FeS2多晶薄膜电子结构的实验研究

用磁控溅射方法制各纯Fe薄膜,并硫化合成FeS2.采用同步辐射X射线近边吸收谱与X射线光电子能谱研究了薄膜的电子结构.结果表明,合成的FeS2薄膜,在费米能级附近,有较强的Fe 3d态密度存在,同时,在价带谱中2-10eV处有强度较大的S 3p态密度存在;Fe的3d轨道在八面体配位场作用下分别为t2g和eg轨道,实验中由Fe的吸收谱计算得到两分裂能级之差为2.1eV;实验测得FeS2价带结构中导带宽度约为2.4eV,导带上方仍存在第二能隙,其宽度约为2.8eV.     

SiOx纳米管的制备及其发光特性

以液态金属镓为媒介,利用热蒸发法合成大量非晶SiOx纳米管,这些纳米管管径均匀分布,平均约80 nm,长度大于10μm,且管内外径比例较小．分析发现,在实验过程中,熔入金属镓液滴中的硅元素和氧元素结合并从液滴的表面饱和析出,形成以镓为中心的非晶SiOx纳米管状结构．在室温中,利用260 nm的激发光源激发SiOx纳米管,发现在蓝光波段附近发出强而稳定的PL谱线,这可能与样品中的氧缺陷和空位有关．     

空气/水界面水分子的取向和运动

对四种不同的实验构型下空气／水界面自由O-H键在3700cm~(-1)的和频振动光谱的分析表明,水分子在空气／水界面的取向运动只可能是在平衡位置附近有限角度之内的受限转动。界面水分子的自由O-H键取向距界面法线约33°,而取向分布或运动的宽度不超过15°。这一图像显著地不同于Wei等人(Phys. Rev. Lett.86,4799(2001))只通过单一的SFG实验构型所得出结论,即：空气／水界面的水分子在超快的振动弛豫时间内在很大的角度范围内运动。     

用自适应脉冲微扰引导混沌系统到周期解

用自适应脉冲微扰方法控制的系统的某个系统变量作为驱动,设计了一种自适应控制器方法对两个或多个响应混沌系统进行脉冲微扰,引导这些系统从混沌运动到低周期运动,实现同时控制多个混沌系统到不同的周期态. 当选择相同的自适应控制器输入变量实施脉冲微扰时,还可控制两个或多个混沌系统达到不同的周期态同步. 通过对R?ssler混沌系统的仿真研究证实了方法的有效性. 关键词： 混沌控制 系统参量 自适应控制器 脉冲微扰 周期态同步     

提高微晶硅薄膜太阳电池效率的研究

采用甚高频等离子体增强化学气相沉积技术制备了系列微晶硅薄膜太阳电池，指出了气体总流量和背反射电极的类型对电池性能参数的影响.电池的I-V测试结果表明：随反应气体总流量的增加，对应电池的短路电流密度、开路电压和填充因子都有很大程度的提高，结果使得电池的光电转换效率得以提高.另外，ZnO/Ag/Al背反射电极能明显提高电池的短路电流密度，进而也提高了电池的光电转换效率.对气体总流量和背反射电极类型影响电池效率的原因进行了分析. 关键词： 微晶硅薄膜太阳电池 气体流量 ZnO/Ag/Al背反射电极     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

一类高次系统极限环的存在与唯一性

本文对系统dxdt=-y(1-ax2n)(1-bx2n) δx-lx4n 1dydt=x2n-1(1-cx2n)(1-bx2n)进行定性分析,得出其极限环的存在性,不存在性及唯一性的一系列充分条件.     

The application of a vehicle routing model to a waste-collection problem: two case studies

In this paper we suggest a unique model for estimating the operating cost of each of three waste-collection systems. Under the traditional system, which is widely used, waste is typically collected in plastic bags and a three-man crew is needed on each vehicle. The other two systems require a one-man crew for vehicle collecting street containers. The side-loader system with fixed body automatically empties street containers into the vehicle body and empties the load at the disposal site. The side-loader system with demountable body allows the separation of the waste collection phase from transport to the disposal site, since the vehicle body can be demounted. We also present two case studies and show how the estimation of operating costs is a critical issue in decisions regarding the type of system to be used for waste collection.     

Calibrating software reliability models when the test environment does not match the user environment

Software failures have become the major factor that brings the system down or causes a degradation in the quality of service. For many applications, estimating the software failure rate from a user's perspective helps the development team evaluate the reliability of the software and determine the release time properly. Traditionally, software reliability growth models are applied to system test data with the hope of estimating the software failure rate in the field. Given the aggressive nature by which the software is exercised during system test, as well as unavoidable differences between the test environment and the field environment, the resulting estimate of the failure rate will not typically reflect the user‐perceived failure rate in the field. The goal of this work is to quantify the mismatch between the system test environment and the field environment. A calibration factor is proposed to map the failure rate estimated from the system test data to the failure rate that will be observed in the field. Non‐homogeneous Poisson process models are utilized to estimate the software failure rate in both the system test phase and the field. For projects that have only system test data, use of the calibration factor provides an estimate of the field failure rate that would otherwise be unavailable. For projects that have both system test data and previous field data, the calibration factor can be explicitly evaluated and used to estimate the field failure rate of future releases as their system test data becomes available. Copyright © 2002 John Wiley & Sons, Ltd.     

The study and applications of photochemical-dynamical gravity wave model II

A nonlinear, compressible, non-isothermal gravity wave model that involves photochemistry is used to study the effects of gravity wave on atmospheric chemical species distributions in this paper. The changes in the distributions of oxygen compound and hydrogen compound density induced by gravity wave propagation are simulated. The results indicate that when a gravity wave propagates through a mesopause region, even if it does not break, it can influence the background distributions of chemical species. The effect of gravity wave on chemical species at night is larger than in daytime.