Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

应力对La0.83Sr0.17MnO3薄膜输运性能的影响

采用溶胶-凝胶方法在Si(111)上制备了LSMO(x=0.17)薄膜.研究了块体材料和不同厚度薄膜R -T曲线、红外光谱和X射线衍射.结果表明，LSMO薄膜属于正交晶体结构，薄膜取向与膜厚度 有关，当膜厚度为450nm或680nm时，主要取向〈200〉，而膜厚度为900nm时取向为〈020〉 ：根据离子对相互作用能和谐振子模型，得到了红外吸收与Mn—O—Mn键长和键角关系式，6 00cm^-1附近红外吸收与晶格常数b的变化有关；块体与薄膜的金属—绝缘体转变 温度(T_MI)存在较大差别，薄膜转变温度显著低于块体，并与厚度有一定关系. 认为是LSMO薄膜中的应力诱导了晶格常数变化，引起键角改变及JT效应是转变温度变化的主 要原因. 关键词： 单晶硅 晶格常数 金属—绝缘体转变温度 应力诱导     

电沉积富铁Fe-Ni合金箔工艺的研究

对硫酸盐-氯化物电解液中电沉积富铁Fe-Ni合金箔的工艺进行了研究,讨论了电解液组成、电流密度、温度及pH值等因素与合金箔组成之间的相互关系,得到了制备富铁合金箔的最佳镀液组成及工艺条件,并通过实验确定在阴阳极比为1:2时,镍铁联合阳极配比为1.5:1.通过扫描电镜,能谱和X-衍射对富铁Fe-Ni合金箔的形貌及结构进行分析表明合金箔晶粒细致,尺寸均匀,结构紧密,表面光滑平整,无孔洞和裂纹,晶粒结构为(111),(200),(311)及(222)织构,并表现为较强的(111)择优取向.     

穿过液膜的自发电势振荡

An artificial membrane consisting of pricramic acid in nitrobenzene was used as an oil phase imposed between two aqueous phases. The right one contained trimethyl-slearylammonium chloride and aicohol; and the left contained sucrose solution (or H_2O). We found that this system exhibited rhythmic oscillation of electrical potential. The amplitude of the oscillations was between 20—150 mV. The oscillations were observed even when ethyl alcohol was absent in the aqueous of trimethylslearylammonium Chloride, and the increase in amplitude of oscillation with time was found to be less in the presence of sucrose. Some of the expremental results have been explained.     

SUPER TOUGH GELS WITH A DOUBLE NETWORK STRUCTURE

 Living tissues work with fantastic functions in soft and wet gel-like state. Thus, hydrogels have attracted much attention as excellent soft & wet materials, suitable for making artificial organs for medical treatments.However, conventional hydrogels are mechanically too weak for practical uses. We have created double network (DN) hydrogels with extremely high mechanical strength in order to overcome this problem. DN gels are interpenetrating network (IPN) hydrogels consisting of rigid polyelectrolyte and soft neutral polymer. Their excellent mechanical properties cannot be explained by the standard fracture theories. In this paper, we discuss about the toughening mechanism of DN gels in accordance with their characteristic behavior, such as large hysteresis and necking phenomenon. We also describe the results on tissue engineering application of DN gels.     

Synthesis of monodisperse poly(chloromethylstyrene-co-divinylbenzene) beads and their application in separation of biopolymers

The monodisperse, porous poly(chloromethylstyrene-co-divinylbenzene) beads of 7.9 microm were prepared by a single-step swelling and polymerization method. The seed particles prepared by dispersion polymerization exhibited good absorption of the monomer phase. Based on this media, a weak cation-exchange (WCX) stationary phase for HPLC was synthesized by a new chemically modified method. The prepared resin has advantages of biopolymer separation, high column efficiency, low column backpressure, high protein mass recovery, and good resolution for proteins. The dynamic protein-loading capacity of the synthesized WCX packings was 18.2 mg/g. Five proteins were separated in 3.0 min using the synthesized WCX stationary phase. The experimental results show that the obtained WCX resin has very weak hydrophobicity. The WCX resin was also used for the rapid separation and purification of lysozyme from egg white in 5.0 min with only one step. The purity and specific bioactivity of the purified lysozyme were found to be more than 93% and 70 245 U/mg, respectively.     

合成1，3－二（3－羟丙基）四甲基二硅氧烷的新方法

用二乙氧基二甲基硅烷与３－氯丙醇反应，合成了新化合物３－氯丙氧基乙氧基二甲基硅烷，然后用格氏反应代替Ｗａｌｔｅｒ的钠缩合反应，最后经水解制备了１，３－二（３－羟丙基）四甲基二硅氧烷，总收率为４２．０％。     

Synthesis of polypiperazine-amide thin-film membrane on PPESK hollow fiber UF membrane

A new interfacial polymerization (IP) procedure is developed in order to synthesize polypiperazine-amide thin-film membrane on the inner surface of poly(phthalazinone ether sulfone ketone) (PPESK) hollow fiber ultrafiltration (UF) membrane.A hollow fiber composite membrane with good performance was prepared and studied by FT-IR and scanning electron microscopy.     

胍类化合物的合成进展

胍类化合物是精氨酸残体的一部分，它在具有生物活性的蛋白质、肽中起着重要作用，从天然产物分离得到的胍类化合物大部分具有生理活性，如抗病毒、抗肿瘤、抗艾滋病等。所以，在温和条件下高产率的合成胍类化合物显得非常重要。本文综述了胍类化合物的合成进展。参考文献32篇。     

助剂对Cu/Cr催化剂上甲醇部分氧化制氢的活性影响

曾研究了Cu/Cr二元催化剂上甲醇部分氧化制氢的反应，发现当Cu/Cr比为6：4时，催化剂的Cu^0比表面积最大，呈现出较好的活性。在Cu/Cr（6：4）催化剂中添加Fe,Zn,Al等8种助剂，考察其对甲醇部分氧化制氢催化性能的影响，并着重研究了Zn助剂的作用。实验结果表明，Zn的引入，有利于催化剂活性的提高。当Zn含量为10％时，催化剂活性最好。XRD表征结果表明，Cu/Cr催化剂的失活与其表面上的Cu物种烧结有关，Zn的引入可明显增强Cu/Cr（6：4）催化剂的热稳定性，提高其寿命。