Arraying Cell Cultures Using PEG‐DMA Micromolding in Standard Culture Dishes

A robust and effortless procedure is presented, which allows for the microstructuring of standard cell culture dishes. Cell adhesion and proliferation are controlled by three‐dimensional poly(ethylene glycol)‐dimethacrylate (PEG‐DMA) microstructures. The spacing between microwells can be extended to millimeter size in order to enable the combination with robotic workstations. Cell arrays of microcolonies can be studied under boundary‐free growth conditions by lift‐off of the PEG‐DMA layer in which the growth rate is accessible via the evolution of patch areas. Alternatively, PEG‐DMA stencils can be used as templates for plasma‐induced patterning.

     

Accelerated solvent extraction and pH‐zone‐refining counter‐current chromatographic purification of yunaconitine and 8‐deacetylyunaconitine from Aconitum vilmorinianum Kom

This study aimed to seek an efficient method to extract and purify yunaconitine and 8‐deacetylyunaconitine from Aconitum vilmorinianum Kom. by accelerated solvent extraction combined with pH‐zone‐refining counter‐current chromatography. The major extraction parameters for accelerated solvent extraction were optimized by an orthogonal test design L₉ (3)⁴. Then a separation and purification method was established using pH‐zone‐refining counter‐current chromatography with a two‐phase solvent system composed of petroleum ether/ethyl acetate/methanol/water (5:5:2:8, v/v) with 10 mM triethylamine in the upper phase and 10 mM HCl in the lower phase. From 2 g crude extract, 224 mg of 8‐deacetylyunaconitine (I) and 841 mg of yunaconitine (II) were obtained with a purity of over 98.0%. The chemical structures were identified by ESI‐MS and ¹H and ¹³C NMR spectroscopy.     

Transfection of Mammalian Cells Using Block Copolypeptide Vesicles

An arginine‐leucine block copolypeptide (R₆₀L₂₀) is synthesized, which is capable of forming vesicles with controllable sizes, able to transport hydrophilic cargo across the cell membrane, and exhibit relatively low cytotoxicity. The R₆₀L₂₀ vesicles also possess the ability to deliver DNA into mammalian cells for transfection. Although the transfection efficiency is lower than that of the commercially available transfection agent Lipofectamine 2000, the R₆₀L₂₀ vesicles are able to achieve transfection with significantly lower cytotoxicity and immunogenicity. This behavior is potentially due to its stronger interaction with DNA which subsequently provides better protection against anionic heparin.

     

Low Band Gap Donor‐Acceptor Conjugated Polymer Nanoparticles and their NIR‐mediated Thermal Ablation of Cancer Cells

Low band gap D‐A conjugated PNs consisting of 2‐ethylhexyl cyclopentadithiophene co‐polymerized with 2,1,3‐benzothiadiazole (for nano‐PCPDTBT) or 2,1,3‐benzoselenadiazole (for nano‐PCPDTBSe) have been developed. The PNs are stable in aqueous media and showed no significant toxicity up to 1 mg · mL^?1. Upon exposure to 808 nm light, the PNs generated temperatures above 50 °C. Photothermal ablation studies of the PNs with RKO and HCT116 colorectal cancer cells were performed. At concentrations above 100 µg · mL^?1 for nano‐PCPDTBSe, cell viability was less than 20%, while at concentrations above 62 µg · mL^?1 for nano‐PCPDTBT, cell viability was less than 10%. The results of this work demonstrate that low band gap D‐A conjugated polymers 1) can be formed into nanoparticles that are stable in aqueous media; 2) are non‐toxic until stimulated by IR light and 3) have a high photothermal efficiency.

     

Separation selectivity patterns of fully charged achiral compounds in capillary electrophoresis with a neutral cyclodextrin

Based on the separation selectivity equation, related to the dimensionless parameters for fully charged achiral analytes using a neutral CD, the separation selectivity can be classified into seven patterns. With respect to CZE without CD, the presence of CD in the buffer may improve, or reduce, the separation selectivity with this effect being accompanied by the same or reversed electrophoretic mobility order for charged analytes. This can depend on the separation selectivity of the two analytes in free solution, the binding selectivity, the separation selectivity of analyte–CD complexes and the ratio of electrophoretic mobility of the analytes in free, and complexed forms. Using positional isomers of benzoic acids and phenoxy acids as test analytes and α‐CD as a selector, the observed separation selectivity shapes were found to be in excellent agreement with the predicted separation selectivities.     

Simultaneous determination of chlordiazepoxide and selected antidepressants using CZE

A simple CE method was developed and validated for the simultaneous determination of chlordiazepoxide (CHL), amitriptyline, and nortriptyline (mixture I) or the determination of CHL and imipramine (mixture II) using the same BGE. Sertraline and amitriptyline were used as internal standards for the first and second mixtures, respectively. The method allows amitriptyline to be completely separated from its impurity and main metabolite nortriptyline, which can be quantified from 0.2 μg/mL. The separation was achieved using 20 mM potassium phosphate buffer pH 5 containing 12 mM β‐cyclodextrin and 1 mM carboxymethyl‐β‐cyclodextrin. UV detection was performed at 200 nm and a voltage of 15 kV was applied on an uncoated fused‐silica capillary at 25°C. These experimental conditions allowed separation of the compounds to be obtained in 7 min. Calibration graphs proved the linearity up to 40 μg/mL for CHL, up to 100 μg/mL for amitriptyline and imipramine, and up to 5 μg/mL for nortriptyline. The accuracy and precision of the method have been determined by analyzing synthetic mixtures and pharmaceutical formulations. The analytical results were quite good in all cases indicating that the method was linear, sensitive, precise, accurate, and selective for both mixtures.     

A convenient and sensitive method for haloacetic acid analysis in tap water by on‐line field‐amplified sample‐stacking CE–ESI‐MS

In this study, we propose a simple strategy based on flow injection and field‐amplified sample‐stacking CE–ESI‐MS/MS to analyze haloacetic acids (HAAs) in tap water. Tap water was passed through a desalination cartridge before field‐amplified sample‐stacking CE–ESI‐MS/MS analysis to reduce sample salinity. With this treatment, the signals of the HAAs increased 300‐ to 1400‐fold. The LODs for tap water analysis were in the range of 10 to 100 ng/L, except for the LOD of monochloroacetic acid (1 μg/L in selected‐ion monitoring mode detection). The proposed method is fast, convenient, and sensitive enough to perform on‐line analysis of five HAAs in the tap water of Taipei City. Four HAAs, including trichloroacetic acid, dichloroacetic acid, dibromoacetic acid, and monobromoacetic acid, were detected at concentrations of approximately 1.74, 1.15, 0.16, and 0.15 ppb, respectively.     

Determination of phthalate esters in bottled water using dispersive liquid–liquid microextraction coupled with GC–MS

Dispersive liquid–liquid microextraction method was developed for the determination of the amount of phthalate esters in bottled drinking water samples and dispersive liquid–liquid microextraction samples were analyzed by GC–MS. Various experimental conditions influencing the extraction were optimized. Under the optimized conditions, very good linearity was observed for all analytes in a range between 0.05 and 150 μg/L with coefficient of determination (R²) between 0.995 and 0.999. The LODs based on S/N = 3 were 0.005–0.22 μg/L. The reproducibility of dispersive liquid–liquid microextraction was evaluated. The RSDs were 1.3–5.2% (n = 3). The concentrations of phthalates were determined in bottled samples available in half shell. To understand the leaching profile of these phthalates from bottled water, bottles were exposed to direct sunlight during summer (temperature from 34–57°C) and sampled at different intervals. Result showed that the proposed dispersive liquid–liquid microextraction is suitable for rapid determination of phthalates in bottled water and di‐n‐butyl, butyl benzyl, and bis‐2‐ethylhexyl phthalate compounds leaching from bottles up to 36 h. Thereafter, degradation of phthalates was observed.     

An interesting two‐phase solvent system and its use in preparative isolation of aconitines from aconite roots by counter‐current chromatography

Two‐phase solvent system plays crucial role in successful separation of organic compounds using counter‐current chromatography (CCC). An interesting two‐phase solvent system, composed of chloroform/ethyl acetate/methanol/water, is reported here, in which both phases contain sufficient organic solvents to balance their dissolving capacities. Adjusting the solvent system to get satisfactory partition coefficients (K values) for target compounds becomes relatively simple. This solvent system succeeded in sample preparation of aconitine (8.07 mg, 93.69%), hypaconitine (7.74 mg, 93.17%), mesaconitine (1.95 mg, 94.52%) from raw aconite roots (102.24 mg, crude extract), benzoylmesaconine (34.79 mg, 98.67%) from processed aconite roots (400.01 mg, crude extract), and yunaconitine (253.59 mg, 98.65%) from a crude extract of Aconitum forrestii (326.69 mg, crude extract).