Quantitative analysis of polybrominated diphenyl ethers in adipose tissue, human serum and foodstuff samples by gas chromatography with ion trap tandem mass spectrometry and isotope dilution

A method based on gas chromatography (GC) separation followed by ion trap tandem mass spectrometry detection in EI mode (ITD-MS/MS), using isotope dilution, was developed for the determination of ten native polybrominated diphenyl ethers (PBDEs) and four (13)C(12)-labeled congeners in biological (fat tissue and human serum) and food samples. The highest-mass fragment ions were used as precursor ions for those congeners with molecular ions with m/z values higher than the maximum of the instrument. In these cases (hepta-BDEs and (13)C(12)-hexa-BDEs) no fragmentation was achieved under the experimental conditions employed. Repeatability (lower than 9%) and reproducibility (lower than 13%), expressed as relative standard deviation (RSD, n = 3 and 4, respectively), were satisfactory. Similarly, the coefficient of variation (n = 4) of the isotopic ratio between the two most abundant product ions was lower than 10 and 6% for native and labeled congeners, respectively. To evaluate the feasibility of the method, the optimized isotope dilution GC/ITD-MS/MS method was used for the quantitation of selected PBDE congeners in different samples including adipose tissue, human serum and foodstuff samples, from three inter-laboratory comparative exercises, covering a wide range of concentrations. A solid-phase extraction procedure, previously developed for PCB determination in small-size bird serum samples, was successfully applied to quantification of PBDEs in 1 mL samples of human serum.     

Robust regression techniques A useful alternative for the detection of outlier data in chemical analysis

The validation of an analytical procedure means the evaluation of some performance criteria such as accuracy, sensitivity, linear range, capability of detection, selectivity, calibration curve, etc. This implies the use of different statistical methodologies, some of them related with statistical regression techniques, which may be robust or not. The presence of outlier data has a significant effect on the determination of sensitivity, linear range or capability of detection amongst others, when these figures of merit are evaluated with non-robust methodologies.In this paper some of the robust methods used for calibration in analytical chemistry are reviewed: the Huber M-estimator; the Andrews, Tukey and Welsh GM-estimators; the fuzzy estimators; the constrained M-estimators, CM; the least trimmed squares, LTS. The paper also shows that the mathematical properties of the least median squares (LMS) regression can be of great interest in the detection of outlier data in chemical analysis. A comparative analysis is made of the results obtained by applying these regression methods to synthetic and real data. There is also a review of some applications where this robust regression works in a suitable and simple way that proves very useful to secure an objective detection of outliers. The use of a robust regression is recommended in ISO 5725-5.     

Pesticides and degradation products in groundwaters from a vineyard region: Optimization of a multiresidue method based on SPE and GC‐MS

A reliable multiresidue method based on solid phase extraction was developed using GC–MS to determine and quantify 34 pesticides, including herbicides, fungicides, insecticides, and some of their degradation products, in groundwater in a vineyard region of La Rioja (northern Spain). Different parameters were optimized and good recoveries (65–108% range) and precisions (12–19% range) were achieved with spiked water samples for a concentration of 0.1 μg/L. The experimental results showed an excellent linearity (r² > 0.99) over the 0.1–1.5 μg/L range. The detection limits of the proposed method were 1–37 ng/L for most of the compounds studied. The methodology has been successfully applied to the analysis of groundwater samples from vineyard areas in La Rioja and the presence of pesticides, especially fungicides and herbicides, at several concentration levels was revealed. Terbuthylazine, its metabolite desethyl‐terbuthylazine, and fluometuron were the pesticides most frequently detected in higher concentrations. Overall and taking into consideration the European Union maximum residue limit of pesticides in groundwater, 16 of the 34 compounds included in this study were detected in concentrations over that limit in at least one of the samples analyzed.     

Advantages of a programmed temperature vaporizer inlet and parallel factor analysis in the determination of triazines in the presence of non-intentionally added substances by gas chromatography

Non-intentionally added substances (NIASs) are usually detected by acquiring mass spectra in full scan mode and then identifying the compounds corresponding to the unexpected peaks. High-resolution mass spectrometry detectors are frequently used, but this does not solve the problem that an NIAS can contribute to the abundance at m/z ratios that correspond to the fragmentation of other molecules. This problem leads to false negatives when identifying compounds, even in target analysis when the maximum permitted tolerances for relative ion abundances (SANCO/10684/2009) are taken into account. In this work, the introduction of different volumes of a test sample onto a GC/MS system that has a programmed temperature vaporizer inlet and is operating in full scan mode provides a data tensor. The proposed approach consists of considering the structure of the matrix of abundances of K m/z ratios acquired at J elution times for each chromatographic peak. Upon concatenating I of such matrices, a three-way tensor X is obtained, which is then decomposed using parallel factor analysis into as many factors as there are substances coeluting, thus providing the mass spectrum and the chromatographic profile for each of them. If the amount of an analyte changes significantly during the I injections, then it can be unequivocally identified. This procedure thus identifies coeluting NIASs, provides information about their mass spectra, and guarantees the identification and quantification of target compounds. In this work, it is used to determine five triazines in the presence of NIASs which match some of the m/z ratios of the triazines and coelute with them. Decision limits (CCα) of between 7.5 and 25.0 μg L(-1) were obtained.     

High-directional wave propagation in periodic loss modulated materials

Amplification/attenuation of light waves in artificial materials can become sensitive to the propagation direction by spatially modulating the gain/loss response of the medium on the wavelength scale. We give a numerical proof of the high anisotropy of the gain/loss in two dimensional periodic structures with square and rhombic lattice symmetry by solving the full set of Maxwell's equations using the finite difference time domain method. Anisotropy of amplification/attenuation leads to the narrowing of the angular spectrum of propagating radiation with wavevectors close to the edges of the first Brillouin Zone. The effect provides a novel and useful method to filter out high spatial harmonics from noisy beams.     

Energetics and structural properties, in the gas phase, of trans-hydroxycinnamic acids

We have studied the energetics and structural properties of trans-cinnamic acid (CA), o-, m-, and p-coumaric acids (2-, 3-, and 4-hydroxycinnamic acids), caffeic acid (3,4-dihydroxycinnamic acid), ferulic acid (4-hydroxy-3-methoxycinnamic acid), iso-ferulic acid (3-hydroxy-4-methoxycinnamic acid), and sinapic acid (3,5-dimethoxy-4-hydroxycinnamic acid). The experimental values of Δ(f)H(m)°(g), determined (in kJ·mol(-1)) for CA (-229.8 ± 1.9), p-coumaric acid (-408.0 ± 4.4), caffeic acid (-580.0 ± 5.9), and ferulic acid (-566.4 ± 5.7), allowed us to derive Δ(f)H(m)°(g) of o-coumaric acid (-405.6 ± 4.4), m-coumaric acid (-406.4 ± 4.4), iso-ferulic acid (-565.2 ± 5.7), and sinapic acid (-698.8 ± 4.1). From these values and by use of isodesmic/homodesmotic reactions, we studied the energetic effects of π-donor substituents (-OH and -OCH(3)) in cinnamic acid derivatives and in the respective benzene analogues. Our results indicate that the interaction between -OCH(3) and/or -OH groups in hydroxycinnamic acids takes place without significant influence of the propenoic fragment.     

Quasi-harmonic approximation of thermodynamic properties of ice Ih, II, and III

Several thermodynamic properties of ice Ih, II, and III are studied by a quasi-harmonic approximation and compared to results of quantum path integral and classical simulations. This approximation allows to obtain thermodynamic information at a fraction of the computational cost of standard simulation methods, and at the same time permits studying quantum effects related to zero-point vibrations of the atoms. Specifically, we have studied the crystal volume, bulk modulus, kinetic energy, enthalpy, and heat capacity of the three ice phases as a function of temperature and pressure. The flexible q-TIP4P/F model of water was employed for this study, although the results concerning the capability of the quasi-harmonic approximation are expected to be valid independently of the employed water model. The quasi-harmonic approximation reproduces with reasonable accuracy the results of quantum and classical simulations showing an improved agreement at low temperatures (T< 100 K). This agreement does not deteriorate as a function of pressure as long as it is not too close to the limit of mechanical stability of the ice phases.     

Structural distortion,charge modulation and local anisotropies in magnetite below the Verwey transition using resonant X‐ray scattering

The pattern of charge modulations and local anisotropies below the Verwey transition has been determined and quantified in high‐quality Fe₃O₄ single crystals and thin films grown on MgO by using resonant X‐ray scattering at the Fe K‐edge. The energy, polarization and azimuthal angle dependencies of an extensive set of reflections with potential sensitivity to charge or local anisotropy orderings have been analyzed to explore their origins. A charge disproportion on octahedral B sites of 0.20 ± 0.05 e^? with [0 0 1] and cubic periodicities has been confirmed, while no significant charge disproportion has been obtained with [0 0 1/2] cubic periodicity. Additional charge modulations in the monoclinic a–b plane are also present. In addition, the occurrence of new forbidden (1, 1, 0) and (0, 0, 2n + 1/2) cubic reflections that arise from the anisotropy of the local structure around different tetrahedral and octahedral Fe atoms is shown. This complex pattern of weak charge modulations and local anisotropies is fully compatible with the low‐temperature crystal structure refined in the non‐polar C2/c space group and disproves any bimodal charge disproportion of the octahedral Fe atoms.     

Study of the interface formed between poly(2-methoxy-5-(2′-ethyl-hexyloxyl)-p-phenylene vinylene) and indium tin oxide in top emission organic light emitting diodes

X-ray photoelectron spectroscopy (XPS) technique have been used to investigate the interface formed between poly(2-methoxy-5-(2′-ethyl-hexyloxyl)-p-phenylene vinylene) (MEH-PPV) and indium tin oxide (ITO) layer in top emission organic light emitting diodes. A weak but noticeable diffusion of indium into the polymer film was observed. Interactions between the diffused metallic atoms with the polymer resulted in the formation of carbon-metal complexes at the interface region. Compared to the ITO/MEH-PPV interface, the penetration of indium into the polymer layer was less important and may be explained by the surface morphology of the polymer film. It was however, a probable factor for fast degradation of devices using this structure.