p型金属氧化物半导体场效应晶体管低剂量率辐射损伤增强效应模型研究

对一种非加固4007电路中p型金属氧化物半导体场效应晶体管(PMOSFET)在不同剂量率条件下的电离辐射损伤效应及高剂量率辐照后的退火效应进行了研究. 通过测量不同剂量率条件下PMOSFET的亚阈I-V特性曲线,得到阈值电压漂移量随累积剂量、退火时间的变化关系. 实验发现,此种型号的PMOSFET具有低剂量率辐射损伤增强效应. 通过描述H⁺在氧化层中的输运过程,解释了界面态的形成原因,初步探讨了非加固4007电路中PMOSFET低剂量率辐射损伤增强效应模型. 关键词： p型金属氧化物半导体场效应晶体管 60Co γ射线')" href="#">⁶⁰Co γ射线 电离辐射损伤 低剂量率辐射损伤增强效应     

近红外光谱监测体外循环手术中脑组织氧合状况的研究

体外循环手术中,为防止因脑氧供需失衡导致脑缺氧,就要实时监测患者局部脑组织的氧合状况,以根据其变化调整生理参数或采取应急手段。用该研究小组自行研制的近红外仪器(使用一个双波长的近红外光源和两个近红外检测器)监测心脏手术中患者的脑氧,可以求出局部脑组织血红蛋白浓度的变化,并根据稳态空间分辨光谱(SRS)算法求出局部脑组织的氧饱和度(rSO₂)。体外循环中用监护仪监测患者的混合静脉血氧饱和度(SvO₂)等生理参数。测得的血红蛋白浓度变化容易受到干扰,而rSO₂的抗干扰性能较好。rSO₂在整个手术过程中都可以监测到,而SvO₂只能在体外循环过程中监测到。多数患者rSO₂和SvO₂存在正向相关性,但二者的相关系数并不很高。这是因为SvO₂是大静脉的血氧饱和度,而测得的rSO₂反映局部脑组织的氧合状况,二者的生理意义不同。实验结果表明,体外循环手术中rSO₂可以反映患者脑组织氧合状况的变化,而仅仅监测SvO₂是不够的。     

AlGaN-Based Solar-Blind Schottky Photodetectors Fabricated on AlN/Sapphire Template

We report AlGaN-based back-illuminated solar-blind Schottky-type ultraviolet photodetectors with the cutoff- wavelength from 280nm to 292nm without bias. The devices show low dark current of 2.1× 10^-6A/cm^2 at the reverse bias of 5 V. The specific detectivity D＊ is estimated to be 3.3 × 10^12cmHz^1/2 W^-1 . To guarantee the performance of the photodetectors, the optimization of AlGaN growth and annealing condition for Schottky contacts were performed. The results show that high-temperature annealing method for Ni/Pt Schottky contacts is effective for the reduction of leakage current.     

Chaotic Dynamics of a Josephson Junction with a Ratchet Potential and Current-Modulating Damping

The chaotic dynamics of a Josephson junction with a ratchet potential and current-modulating damping are studied. Under the first-order approximation, we construct the general solution of the first-order equation whose boundedness condition contains the famous Melnikov chaotic criterion. Based on the general solution, the incomputability and unpredictability of the system’s chaotic behavior are discussed. For the case beyond perturbation conditions, the evolution of stroboscopic Poincaré sections shows that the system undergoes a quasi-periodic transition to chaos with an increasing intensity of the rf-current. Through a suitable feedback controlling strategy, the chaos can be effectively suppressed and the intensity of the controller can vary in a large range. It is also found that the current between the two separated superconductors increases monotonously in some specific parameter spaces.     

SINGLE AND DOUBLE EDGE INTERFACE CRACK SOLUTIONS FOR ARBITRARY FORMS OF MATERIAL COMBINATION

In this paper interfacial edge crack problems are considered by the application of the finite element method. The stress intensity factors are accurately determined from the ratio of crack-tip-stress value between the target given unknown and reference problems. The reference problem is chosen to produce the singular stress fields proportional to those of the given unknown problem. Here the original proportional method is improved through utilizing very refined meshes and post-processing technique of linear extrapolation. The results for a double-edge interface crack in a bonded strip are newly obtained and compared with those of a single-edge interface crack for different forms of combination of material. It is found that the stress intensity factors should be compared in the three different zones of relative crack lengths. Different from the case of a cracked homogeneous strip, the results for the double edge interface cracks are found to possibly be bigger than those for a single edge interface crack under the same relative crack length.     

离子色谱法测定护发和皂类产品中羟乙磷酸及其盐类

研究并建立了护发和皂类产品中羟乙磷酸及其盐类的离子色谱测定方法。将护发和皂类样品分散于3mmol/L盐酸中,于振荡器上振摇至完全溶解,护发和皂类样品提取液分别调节pH值至2.5和5.5,依次过尼龙滤膜和OnGuardⅡRP固相萃取柱。滤液采用离子色谱-抑制电导检测法分析测定,以IonPac AS11-HC阴离子交换色谱柱分离,40mmol/L氢氧化钾溶液为淋洗液等度洗脱,ASRS-400阴离子型抑制电导检测,外标法定量。方法的线性范围为0.5～8.0mg/L,相关系数为0.9999,对羟乙磷酸的定量限为0.025%,护发产品在低、中、高3种加标水平的回收率为84.0%～93.5%,相对标准偏差为1.3%～3.0%;皂类产品在低、中、高3种加标水平的回收率为81.4%～92.3%,相对标准偏差为1.8%～5.1%。该法准确、简便、快速,可用于护发和皂类产品的实际检测。     

Tailorable PC71BM Isomers: Using the Most Prevalent Electron Acceptor to Obtain High‐Performance Polymer Solar Cells

Despite being widely used as electron acceptor in polymer solar cells, commercially available PC₇₁BM (phenyl‐C₇₁‐butyric acid methyl ester) usually has a “random” composition of mixed regioisomers or stereoisomers. Here PC₇₁BM has been isolated into three typical isomers, α‐, β₁‐ and β₂‐PC₇₁BM, to establish the isomer‐dependent photovoltaic performance on changing the ternary composition of α‐, β₁‐ and β₂‐PC₇₁BM. Mixing the isomers in a ratio of α/β₁/β₂=8:1:1 resulted in the best power conversion efficiency (PCE) of 7.67 % for the polymer solar cells with PTB7:PC₇₁BM as photoactive layer (PTB7=poly[[4,8‐bis[(2‐ethylhexyl)oxy]benzo[1,2‐b:4,5‐b′]dithiophene‐2,6‐diyl][3‐fluoro‐2‐[(2‐ethylhexyl)carbonyl]thieno[3,4‐b]thiophenediyl]]). The three typical PC₇₁BM isomers, even though sharing similar LUMO energy levels and light absorption, render starkly different photovoltaic performances with average‐performing PCE of 1.28–7.44 % due to diverse self‐aggregation of individual or mixed PC₇₁BM isomers in the otherwise same polymer solar cells.