Heat of immersion of iron(III) oxides in water at 25°C

The heat of immersion in water was measured at 25°C for three iron(III) oxides using a twin-type microcalorimeter. One of the samples was commercial α-Fe₂O₃ (sample C) and the other two (samples M and F) were prepared by calcining magnetite and iron(III) hydroxide in air at various temperatures, T_p, from 300 to 700°C. The samples were evacuated at outgassing temperature, T_o, between room temperature and 500°C at a pressure of 1 × 10^?2?2.7 × 10^?2N m^?2 for 6 h. The heat of immersion, h_i(J m^?2), of samples C and M increased with an increase in T_o and showed the maximum h_i at T_o =400°C, while sample F did not show the maximum up to T_o =500°C. The systematic correlation was not observed between h_i and T_p of sample F. The heat of reproduction of the surface hydroxyl group on sample F was approximately estimated as 6.6 × 10⁴ J mole^?1 H₂O.     

Stabilities in field electron emissions from noble‐metal covered W nano‐tips: apex structure dependence

We observed field emission microscopy (FEM) patterns of noble‐metal (NM) covered W nano‐tips with three different apex structures fabricated by field evaporation. Each of the three tips was terminated with a single atom, three atoms or ten atoms. We investigated the temporal changes in the FEM of these tips to discuss the stabilities in the spatial distributions of the field emission (FE) beams. The single‐atom tip showed two characteristics that were superior to the others. First, the beams emitted from the single‐atom tip were the most collimated among the three tips (the semi‐cone angle of 1.0° , FWHM). Second, adsorption of residual gas had little influence on FE from the single‐atom tip, while the other tips were easily contaminated even at ultra high vacuum, resulting in the emission fluctuation. Copyright © 2006 John Wiley & Sons, Ltd.     

Extraction of Catecholamines by Calixarene Carboxylic Acid Derivatives

Extraction behaviors of catecholamines with a series of calixarene carboxylic acid derivatives were investigated. Relatively large calix[6]arene and calix[8]arene extract catecholamines into the organic solution, while smaller calix[4]arene and the monomer analog do not. The calix[6]arene, which has a cavity that fits a protonated amino group well, selectively extracts a primary amino compound dopamine over other catecholamines. Slope analysis and Job’s method confirmed formation of a 1:1 complex between the calix[6]arene and dopamine. On the other hand, the calix[8]arene extracts both dopamine and adrenaline, due to the large cavity for induced-fit recognition. Dopamine extracted with the calixarene is quantitatively stripped by contacting the organic solution with a fresh acidic solution.     

Extraction Behavior of Amino Acids by Calix[6]arene Carboxylic Acid Derivatives

A series of calixarene carboxylic acid derivatives were synthesized for the extraction of amino acids. A calix[6]arene carboxylic acid derivative showed the highest extractability to the target tryptophan ester. The main driving forcefor the complexation was the interaction between the ammonium cation of the aminoacid and the oxygen atoms of the host molecule. Stripping of amino acids was alsoaccomplished by contacting the organic solution with a fresh acidic solution. Basedon slope and Job method analyses, it was confirmed that the calix[6]arene formsa 1 : 1 complex with the amino acid ester. The structure of the complex between the calix[6]arene and the amino acid was investigated by ¹H-NMR and CD spectra. The calix[6]arene includes a guest molecule in the cavity, and the inclusion induces the asymmetrization of the host molecule. This host compound functions as a novel recognition tool for amino acids.     

Synthesis of novel chitosan resin derivatized with serine moiety for the column collection/concentration of uranium and the determination of uranium by ICP-MS

A chitosan resin derivatized with serine moiety (serine-type chitosan) was newly developed by using the cross-linked chitosan as a base material. The adsorption behavior of trace amounts of metal ions on the serine-type chitosan resin was systematically examined by packing it in a mini-column, passing a metal solution through it and measuring metal ions in the effluent by ICP-MS. The resin could adsorb a number of metal cations at pH from neutral to alkaline region, and several oxoanionic metals at acidic pH region by an anion exchange mechanism. Uranium and Cu could be adsorbed selectively at pH from acidic to alkaline region by a chelating mechanism; U could be adsorbed quantitatively even at pH 3–4. Uranium adsorbed on the resin was easily eluted with 1 M nitric acid: the preconcentration (5-, 10-, 50- and 100-fold) of U was possible. The column treatment method was used prior to the ICP-MS measurement of U in natural river, sea and tap waters; R.S.D. were 2.63, 1.13 and 1.37%, respectively. Uranium in tap water could be determined by 10-fold preconcentration: analytical result was 1.46±0.02 ppt. The resin also was applied to the recovery of U in sea water: the recovery tests for artificial and natural sea water were 97.1 and 93.0%, respectively.     

Determination of nitrogen- and phosphorus-containing pesticide residues in vegetables by gas chromatography with nitrogen-phosphorus and flame photometric detection after gel permeation chromatography and a two-step minicolumn cleanup

An efficient and reliable multiresidue method for determining pesticide residues in a large number of vegetable samples was studied. First, the important target compounds for monitoring, 52 nitrogen- and/or phosphorus-containing pesticides, were selected. The sample was extracted with acetonitrile, and the separated acetonitrile layer was cleaned up by a salting-out step. The acetonitrile extract was purified by gel permeation chromatography that divided the pesticide eluate into 2 fractions; the pesticide fractions were respectively purified by a 2-step minicolumn cleanup in which the second pesticide fraction was loaded on a silica-gel minicolumn. After a Florisil minicolumn was inserted on the silica-gel minicolumn, the first pesticide fraction was loaded on the tandem minicolumn, which was eluted with acetone-petroleum ether (3 + 7). The combined eluate was subjected to dual-column gas chromatography (GC) with nitrogen-phosphorus and flame photometric detection. By application of the optimum cleanup conditions to the 52 pesticides selected, good resolution and low breakdown levels of the pesticides during GC were maintained. Recoveries of the 52 pesticides from fortified cabbage, lettuce, spring onion, and spinach ranged from 72 to 108% with relative standard deviations of 2-17%, except for the recoveries of methamidophos and chlorothalonil. The detection limits of the pesticides were satisfactory (0.001-0.009 mg/kg) for monitoring pesticide residues in vegetables.     

Monitoring the removal of carbonate from alkali metal hydroxide solutions using gas diffusion flow injection

Monitoring the removal of carbonate from alkali metal hydroxide (MOH, M = K, Na) solutions with calcium oxide (CaO) was studied using a newly developed method for the determination of trace amounts of total carbonate (TC) in alkaline solutions based on a flow injection (FI) technique coupled with a gas diffusion system. The optimized conditions of the FI system were as follows: the flow rate of each carrier, reaction solution (H2SO4) and receptor solution (Cresol Red, pH 8.9) was 0.25 ml min(-1), the sample size was 0.1 ml and the concentration of H2SO4 in the reaction solution was 0.09 M. The limit of detection of TC by the proposed method was 4 x 10(-7) M. The removal efficiency of carbonate was affected by the amount of CaO added, the shaking time of the solutions and the concentration of MOH. For 1 M NaOH and KOH solution, the removal efficiency of carbonate was about 99% and the concentration of residual carbonate was 4 x 10(-5) and 1.2 X 10(-4) M, respectively, when the amount of CaO added was 2 g l(-1) and the shaking time was 16 h.     

Structural difference between a superconducting sodium cobalt oxide and its related phase

Monolayer hydrate (MLH) Na_xCoO₂·y′H₂O was obtained from superconducting bilayer hydrate (BLH) Na_xCoO₂·yH₂O by partial extraction of H₂O molecules between the CoO₂ layers. Magnetization measurements indicated that electron densities in the CoO₂ layer of the MLH phase remained unchanged after the water extraction. Nevertheless, superconductivity was completely suppressed in the MLH phase. This strongly suggests that the highly 2D nature in the BLH phase due to its thick insulating layers consisting of H₂O molecules and Na⁺ ions plays an important role for inducing superconductivity.     

Selective extraction of gallium from aluminum and indium using tripod phenolic ligands

Solvent extraction of trivalent group 13 metal cations such as aluminum, gallium and indium with tripod quadridentate phenolic ligand, tris(2-hydroxy-3,5-dimethylbenzyl)amine (H(3)tdmba), was investigated as fundamental study for their mutual separation. Gallium was extracted almost quantitatively as Ga(tdmba) (logK(ex)=-6.66+/-0.06 on using chloroform as extraction solvent), whereas aluminum and indium were hardly extracted due to steric hindrance on complexation of them with the ligand. The extracted Ga species was estimated as trigonal bipyramidal complex with one H(2)O molecule. Furthermore, extractability of Ga was increased by changing the ligand to more acidic tris(5-chloro-2-hydroxy-3-methylbenzyl)amine (H(3)tcmba) (logK(ex)=-6.18+/-0.18 on using dichloroethane as extraction solvent).     

Analysis of organotin compounds by grignard derivatization and gas chromatography-ion trap tandem mass spectrometry

The determination of organotin compounds in water using gas chromatography-tandem mass spectrometry (GC-MS-MS) is described. Several organotin derivatives were synthesized by the reaction of organotin chlorides with Grignard reagents such as methyl-, propyl- and pentylmagnesium halides. After the optimization of the GC-MS-MS conditions, several derivatizations with the Grignard reagents were compared by evaluating the molar responses and volatilities of the derivatives and derivatization yields. As a result, the derivatizing reagent of choice is pentylmagnesium bromide. Calibration curves for the mono-, di- and tributyltins and mono-, di- and triphenyltins with pentylmagnesium bromide were linear in the range of 0.5-100 pg of Sn. The instrumental detection limits of six organotins ranged from 0.20 to 0.35 pg of Sn. The recovery tests from water samples (500 ml) were performed by using sodium diethyldithiocarbamate (DDTC) as a complexing reagent. Except for monophenyltin, the absolute recoveries of organotins from pure water at 200 ng of Sn/l were satisfactory. The recoveries calibrated by surrogate compounds (perdeuterated organotin chlorides) ranged from 71 to 109%. The method detection limits ranged from 0.26 to 0.84 pg of Sn (500-ml sample). This method was applied to the recovery of organotins from river water and seawater. The calibrated recoveries were between 90 and 122%.