挤压-堆积复合法制备As2S3红外硫系玻璃光子 晶体光纤及其特性研究

在利用多极法优化设计光子晶体光纤结构的基础上, 充分结合挤压和堆积两种方法的优点, 提出了基于挤压-堆积的新型硫系光子晶体光纤制备技术, 利用As2S3硫系玻璃制备了三层孔环结构光子晶体光纤. 通过理论模拟分析得出了该光纤的色散特性和零色散点, 测试了1550nm近红外光纤激光在该光纤中的传输效果和纤芯光斑能量分布, 利用该光斑测试验证了该光纤在近红外的光能传输局部限制能力和光子晶体的光学初步控制现象.     

Diffraction inhibition in two-dimensional photonic crystals

We show the existence of flat equal-frequency contour across the entire first Brillouin zone in two-dimensional photonic crystals. Under this condition, light diffraction can be inhibited. Moreover, the beam can be highly localized between two neighboring rows of the defect-free photonic crystal. Such a finding may have novel applications in light beam manipulations and on-chip integrated photonic devices.     

Image reconstruction tomography with only a method for laminar optical single Monte-Carlo simulation

Laminar optical tomography （LOT） is a new mesoscopic functional optical imaging technique. Currently, the forward problem of LOT image reconstruction is generally solved on the basis of Monte-Carlo （MC） methods. However, considering the nonlinear nature of the image reconstruction in LOT with the increasing number of source positions, methods based on MC take too much computation time. This letter develops a fast image reconstruction algorithm based on perturbation MC （pMC） for reconstructing the absorption or scattering image of a slab medium, which is suitable for LOT or other functional optical tomography system with narrow source-detector separation and dense sampling. To calculate the pMC parameters, i.e., the path length passed by a photon and the collision numbers experienced in each voxel with only one baseline MC simulation, we propose a scheme named as the trajectory translation and target voxel regression （TT＆TVR） based on the reciprocity principle. To further speed up the image reconstruction procedure, the weighted average of the pMC parameters for all survival photons is adopted and the region of interest （ROI） is extracted from the raw data to save as the prior information of the image reconstruction. The method is applied to the absorption reconstruction of the layered inhomogeneous media. Results demonstrate that the reconstructing time is less than 20 s with the X - Y section of the sample subdivided into 50 × 50 voxels, and the target size quantitativeness ratio can be obtained in a satisfying accuracy in the source-detector separations of 0.4 and 1.25 mm, respectively.     

γ辐射引发淀粉目由基衰减的动力学研究

用ESR方法研究了红薯淀粉在y射线预辐照下,产生的淀粉自由基特性及其室温下的自由基衰减动力学反应。结果表明在室温条件下,淀粉自由基的相对浓度随辐射剂量的增大而增加。自由基相对浓度的室温衰减用二级反应动力学处理,求得了衰减速率常数和淀粉自由基反应的半衰期。     

可接入射频半实物的试验数据转换系统设计与实现

试验环节是产品研制生命周期中的重要环节,但是一直以来都缺乏有效的管理手段,在整个测试阶段都存在大量的人为的、重复性的工作,导致试验效率低下,为改善这一现状,提高试验效率,提出了一种基于PXIe数据采集系统,借助LabVIEW和DIAdem软件的测试系统解决方案：以LabVIEW控制数据高速同步采集,DIAdem调用LabVIEW模块执行算法分析,通过软件集成,实现对测试系统的全面管理,包括数据采集、数据检索、数据分析、报表生成及整个流程的自动化控制。本文以C919飞机电源测试系统为介绍对象,对该套测试系统解决方案进行阐述,实际测试情况表明,在数据吞吐率大于200M/S的情况下,相对传统测试方法,该测试方案在保证测试精度的基础上,极大的提高了试验效率,极大的提高了系统的可扩展性和可维护性。     

基于包层模的光纤布拉格光栅折射率传感特性

提出了基于光纤布拉格光栅(FBG)包层模式的折射率传感方案。实验中,利用不同浓度的丙三醇水溶液作为外界折射率传感溶液,采用氢氟酸溶液化学腐蚀的方法来减小光纤包层的直径以增大包层模式对外界折射率的敏感度,研究了腐蚀后光纤布拉格光栅包层模式的耦合波长对外部折射率的变化关系。实验结果表明在1.3300~1.4584的折射率范围内,包层模式耦合波长随外界折射率增大而增大,在接近光纤包层折射率处具有很高的折射率灵敏度,最大达到了172 nm/riu(refractive index unit)。而且,包层模谐振的光谱半峰全宽(约0.07 nm)仅为布拉格纤芯模谐振光谱半峰全宽的1/4,能够获得更好的传感精度。     

A high sensitivity spectrometer with tunable diode laser for ambient methane monitoring

Tunable diode laser absorption spectroscopy (TDLAS) has been widely employed in atmospheric trace gases detection. In the measurement of these trace gases, harmonic detection combined with a multi-pass white cell could remarkably enhance the detection sensitivity. In this paper, a portable TDLAS system built specifically for long time monitoring methane in the atmosphere is introduced. The detection limit is below 100 ppb that is enough for the monitoring of ambient methane, and the long time monitoring results obtained in Beijing are given, which is well coincident with that of the Fourier transform infrared (FTIR) spectroscopy.