Synthesis of 21-nor-22-oxa-1α,25-dihydroxyvitamin D3 derivatives in quest of a drug with low calcemic activity

Two 21-nor-22-oxa-1α,25-dihydroxyvitamin D₃ derivatives have been synthesized in quest of a drug with lower calcemic activity than Maxacalcitol, 22-oxa-1α,25-dihydroxyvitamin D₃, being used as antihyperparathyroidism and antipsoriatic drug. Of two 21-nor products obtained, the product carrying one carbon elongated side chain with diethylcarbinol moiety has been found to exhibit comparable differentiation-inducing activity to Maxacalcitol with much lower exhibition of calcemic activity.     

Purification of a marine bacterial glucose dehydrogenase fromCytophaga marinoflava and its application for measurement of 1,5-anhydro-d-glucitol

A novel glucose dehydrogenase (GDH) from a marine bacteriumCytophaga marinoflava IFO 14170 was isolated from its membrane fraction. This GDH catalyzes the oxidation of a hydroxy group of glucose, but does not react in its C-l position. This enzyme is composed of a single peptide with a mol wt of 67,000. The GDH can react under high salinity. The optimum pH is around 8.0, showing a typical property of marine bacterial enzymes. Using this novel enzyme, an enzymatic determination of 1,5-anhydro-D-glucitol (1,5AG) utilizing 2,6-dichrolophenolindophenol (DCIP) and phenazine methosulfate (PMS) as electron mediators was caried out. A good linear correlation was observed from 0.5 mM to 4 mM of 1,5AG.     

Effects of electron beam preirradiation on the γ radiolysis of polyethylene

The γ radiolysis of polyethylene preirradiated with electron beams to 3 Mrad was carried out at 30–100°C in vacuo with a dose rate of 6.35 × 10⁵ rad/hr. The hydrogen formation in the γ radiolysis was little affected by the preirradiation of electron beams, whereas the formation of trans-vinylene unsaturation and gel was somewhat retarded. The rates of the formation of hydrogen and trans-vinylene unsaturation were described by the zero-order formation kinetics with respect to each concentration combined with the first-order disappearance. The apparent rate constants and activation energies for the formation and disappearance of hydrogen and trans-vinylene unsaturation were almost independent of the preirradiation. The gel fraction was analyzed by using the Charlesby–Pinner equation. The G values of crosslinking and main chain scission were increased by the preirradiation, whereas their activation energies remained unaltered. On the basis of these results the effects of preirradiation on the reactions induced by γ rays in polyethylene were discussed.     

Separation and determination of some stereoisomers by capillary gel electrophoresis with cyclodextrin incorporated in polyacrylamide gel

Capillary gel electrophoresis (CGE) was successfully applied to the separation of optically active isomers and position isomers by incorporating a suitable cyclodextrin chiral selector in polyacrylamide gel. A commercially available ß-cyclodextrin (ß-CD) was used for enantioselectivity towards o-, m- and p-nitrobenzoic acid, o-, m- and p-hydroxybenzoic acid, o-, m- and p-toluic acid and the optical isomers of dansyl-D,L-leucine and R,S-1,1-binaphthyl-2,2-dihydrogenphosphate. Especially the effect of organic solvents, such as acetonitrile, methanol, dimethylsulphoxide and others were examined in detail. The resolution varied to some extent with the addition of the organic solvent to the polyacrylamide gel and the running buffer solution. The possible mechanism has also been discussed. In addition, quantitative aspects of the separation of stereoisomers using CGE have been studied, showing that both the resolution and accuracy of the determinations were affected by the ratio of the enantiomers.     

Methane partial oxidation to formaldehyde with oxygen over SiO2-supported molybdenum oxide catalysts

The formation rate of formaldehyde increases with increasing surface area of SiO₂ support, but the selectivity does not. From the characterization of catalysts using XRD, SEM and Raman spectroscopy, highly dispersed molybdenum oxide was considered to be much more active for the formation of formaldehyde than crystallite forms of MoO₃.     

Recent progress of high-power negative ion beam development for fusion plasma heating

A negative-ion-based neutral beam injector (N-NBI) has been constructed for JT-60U. The N-NBI is designed to inject 500 keV, 10 MW neutral beams using two ion sources, each producing a 500 keV, 22 A D⁻ ion beam. In the preliminary experiment using one ion source, a D⁻ ion beam of 13.5 A has been successfully accelerated with an energy of 400 keV (5.4 MW) for 0.12 s at an operating pressure of 0.22 Pa. This is the highest D⁻ beam current and power in the world. Co-extracted electron current was effectively suppressed to the ratio of Ie/I_D⁻ < 1. The highest energy beam of 460 keV, 2.4 A, 0.44 s has also been obtained. To realize 1 MeV class NBI system for ITER (International Thermonuclear Experimental Reactor), demonstration of ampere class negative ion beam acceleration up to 1 MeV is an important mile stone. To achieve the mile stone, a prototype accelerator and a 1 MV, 1 A test facility called MeV Test Facility (MTF) were constructed. Up to now, an H⁻ ion beam was accelerated up to the energy of 805 keV with an acceleration drain current of 150 mA for 1 s in a five stage electrostatic multi-aperture accelerator.     

Distribution pattern of rare earth ions between water and montmorillonite and its relation to the sorbed species of the ions.

REE (rare earth element) distribution coefficients (Kd) between the aqueous phase and montmorillonite surface were obtained to investigate the relation between the REE distribution patterns and the species of REE sorbed on the solid-water interface. It was shown that the features in the REE patterns, such as the slope of the REE patterns, the tetrad effect, and the Y/Ho ratio, were closely related to the REE species at the montmorillonite-water interface. In a binary system (REE-montmorillonite) below pH 5, three features (a larger Kd value for a lighter REE, the absence of the tetrad effect, and the Y/Ho ratio being unchanged from its initial value) suggest that hydrated REE are directly sorbed as an outer-sphere complex at the montmorillonite-water interface. Above pH 5.5, the features in the REE patterns, the larger Kd value for heavier REE, the M-type tetrad effect, and the reduced Y/Ho ratio, showed the formation of an inner-sphere complex of REE with -OH group at the montmorillonite surface. In addition, the REE patterns in the presence of humic acid at pH 5.9 were also studied, where the REE patterns became flat, suggesting that the humate complex is dominant as both dissolved and sorbed species of REE in the ternary system. All of these results were consistent with the spectroscopic data (laser-induced fluorescence spectroscopy) showing the local structure of Eu(III) conducted in the same experimental system. The present results suggest that the features in the REE distribution patterns include information on the REE species at the solid-water interface.     

Formation and stabilization model of the 42-mer Abeta radical: implications for the long-lasting oxidative stress in Alzheimer's disease

Amyloid fibrils mainly consist of 40-mer and 42-mer peptides (Abeta40, Abeta42). Abeta42 is believed to play a crucial role in the pathogenesis of Alzheimer's disease because its aggregative ability and neurotoxicity are considerably greater than those of Abeta40. The neurotoxicity of Abeta peptides involving the generation of free radicals is closely related to the S-oxidized radical cation of Met-35. However, the cation's origin and mechanism of stabilization remain unclear. Recently, structural models of fibrillar Abeta42 and Abeta40 based on systematic proline replacement have been proposed by our group [Morimoto, A.; et al. J. Biol. Chem. 2004, 279, 52781] and Wetzel's group [Williams, A. D.; et al. J. Mol. Biol. 2004, 335, 833], respectively. A major difference between these models is that our model of Abeta42 has a C-terminal beta-sheet region. Our biophysical study on Abeta42 using electron spin resonance (ESR) suggests that the S-oxidized radical cation of Met-35 could be generated by the reduction of the tyrosyl radical at Tyr-10 through a turn structure at positions 22 and 23, and stabilized by a C-terminal carboxylate anion through an intramolecular beta-sheet at positions 35-37 and 40-42 to form a C-terminal core that would lead to aggregation. A time-course analysis of the generation of radicals using ESR suggests that stabilization of the radicals by aggregation might be a main reason for the long-lasting oxidative stress of Abeta42. In contrast, the S-oxidized radical cation of Abeta40 is too short-lived to induce potent neurotoxicity because no such stabilization of radicals occurs in Abeta40.     

Modern Synthetic Methods for Fluorine‐Substituted Target Molecules

Fluorine has come to be recognized as a key element in materials science: in heat‐transfer agents, liquid crystals, dyes, surfactants, plastics, elastomers, membranes, and other materials. Furthermore, many fluorine‐containing biologically active agents are finding applications as pharmaceuticals and agrochemicals. Progress in synthetic fluorine chemistry has been critical to the development of these fields and has led to the invention of many novel fluorinated molecules as future drugs and materials. As a result of the electronic effects of fluorine substituents, fluorinated substrates and reagents often exhibit unusual and unique chemical properties, which often make them incompatible with established synthetic methods. Thus, the problem of how to control the unusual properties of compounds with fluorine substituents deserves much attention, so as to promote the design of facile, efficient, and environmentally benign methods for the synthesis of valuable organofluorine targets.     

Fluorinated monomer–styrene copolymer latex particles: I. kinetic studies in a soap-free aqueous medium

Soap-free emulsion copolymerization of 2, 2, 2-trifluoroethyl acrylate (3FEA) with styrene was carried out by using potassium persulfate as an initiator, and the effects of the weight fraction of 3FEA in the monomer feed on the kinetics and the particle size were investigated. Monomer conversions were followed by a gravimetric method, revealing that the overall polymerization rate increased exponentially with an increase in the weight fraction of 3FEA. According to dynamic light scattering measurement, the final particle size was found to decrease with an increase in the weight fraction of 3FEA. The number of particles for 3FEA homopolymerization was roughly twice as large as that at the fraction of 0.9, although both fractions had the almost same polymerization rates. These results indicate that soap-free emulsion homopolymerization of 3FEA would proceed not only inside the polymer particles but also in the aqueous phase throughout the polymerization.