Monitoring of safety features,fissile material accumulation and concentration in nuclear reprocessing by active and passive neutron counting techniques

The application, the advantage and limits of neutron monitoring techniques, such as Hf-monitors, fissile material accumulation and concentration monitors are being discussed. The active neutron counting technique applied to emptied pulsed extraction columns containing Hf-sieve plates allows conclusive answers as to the position of the plates in the columns. Pu-accumulations on Hf-sieve plates in pulsed extraction columns can be estimated within a factor of two, whereby the detection limit is about equal to or less than 1 g Pu/plate. Fissile material concentration changes of 1.1 g/l can be detected in the case of²³⁵U in solution and of 0.4 Pu/l if a²³⁹Pu/²⁴⁰Pu ratio of 4 to 1 is assumed.     

Induced smectic C* phases

Induced ferroelectric S*_C phases are formed by non-chiral S_C host phases doped with chiral dipolar guest molecules. In those mixtures the spontaneous polarization P_s and the tilt angle Θ has been investigated as a function of the mole fraction x_G of the chiral dopant. In most cases the reduced polarization P₀ = P_S/ sin Θ has been found to depend linearly on x_G. The polarization power which is defined by δ_P=(∂P₀/∂x_G)ΔT is discussed in terms of the molecular structure of the chiral dopants. There are systems in which P₀(x_G) deviates positively from linearity. This behaviour can be understood by considering a local field correction to P₀. By assuming a local field of Lorentz type a theoretical relation for P₀(x_G) has been derived which explains the experimental results. The effect of a local field is considerable if the transverse dipole moment and the polarizability of the chiral dopant are large.     

On a new class of function systems of Faber-Schauder type

In this paper, we introduce a new class of function systems generalizing the classical Faber-Schauder system. Under the condition that the generating sequence is bounded, we show that systems of such a class constitute bases in the space of continuous functions and prove some properties of series expansions of functions in these systems.     

Mg 2p shallow core-level and local atomic structure of i-ZnMgRE quasicrystals

We present a detailed analysis of the Mg 2p shallow core-levels measured on icosahedral single-grain ZnMgY, ZnMgHo, and ZnMgEr quasicrystals during a photoelectron microscopy study. The synchrotron radiation photoemission measurements were performed on in situ cleaved samples at a pressure of 10⁻¹⁰ mbar and at low temperature, typically 90-150 K. The Mg 2p photoemission lines are essentially broadened as compared to those of the Mg 2p spin-orbit doublet recorded on the Zn₂Mg crystalline Laves phase. The broadening is associated to the coordination shifts of the Mg 2p level due to the inequivalent magnesium sites in the quasicrystalline lattice. The coordination shifts are calculated on the basis of i-ZnMg(Ho, Y) atomic structure data, recently determined from the pair distribution function analysis. The coordination shifts obtained are up to 0.2 eV. The Mg 2p experimental spectral intensity is nicely reproduced by a superposition of coordination-shifted Mg 2p spin-orbit doublets.     

AUTOMATED WIND TUNNEL MEASUREMENTS

It is common practice in power transmission to use bundled overhead electrical conductors because the lower rate of corona discharge, compared with single conductors, makes the bundle attractive for high voltages. However, secondary problems may arise from the vibrations induced by the aerodynamic forces which act on the leeward conductors as a result of their immersion in the wake of a windward conductor. Thus, in addition to possible aeolian and galloping oscillations observed for a single conductor, bundle conductors may also be subjected to wake-induced oscillations. ^1,2 Although extensive research has been done on the aeroelastic behavior of single and bundled conductors which are bare, little is known about the galloping or wake oscillation characteristics of given bundle conductors which, depending upon the environmental conditions during the formation of ice, may have five or so representative shaped cross-sections. One important task involves the aerodynamic quasi-static force and moment measurements in a wind tunnel using full scale conductor cross-sections each of which must be rotated through many angles at different spacings. Such measurements are repetitive as well as tediously time consuming and, hence, are beneficially automated. A reliable, accurate and inexpensive automated apparatus is described in this paper which permits the aerodynamic measurements to be performed efficiently and without intervention. Most importantly, it relieves the operator of the usual responsibility for manually controlling the separation and orientation of the sections as well as the need to manually compensate fluctuations in the free stream air speed. For simplicity, the apparatus is detailed in the context of a twin bundle conductor.