Mott transition from a spin liquid to a Fermi liquid in the spin-frustrated organic conductor kappa-(ET)2Cu2(CN)3

The pressure-temperature phase diagram of the organic Mott insulator kappa-(ET)2Cu2(CN)3, a model system of the spin liquid on triangular lattice, has been investigated by 1H NMR and resistivity measurements. The spin-liquid phase is persistent before the Mott transition to the metal or superconducting phase under pressure. At the Mott transition, the spin fluctuations are rapidly suppressed and the Fermi-liquid features are observed in the temperature dependence of the spin-lattice relaxation rate and resistivity. The characteristic curvature of the Mott boundary in the phase diagram highlights a crucial effect of the spin frustration on the Mott transition.     

Resolving the discrepancy of 135 MeV pd elastic scattering cross sections and relativistic effects

Three precise measurements for elastic pd scattering at 135 MeV/A have been performed with the three different experimental setups. The cross sections are described well by the theoretical predictions based on modern nucleon-nucleon forces combined with three-nucleon forces. Relativistic Faddeev calculations show that relativistic effects are restricted to backward angles. This result supports the two measurements recently reported by RIKEN and contradicts the KVI data.     

Study for noise reduction in synchrotron radiation based scanning tunneling microscopy by developing insulator-coat tip

To solve difficulties of instability and inaccuracy in synchrotron radiation based scanning tunneling microscopy, a method to reduce noise was investigated. New insulator-coat tips were developed to shut out electrons coming from a wide area that damage the spatial resolution. By changing the exposed conductive area at the end of the insulator-coat tips, the effect of noise reduction was estimated. The tip with an exposure area of 50 nm in diameter was found to reduce noise effectively. Also a key discriminating condition was found to obtain the local signal, which is based on the modulation of the X-ray-induced tip current caused by excitation of the specific element.     

Performance Test of CW 300?GHz Gyrotron FU CW I

A 300 GHz CW gyrotron FU CW I has been developed and installed in the Research Center for Development of Far-Infrared Region, University of Fukui as a power source of a high frequency material processing system. Its performance was tested and the maximum power of 1.75 kW / CW has been attained at the beam voltage of 15 kV and the beam current of 1A. The maximum window power efficiency of 15.5% has been obtained at the cathode voltage slightly lower than 15 kV. This gyrotron is designed to deliver a Gaussian beam after mode conversion from the oscillation mode TE_22,8 in the cavity with a complex of an internal radiator and beam shaping mirrors. The detailed measurement with an infrared camera has confirmed that a Gaussian beam is radiated when the magnetic field strength B _c at the cavity is adjusted at a proper value. However, within a range of B _c , the output power is emerged into multiple directions, which suggests simultaneous oscillation of competing cavity modes.     

Energetics and structural stability of Cs3C60

Using the ab initio pseudopotential total-energy method and the density-functional theory, we study the energetics of face-centered-cubic Cs₃C₆₀ which is a material of great interest as a possible high transition-temperature superconductor. At the optimized lattice constant the volume per C₆₀ is found to be smaller than the the most-stable hexagon-coordination A15 phase, while the total energy of the fcc phase is about 0.9 eV higher than the A15 phase. These results indicate that a low-temperature and high-pressure synthesis method might be a possible way to produce the fcc Cs₃C₆₀ phase. In addition, it is also found that the A15 Cs₃C₆₀ should show a phase transformation from a hexagon-coordination phase to a pentagon-coordination phase under hydrostatic pressure.     

Measurement of Cu K-shell and Ag L-shell ionization cross sections by low-energy positron impact

Inner shell ionization cross sections by low-energy positron impact have been measured. Development of an x-ray detector with thin Si(Li) crystals has enabled the first measurements of the absolute cross sections for the positron impacts in the energy range below 30 keV. Threshold behavior of the measured cross sections for the Cu K shell and Ag L shell are compared with the theoretical results of Gryzinski and Kowalski [Phys. Lett. A 183, 196 (1993)]] and Khare and Wadehra [Can. J. Phys. 74, 376 (1996)]]. Good agreement has been found for the Cu K shell, while the experimental values for the Ag L shell were found to be smaller than the corresponding theoretical results.     

Dephasing of a superconducting flux qubit

In order to gain a better understanding of the origin of decoherence in superconducting flux qubits, we have measured the magnetic field dependence of the characteristic energy relaxation time (T(1)) and echo phase relaxation time (T(2)(echo)) near the optimal operating point of a flux qubit. We have measured T(2)(echo) by means of the phase cycling method. At the optimal point, we found the relation T(2)(echo) approximately 2T(1). This means that the echo decay time is limited by the energy relaxation (T(1) process). Moving away from the optimal point, we observe a linear increase of the phase relaxation rate (1/T(2)(echo)) with the applied external magnetic flux. This behavior can be well explained by the influence of magnetic flux noise with a 1/f spectrum on the qubit.     

Measurement of the vector A y and tensor A yy , A xx , A xz analyzing powers for the dd → 3H p reaction at 200 MeV

The data on the vector A _y and tensor A _yy , A _xx , A _xz analyzing powers for the d → ³H p reaction have been obtained at the energy of the initial deuteron of 200MeV in the angular range of 0–95 degrees in the c.m.s. The calculations performed within one-nucleon exchange model with the use of the standard three-nucleon bound state wave functions fail to reproduce the data on the tensor analyzing powers.     

Effects of substrate temperature upon the properties of ZnMgTe layer grown by MOVPE

The effects of substrate temperature upon the optical property, composition and surface morphology have been investigated on nominally undoped Zn_1−xMg_xTe layers grown on (1 0 0) ZnTe substrates by atmospheric pressure metal organic vapor phase epitaxy (MOVPE). It was found that Mg composition increases with decreasing substrate temperature. The result of low temperature photoluminescence (PL) measurement suggests that the optical quality of Zn_1−xMg_xTe layers becomes better with decreasing substrate temperature. On the other hand, there is a narrow range of optimal substrate temperature for a smooth surface morphology. For all the layers, a two-mode behavior with ZnTe- and MgTe-like longitudinal optical phonon modes was confirmed by Raman scattering.