γ-Ray-induced polymerization of α-haloacrylic acids

The γ-ray induced polymerizations of α-chloroacrylic acid, mp 66°C, and α-bromo-acrylic acid, mp 72°C, were investigated in the temperature range from 35°C to 85°C. An analysis of polymerization kinetics was made, and results were similar to those reported in the literature for other vinyl monomers. On heating of the polymer obtained, elimination of hydrogen halide takes place, and intramolecular lactone formation is observed. The rate of lactone formation of poly(α-chloroacrylic acid) obtained in the solid-state polymerization was found to be higher than that in the liquid state, because a highly isotactic configuration of polymers, tends to be formed in the solid-state polymerization, and elimination of hydrogen chloride is facilitated with an isotactic 5₂ helix structure.     

Ionic liquid crystal as a hole transport layer of dye-sensitized solar cells

Use of a new ionic liquid crystal, 1-dodecyl-3-methylimidazolium iodide, and iodine as an electrolyte of dye-sensitized solar cells leads to a high short circuit photocurrent density and a high light-to-electricity conversion efficiency, due to a self-assembled structure of the imidazolium cations, resulting in high conductivity of the electrolyte.     

Preparation of rapidly disintegrating tablet using new types of microcrystalline cellulose (PH-M series) and low substituted-hydroxypropylcellulose or spherical sugar granules by direct compression method

To decrease the sensation of roughness when a tablet, which is rapidly disintegrated by saliva (rapidly disintegrating tablet), is orally taken, we prepared rapidly disintegrating tablets using microcrystalline cellulose (Avicel PH-M series), a new type of pharmaceutical excipient that is spherical and has a very small particle size (particle size, 7-32 microm), instead of conventional microcrystalline cellulose (PH-102) used in the formulation of tablets containing acetaminophen or ascorbic acid as model drugs for tableting study. Tablets (200 mg) prepared using spherical microcrystalline cellulose, PH-M-06, with the smallest particle size (mean value, 7 microm) had sufficient crushing tolerance (approximately, 8 kg) and were very rapidly, disintegrated (within 15 s) when the mixing ratio of PH-M-06 to low-substituted hydroxypropylcellulose (L-HPC) was 9:1. Sensory evaluation by volunteers showed that PH-M-06 was superior to PH-102 in terms of the feeling of roughness in the mouth. Consequently, it was found that particle size is an important factor for tablet preparation using microcrystalline cellulose. It is possible to prepare drugs such as acetaminophen and ascorbic acid (concentration of approximately 50%) in the tablet form using PH-NM-06 in combination with L-HPC as a good disintegrant at a low compression force (1-6 kN). To solve the problem of poor fluidity in the preparation of these tablets, we investigated the use of spherical sugar granules (Nonpareil, NP-101 (sucrose and starch, composition ratio of 7:3), NP-103 (purified sucrose), NP-107 (purified lactose) and NP-108 (purified D-mannitol)). Rapidly disintegrating tablets can be prepared by the direct compression method when suitable excipients such as fine microcrystalline cellulose (PH-M-06) and spherical sugar granules (NP) are used.     

Effect of dose rate on the radiation-induced polymerization of ethylene in tert-butyl alcohol

The dependence of the dose rate on the rate of radiation-induced polymerization of ethylene in tert-butyl alcohol containing 5 vol-% water was studied. The reaction was carried out by use of a reactor with a capacity of 100 ml under the following conditions: pressure, 200 kg/cm²; temperature, 24 ± 3°C; dose rate, 3.7 × 10⁴?1.6 × 10⁵ rad/hr; amount of medium, 70 ml. The dose rate exponents for rate of the polymerization, the molecular weight, and the number of polymer chain were found to be about 0.8, ?0.1, and 0.9, respectively. These results were well explained with kinetic results (obtained by a novel analytical method) for the polymerization which contain both first-order and second-order terminations for the concentrations of propagating radical. The individual values of the rate constants in each elementary reaction were also obtained.     

Synthetic study of optically active and C2-symmetric novel ligand, 7,8-bis(benzyloxy)bicyclo[2.2.2]octa-2,5-diene and a tricarbonyliron complex

The 7,8-bis(benzyloxy)bicyclo[2.2.2]octa-2,5-diene derivatives have been synthesized via Diels-Alder reaction of optically active 5,6-bis(benzyloxy)cyclohexa-1,3-diene and dienophiles. The corresponding tricarbonyliron complexes have also been synthesized in enantiomerically pure form.     

Absorption enhancement of polypeptide drugs by cyclodextrins. I. Enhanced rectal absorption of insulin from hollow-type suppositories containing insulin and cyclodextrins in rabbits.

The absorption of insulin (from porcine pancreas) from the rectum of rabbits after the administration of hollow-type suppositories containing insulin and five kinds of cyclodextrins (CyDs) was investigated. Three types of suppositories were employed: suppository I containing insulin (approximately 26 IU/mg) and various amounts of each CyD in citric buffer solution at pH 3.0 or powder in its cavity, suppository II containing CyD without insulin, and suppository III containing insulin without CyD. Without CyD, the insulin and glucose levels in plasma were unchanged, whereas a significant increase in the plasma insulin concentration and a marked decrease in the glucose levels were found following simultaneous administration of insulin and CyDs by suppository I. The enhancing effect of CyD on rectal insulin absorption (absorption-enhancing effect) by chemically modified CyDs (heptakis(2,6-di-O-methyl)-beta-CyD (DM-beta-CyD) and 2-hydroxypropyl-beta-CyD (HP-beta-CyD)) was higher than those by natural CyDs (alpha-, beta-, and gamma-CyD). The area under the plasma concentration-time curve (AUC) and Cmax of insulin significantly decreased with the preadministration (administration of CyD 6, 24 and 48 h before rectal insulin administration) of DM-beta-CyD. The absorption-enhancing effect disappeared 24 h after preadministration. These results suggest that CyDs enhance insulin absorption from the rectum, and that attenuation of the membrane transport barrier function in the rectum recovers at a maximum of 24 h after administration of CyDs.     

Catalytic oxygenative degradation of 4-chlorocatechol by a nonheme iron(III) complex—Mechanism and prevention of catechol ester formation

We examined the oxygenative degradation of 4-chlorocatechol and 4-tert-butylcatechol catalyzed by iron(III)-tris(pyridin-2-yl)amine complex from the standpoint of repressing the formation of 4-chlorocatechol esters of the oxygenated products that causes the incomplete degradation of 4-chlorocatechol. Analysis of the products revealed that 4-chlorocatechol esters are formed by the reaction of muconic anhydride, which is the monooxygenated product, with catechols. It was found that the use of MeOH as the solvent instead of MeCN completely suppressed the catechol ester formation through the methanolysis of muconic anhydride, which greatly improves the degradation efficiency of 4-chlorocatechol.     

6-O-carboxymethyl-chitin (CM-chitin) as a drug carrier

Gel was prepared from 6-O-carboxymethyl-chitin (CM-chitin) by the addition of iron(III) chloride under mild conditions without any organic solvent. The optimal conditions for the gel formation were 15 to 30 mM iron(III) chloride and 0.5 to 0.8 degree of substitution in CM-chitin. The amounts of bovine serum albumin (BSA) and the anticancer drug doxorubicin (DOX) incorporated into CM-chitin gels were more than 80% and 30%, respectively under the conditions described above. The release of BSA or DOX from the gels was observed to be increased by lysozyme digestion in a time-dependent manner. This result indicates that CM-chitin might prove useful as a carrier gel for the sustained release of drugs and cytokines, including vaccines.     

Synthesis of aryltriethoxysilanes via rhodium(I)-catalyzed cross-coupling of aryl electrophiles with triethoxysilane

The general and efficient silylation of aryl halides has been developed utilizing triethoxysilane and a rhodium catalyst. The substrate scope is broad and includes ortho-, meta-, and para-substituted electron-rich and -deficient aryl iodides. In addition, the silylation of aryl bromides and fluoroalkanesulfonates proceeded in the presence of tetra-n-butylammonium iodide.