allowing the synthesis of a variety of neutral, mono- or di-cationic water-soluble molecules of potential interest for biphasic catalysis is reported.     

On the geometry of infinite cyclic subgroups

In this paper we construct an example of a word metric on an infinite cyclic subgroup. This example shows that subexponential distortion does not obstruct non-trivial growth of connected radii. This answers a question of Gromov [6]. The constructed metric has other pathological properies. Specifically, its asymptotic cone depends on the choice of ultrafilter and scaling sequence. The work has been partially supported by the Swiss National Science Foundation.     

IFS attractors and Cantor sets

We build a metric space which is homeomorphic to a Cantor set but cannot be realized as the attractor of an iterated function system. We give also an example of a Cantor set K in R³ such that every homeomorphism f of R³ which preserves K coincides with the identity on K.     

Concentration-cancellation for the velocity fields in two dimensional incompressible fluid flows

We show that the weak-L ² limit of a sequence of solutions of the two dimensional incompressible Euler equation is still a solution, provided that a (strong) concentration set for the reduced defect measure has locally finite one dimensional Hausdorff measure in space and time.     

Integral Inequalities and Global Solutions of Semilinear Evolution Equations

A criterion for the nonexplosion of solutions to semilinear evolution equations on Banach spaces is proved. The result is obtained by applying a modification of the Bihari type inequality to the case of a weakly singular nonlinear integral inequality.     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.     

二项式光场与级联三能级原子的量子纠缠

利用量子熵理论，研究了二项式光场与级联三能级原子的量子纠缠，讨论了光场与原子的初始参量对其量子纠缠性质的影响.结果表明，利用二项式光场的特性，可以揭示从相干态到数态之间的所有态光场与三能级原子相互作用时的量子纠缠性质.选择适当的系统参数可以制备稳定的光场-原子qutrit纠缠态. 关键词： 二项式光场 级联三能级原子 光场熵 量子纠缠     

Laser induced copper electroless plating on polyimide with Q-switch Nd:YAG laser

The results of laser induced deposition of copper on polyimide substrate from copper electrolyte solution are reported. Unlike most work reported in the literatures where CW Ar⁺ lasers were used, a second harmonic (532 nm wavelength) Q-switch Nd:YAG laser was used for our experiments. The deposition process was conducted by laser-catalyzing of the polyimide surface and subsequent photothermal-accelerated reduction of copper-complex ions in an alkaline reducing environment. The characteristics of the deposited copper line were investigated in terms of laser beam scanning speed, and the number of scans. The surface morphology and chemical composition of the deposited copper were analyzed using field emission scanning electron microscope (FESEM) and energy dispersive spectrometer (EDX). The optimum processing conditions have been identified. The copper deposit was found to adhere well to the substrate.