Multicyclic polyethers derived from 1,1,1‐tris(4‐hydroxyphenyl)ethane and 2,6‐dihalopyridines

Poly(pyridine ether)s were prepared in two ways: the polycondensation of silylated 1,1,1‐tris(4‐hydroxyphenyl)ethane (THPE) with 2,6‐difluoropyridine (method A) and the polycondensation of free THPE with 2,6‐dichloropyridine (method B). With method A, the THPE/difluoropyridine feed ratio was varied from 1.0:1.0 to 1.0:1.6. Cycles, bicycles, and multicycles were the main reaction products, and crosslinking was never observed. When ideal stoichiometry was used exclusively, multicycles free of functional groups were obtained. These multicycles were detectable in matrix‐assisted laser desorption/ionization time‐of‐flight (MALDI‐TOF) mass spectra up to B₃₈C₇₆ with a mass of approximately 32,000 Da. With method B, the reaction conditions were varied at a fixed feed ratio to achieve an optimum for the preparation of multicyclic polyethers, but because of the lower reactivity of 2,6‐dichloropyridine, a quantitative conversion was not achieved. The reaction products were characterized with MALDI‐TOF mass spectrometry, viscosity measurements, and size exclusion chromatography. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5725–5735, 2004     

Differential scanning calorimetry and thermogravimetric analysis investigation of the thermal properties and degradation of some radiation‐grafted films and membranes

The influence of irradiation and grafting on the crystallinity of three base polymers has been investigated with differential scanning calorimetry. Grafting has the largest effect on the base polymer crystallinity and results in a reduction of the crystallinity. The thermal degradation of the base polymers and grafted films has been investigated with thermogravimetric analysis. The extent of the fluorination of the base polymer, the irradiation method, and the graft level all influence the thermal degradation and its activation energy. It is proposed that the variation of the chain lengths of the grafted polystyrene chains is actually a primary underlying factor responsible for the influence of these various parameters on the degradation process. The first results of a comparative thermal analysis of some fuel‐cell membranes are also presented, and the promise and shortcomings of this method are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2612–2624, 2004     

Quantitative electron probe microanalysis for the characterization of thin carbon-boron layers in fusion devices

Summary The first wall of the fusion device TEXTOR at the Forschungszentrum Jülich has been coated in situ with an amorphous hydrogen rich carbon/boron film (a-C/B:H) which reduces plasma impurities caused by the plasma surface interaction. The results of the coating process of the 35 m² large inner wall surface have been controlled by a recently developed modification of the quantitative electron probe microanalysis, which has been applied to 12 samples from specified positions inside the tokamak. The quantification itself is based on a Monte Carlo simulation of electron trajectories providing very accurate results for X-ray intensities emitted by elements present in the electron bombarded sample. The Monte Carlo results are used in the present work to calibrate the measured X-ray intensities emitted by boron and carbon from the a-C/B:H layers deposited on pure silicon substrates. As a result the total deposited mass of the layer per area unit as well as the composition of the layers (except hydrogen) could be determined very accurately. The relative errors were less than 7%. The limit of detectability were found to be in the range of one monolayer for boron as well as for carbon.     

Analysis of semiconducting materials by high-resolution radiofrequency glow discharge mass spectrometry

The analytical capabilities of a high-resolution mass spectrometer in combination with a 13.56 MHz glow discharge ion source for the analysis of semiconducting materials (silicon carbide and gallium arsenide) were studied. It was shown that single positively charged ions of sample material have about 10 eV higher average energy than the ions of the discharge and residual gas. Therefore effective energy separation of the ions of analyte from the ions of the discharge and residual gas was achieved by adjusting the ion transfer optics (breadth and position of energy slit), which improves the analytical capabilities of the developed method.Some analytical applications are presented to illustrate the performance of r.f. GDMS for the bulk analysis of semiconducting materials. The results of the trace element analysis of gallium arsenide and silicon carbide samples are compared with data of independent methods (LIMS, ICP-AES, SIMS).Dedicated to Professor Dr. rer. nat. Dr. h.c. Hubertus Nickel on the occasion of his 65th birthdayOn leave from the Institute of Inorganic Chemistry, 630090 Novosibirsk, Russia     

Banach spaces of distributions having two module structures

After a discussion of a space of test functions and the corresponding space of distributions, a family of Banach spaces (B, ∥ ∥_B) in standard situation is described. These are spaces of distributions having a pointwise module structure and also a module structure with respect to convolution. The main results concern relations between the different spaces associated to B established by means of well-known methods from the theory of Banach modules, among them B₀ and $\text{B}\text{?}$, the closure of the test functions in B and the weak relative completion of B, respectively. The latter is shown to be always a dual Banach space. The main diagram, given in Theorem 4.7, gives full information concerning inclusions between these spaces, showing also a complete symmetry. A great number of corresponding formulas is established. How they can be applied is indicated by selected examples, in particular by certain Segal algebras and the A_p-algebras of Herz. Various further applications are to be given elsewhere.     

Jetmetriken und hyperbolische Geometrie

Ohne ZusammenfassungHerrn E. Heinz zum 65. Geburtstag gewidmet