Determination of buprenorphine by high-performance liquid chromatography with fluorescence detection: application to human and rabbit pharmacokinetic studies.

A rapid, sensitive, precise and accurate high-performance liquid chromatographic assay with fluorescence detection was developed for the determination of buprenorphine in human, rabbit, pig and dog plasma. It is comprised of only a one-step extraction procedure with hexane-isoamyl alcohol at pH 9.25 and reversed-phase chromatography on a muPorasil column. The recoveries of buprenorphine and nalbuphine (internal standard) were greater than 90%. Calibration graphs were linear over the concentration range 3-300 ng/ml with a coefficient of variation, both within-day and between-day, of less than 9% at any level. The limit of detection was 1.0 ng/ml of plasma based on a signal-to-noise ratio of 3. Eight other clinically used narcotics were investigated to check for potential interferences and their analytical conditions. The possible decomposed compounds of buprenorphine were also checked for the specificity of this assay. The method has been successfully applied to the stability and pharmacokinetic studies of buprenorphine. Buprenorphine in plasma did not decompose significantly at -20 degrees C for four weeks. Pharmacokinetic application in six rabbits and a surgical patient revealed that buprenorphine followed a linear three-compartment model with two distribution phases. The two distribution and elimination half-lives and the clearance of buprenorphine were 1.32, 24.8 and 230 min and 224 ml/min in human plasma, and 0.94, 12.5 and 232 min and 30 ml/min in rabbit plasma.     

DOPING LEVEL INCREASE OF POLY(3-METHYLTHIOPHENE)FILM DURING ELECTROCHEMICAL POLYMERIZATION PROCESS

The Raman spectra of poly(3-methylthiophene) (PMeT) films with different thicknesses, which have beenelectrochemically deposited on a flat stainless steel electrode surface by direct oxidation of 3-methylthiophene in borontrifluoride diethyl etherate (BFEE) at a constant applied potential of 1.38 V (versus SCE), have been investigated byexcitation with a 633-nm laser beam. The spectroscopic results demonstrated that the doping level of PMeT film wasincreasing during film growth. This finding was also confirmed by electrochemical examination. Moreover, the Raman bandsassigned to radical cations and dications in doped PMeT films were found approximately at 1420 and 1400 cm~(-1),respectively. Radical cations and dications coexist on the backbone of PMeT as conductive species and their concentrationsincrease with the increase of doping level. Successive cyclic voltammetry was proved to be an effective approach toimproving the doping level of as-grown thin compact PMeT film.     

An ab initio study of some structural features and the rotational barriers in performic acid,formic acid and hydrogen peroxide

Calculations on performic acid at the 4-31G level, with and without bond functions with complete geometry optimization, and at the (9, 5) level, with and without polarization functions and rigid rotation, all give no sign of a well in the potential energy curve for rotation about the O/O bond axis in the region of 50° – 90° ; and all but the unaugmented 4-31G basis set find the cis-cis planar conformer to be the most stable form. Calculations at the (9,5) level with rigid rotation find the energies of the other planar conformers, relative to the cis-cis conformer, to be 0.94, 1.50 and 14.80 kcal mol^?1 for the trans-trans, cis-trans and trans-cis structures respectively. These energies and also that for the barrier separating the cis-cis and cis-trans conformers, 1–2 kcal mol^?1, are discussed in relation to corresponding data for formic acid, hydrogen peroxide and several planar four heavy-atom molecules. Dipole moment calculations using the same basis sets would seem to favor a skew conformation as the most stable for performic acid, but comparisons between calculated and experimental values for formic acid and for hydrogen peroxide cast doubt on the validity of such results.     

Ring expansion and hydrogen scrambling in the molecular ion of 3-methylthiophene

The ratio [M ? D]/{[M-D] + [M ? H]} in the 70 eV mass spectra of six deuterated 3-methylthiophenes has been determined. From these values the mole fractions of the molecular ions that lose hydrogen atoms specifically from the various positions of the molecule were calculated, as well as the mole fraction in which the hydrogen atoms are fully scrambled before hydrogen elimination. It appears that hydrogen atoms are mainly lost from a fully scrambled [C₅H₆S]⁺· ion and from the α-position of the original molecular ion. A deuterium isotope effect of 1·60 to 1·72 was calculated for the hydrogen elimination. The reaction was also studied at low electron energies. In order to determine the degree of scrambling in the [C₅H₅S]⁺ ions, some decomposition reactions of this ion were investigated.     

Optimization of the extraction and fractionation of corn bran oil using analytical supercritical fluid instrumentation

Supercritical fluid extraction (SFE) is combined with supercritical fluid chromatography (SFC) in an analytical mode to develop a system for fractionating and enriching high value ferulate-phytosterol esters (FPE) contained in corn bran oil. Corn bran is initially extracted with neat supercritical carbon dioxide (SC-CO2) at various pressures (13.8, 34.5, and 69 MPa) and temperatures (40, 60, and 80 degrees C) to see if the FPE can be enriched in the extracts. These initial studies show the greatest percentage of FPE could be extracted under two sets of conditions: 69 MPa at 80 degrees C and 34.5 MPa at 40 degrees C. Both sets of parameters yield an extract containing approximately 1.25% FPE. A stock supply of corn bran oil is then produced by scaled-up SFE at 34.5 MPa and 40 degrees C for subsequent chromatographic fractionation. The SFE-obtained corn bran oil is then applied to the head of a minichromatographic column containing an amino-propyl sorbent. SFC is than commenced using neat SC-CO2 at 69 MPa and 80 degrees C to remove the majority of the triglyceride-based oil. Pressure and temperature are then lowered to 34.5 MPa and 40 degrees C, respectively, and ethanol is added as a modifier. The modifier is added in an increasing stepwise gradient program, and fractions are collected at equal volume intervals. The resultant fractions are analyzed by analytical high-performance liquid chromatography with evaporative light-scattering detection and show that FPE could be enriched to a 14.5% (w) level.     

Rapid, high-sensitivity reversed-phase liquid chromatographic assay for 9-chloro-2-(2-furyl) [1,2,4]triazolo[1,5-c]quinazolin-5-imine and its oxo metabolite in plasma using fluorescence detection

A rapid, sensitive and specific assay for 9-chloro-2-(2-furyl) [1,2,4]triazolo[1,5-c]quinazolin-5-imine (I) and its oxo metabolite (II) in plasma was developed and validated employing reversed-phase high-performance liquid chromatography with fluorescence detection. Sample preparation was achieved by a simple ethyl acetate extraction from plasma buffered at pH 10 (0.1 M boric acid-0.1 M potassium chloride). Chromatographic analyses were performed isocratically on a C18 column, with a mobile phase consisting of methanol-0.2 M sodium acetate buffer, pH 5.0 (67:33, v/v). Chromatographic run time was less than 8 min. The assay was linear (r greater than 0.9998) over the concentration range 1.50-10,000 ng/ml for both I and II; for individual studies, curves covering a range of two orders of magnitude were generally employed. Limits of detection for I and II were 0.5 and 1.0 ng/ml, respectively. A preliminary investigation of the plasma concentrations of I and II in the rat following a single 30 mg/kg oral dose demonstrated the applicability of the method for pharmacokinetic studies.     

Converged quantum calculations of HO2 bound states and resonances for J=6 and 10

Bound and resonance states of HO(2) are calculated quantum mechanically using both the Lanczos homogeneous filter diagonalization method and the real Chebyshev filter diagonalization method for nonzero total angular momentum J=6 and 10, using a parallel computing strategy. For bound states, agreement between the two methods is quite satisfactory; for resonances, while the energies are in good agreement, the widths are in general agreement. The quantum nonzero-J specific unimolecular dissociation rates for HO(2) are also calculated.     

Use of organophosphorus extractants impregnated on silica gel for the extraction chromatographic separation of minor actinides from high level waste solutions

Silica-gel has been used as an inert support for the extraction chromatographic separation of actinides and lanthanides from HNO₃ and synthetic high level waste (HLW) solutions. Silica-gel was impregnated with tri-butyl phosphate (TBP), to yield STBP; 2-ethylhexyl phosphonic acid, mono 2-ethylhexyl ester (KSM-17, equivalent to PC-88A), SKSM; octyl(phenyl)-N,N-diisobutyl carbamoylmethylphosphine oxide (CMPO), SCMPO; and trialkylphosphine oxide (Cyanex-923), SCYN and sorption of Pu(IV), Am(III) and Eu(III) from HNO₃ solutions was studied batchwise. Several parameters, like time of equilibration, HNO₃ and Pu(IV) concentrations were varied. The uptake of Pu(IV) from 3.0M HNO₃ followed the order SCMPO>SCYN>SKSM>STBP. With increasing HNO₃ concentration, D _Pu increased up to 3.0M of HNO₃ for STBP, SKSM and SCMPO and then decreased. In the case of Am and Eu with SCMPO, the D values initially increased between 0.5 to 1.0M of HNO₃, remained constant up to 5.0M and then slightly decreased at 7.5M. Also, the effects of NaNO₃, Nd(III) and U(VI) concentrations on the uptake of Am(III) from HNO₃ solutions were evaluated. With increasing NaNO₃ concentration up to 3.0M, D _Am remained almost constant while it was observed that it decreases drastically by adding Nd(III) or U(VI). The uptake of Pu and Am from synthetic pressurized heavy water reactor high level waste (PHWR-HLW) in presence of high concentrations of uranium and after depleting the uranium content, and finally extraction chromatographic column separation of Pu and Am from U-depleted synthetic PHWR-HLW have been carried out. Using SCMPO, high sorption of Pu, Am and U was obtained from the U-depleted HLW solution. These metal ions were subsequently eluted using various reagents. The sorption results of the metal ions on silica-gel impregnated with several phosphorus based extractants have been compared. The uptake of Am, Pu and rare earths by SCMPO has been compared with those where CMPO was sorbed on Chromosorb-102, Amberchrom CG-71 and styrene divinylbenzene copolymer immobilized in porous silica particles.     

On incorporation of atomic correlation in transition-metal molecular calculations: NiH

The atomic correlation terms necessary to lead to anaccurate 4s²3d⁸-4s^t 3d⁹ separation for the Ni atom have been incorporated into all-electron MC SCF/Cl calculations for the X² Δ state of NiH. The calculated potential curve properties are significantly improved compared to calculations which dissociate to Hartree-Fock atoms.     

First order magnetic transition,magnetic structure,and vacancy distribution in Fe2P

The para- to ferromagnetic transition in Fe₂P has been studied using Mössbauer spectroscopy. The magnetic hyperfine fields drop abruptly from about half of their saturation values to zero at 214.5 K indicating a first order transition. The isomer shifts show a discontinuous change at the transition point. For some samples the transition takes place over a wide temperature range, probably due to impurities and other imperfections in the samples. From the magnetic hyperfine fields at 15 K the magnetic moments can be deduced to be 1.14 μ_B and 1.78 μ_B for Fe(1) and Fe(2), respectively. An assignment of the components in the Mössbauer spectra to the two crystallographically nonequivalent iron positions has been made from the temperature variation of the spectra.The ordering of metal vacancies has been investigated by a Mössbauer study of a nonstoichiometric Fe₂P sample and by an X-ray diffraction study of a nonstoichiometric Mn₂P crystal.