Individually addressable submicron scale light-emitting devices based on electroluminescence of solid Ru(bpy)3(ClO4)2 films

A submicron light-emitting device (LED) was fabricated from lithographically fabricated parallel indium-tin oxide (ITO) finger electrodes (0.9 mum wide) separated by a 1.1 mum gap. A single layer of an amorphous (a) Ru(bpy)3(ClO4)2 film ( approximately 100 nm thick) was spin-coated on the electrode array. Ga:In or carbon paste was employed as a liftable upper contact electrode. Films ( approximately 1.5 mum thick) of single-crystal Ru(bpy)3(ClO4)2 (xyl) between two ITO electrodes in a sandwich cell were also prepared and produce electroluminescence. As with larger cells of this type, the high-resolution electroluminescence produced showed a high external efficiency ( approximately 3.4%), a low turn-on voltage (2.3 V), and reasonable stability. The single-crystal cells also behaved as photovoltaic devices and a short-circuit photocurrent was observed when they were irradiated without a bias voltage.     

Synthesis of 9-(2,3-dihydroxy-1-propoxymethyl)guanine - a new potential antiviral agent

Coupling of tris(trimethylsilyl)guanine (4) with 1,2-di-$\text{O}$-acetyl-3-$\text{O}$chloromethyl glycerol (3), followed by removal of the protecting groups afforded 9-(2,3-dihydroxy-1-propoxy)guanine (1). Compound 1 exhibited potent antiviral activity.     

合成香料β-大马酮的高效液相色谱分析

本文提出了用分析型HPLC仪器制备β-大马酮标准品的方法及用HPLC测定β-大马酮含量的方法。制备色谱柱为Zorbax SIL 9.4 mmφ×25cm,流动相为石油醚(30～60℃)/乙醚98.5/1.5。分析用色谱柱为Shim CLC SIL 6 mmφ×15cm(岛津全多孔硅胶柱),流动相为石油醚(60—90℃)/无水乙醇99.88/0.12,检测器为紫外可见分光光度检测器。波长253nm或302nm,标准曲线的线性范围0～1.4mg/ml。峰高或峰面积均可用于测定,回收率100.7%。     

Fluoro-substituted DPP-bisthiophene conjugated polymer with azides in the side chains as ambipolar semiconductor and photoresist

Photoresists are essential for the fabrication of flexible electronics through all-photolithographic processes. Single component semiconducting photoresist exhibits both semiconducting and photo-patterning properties, and as a result, the device fabrication process can be simplified. However, the design of semiconducting polymeric photoresist with ambipolar semiconducting property remains challenging. In this paper, we report a single component semiconducting photoresist (PFDPPF4T-N₃) by incorporating azide groups and noncovalent conformation locks into the side alkyl chains and conjugated backbones of a diketopyrrolopyrrole-based conjugated polymer, respectively. The results reveal that PFDPP4FT-N₃ exhibits ambipolar semiconducting property with hole and electron mobilities up to 1.12 and 1.17 cm² V^?1 s^?1, respectively. Moreover, field effect transistors with the individual photo-patterned thin films of PFDPPF4T-N₃ also show ambipolar semiconducting behavior with hole and electron mobilities up to 0.66 and 0.80 cm² V^?1 s^?1, respectively. These results offer a simple yet effective design strategy for high-performance single component semiconducting photoresists, which hold great potential for flexible electronics processed by all photolithography.

     

Separation and determination of podophyllum lignans by micellar electrokinetic chromatography

A micellar electrokinetic chromatography method was established for the quantitative analysis of seven podophyllum lignans in Podophyllum emodi Wall. var. chinesis sprague. The optimum buffer system was 10 mM NaH2PO4-5 mM borate-100 mM sodium dodecylsulfate-30% isopropanol (pH 7.20). Voltage was 18 kV and detection at 214 nm. The second derivative chromatogram was used to determine a low-content component and those not fully separated from adjacent ones. The RSD values of migration times and peak areas were <2.2 and <5.5%, respectively. The effects of several CE parameters on the resolutions were studied systematically.     

Use of p-dimethylaminobenzalhyde as a colored reagent for determination of procaine hydrochloride by spectrophotometry

Spectrophotometric determination of procaine hydrochloride is described. The procaine hydrochloride reacts with p-dimethylaminobenzalhyde in glacial acetic acid to form an Schiff base which is a yellow compound, and its maximum absorption wavelength is at 455nm, ₄₅₅=3.46×10⁴. The absorbance for procaine hydrochloride from 0.2 to 15 μg ml⁻¹ obeys Beer's law. The linear regression equation of the calibration graph is C=5.866A−0.02, with a linear regression correlative coefficient is 0.9994 and relative standard deviation (RSD) of 1.7%; the detection limit is 0.1 μg ml⁻¹; recovery is from 92.0 to 110.0%. Effects of reaction medium, temperature, gentamycin, beneylpenicillin, kanamycin, streptomycin, foreign ions, and stand for time on the determination of procaine hydrochloride have been examined. The results obtained by this method agreed with those by the official method (dead-stop titration). This method is rapid and simple, and can be used for the determination of procaine hydrochloride in injection solution of procaine hydrochloride.     

Oxidative reactivity of S-nitrosoglutathione with Hantzsch 1,4-dihydropyridine

[formula: see text] S-Nitrosoglutathione oxidized 4-substituted Hantzsch 1,4-dihydropyridines in CH3CN/H2O or CH3CN/phosphate aqueous buffer solution to give aromatic products in various yields.     

A metallo-capped polyrotaxane containing calix[4]arenes and cyclodextrins and its highly selective binding for Ca2+

A water-soluble nanometer-scale metallocapped polyrotaxane has been prepared by the inclusion complexation of azo-calixarenes with metallo-bridged bis(beta-CD)s, displaying highly selective binding for Ca(2+).     

Chiral separation of N-(trans-4-isopropylcyclohexylcarbonyl)-D,L-phenylalanine isomers by high performance liquid chromatography

Summary A high-performance liquid chromatographic method was developed for the chiral separation of a new anti-diabetic agent, N-(trans-4-isopropylcyclohexylcarbonyl)-D-phenylalanine, and its L-enantiomer. The separation was performed on a Sumichiral OA-3300 column. Optimized mobile phase was 0.025 mol.L⁻¹ ammonium acetate in methanol solution. UV detection was at 210 nm. Baseline chiral separation was obtained within 12 minutes. The detection limits are 80 pg for the D-enantiomer and 120 pg for the L-enantiomer. RSD of the method was below 1% (n=5).