Optimization of a Cryogenic System at Temperature 2 K for the PKU-FEL Facility

The conceptual design of a cryogenic system at temperature 2 K for the Peking University Free Electron Laser （PKU-FEL） facility is carried out. In order to minimize the scale of the cryogenic system and the running cost, the superconducting accelerator and the superconducting injector will mainly run at a long-pulsed mode. Optimization of the 2-K cryogenic system is carried out based on the heat load estimation and running parameters. Total cooling power of 52.5 W for the long-pulsed mode is necessary for the PKU cryogenic system. The PKU cryogenic system will be the first 2-K system for accelerators in China and will provide experience for similar facilities.     

Controlling the surface buckling wrinkles by patterning the material system of hard-nano-film/soft-matter-substrate

Wrinkling and buckling of nano-films on the compliant substrate are always induced due to thermal deformation mismatch.This paper proposes effective means to control the surface wrinkling of thin film on the compliant substrate,which exploits the curvatures of the curve cracks designed on the stiff film.The procedures of the method are summarized as:1)curve patterns are fabricated on the surface of PDMS(Polydimethylsiloxane)substrate and then the aluminum film with the thickness of several hundred nano-meters is deposited on the substrate;2)the curve patterns are transferred onto the aluminum film and lead to cracking of the film along the curves.The cracking redistributes the stress in the compressed film on the substrate;3)on the concave side of the curve,the wrinkling of the film surface is suppressed to be identified as shielding effect and on the convex side the wrinkling of the film surface is induced to be identified as inductive effect.The shielding and inductive effects make the dis-ordered wrinkling and buckling controllable.This phenomenon provides a potential application in the fabrication of flexible electronic devices.     

环境光对谷氨酸钠溶液激光拉曼光谱的影响

探讨了环境光的存在,对谷氨酸钠溶液的激光拉曼光谱的影响。研究表明,不同的环境光,自然光和室内荧光灯光,会对拉曼光谱产生不同的干扰效应,存在着特征谱峰、负峰或尖锐正峰, 干扰的影响不能忽略。建议在进行溶液激光拉曼光谱检测时,需在暗室或暗罩中进行,以完全隔离环境光的影响。     

用偏光织构及透射光谱分析液晶器件的老化

对一组台式计算器液晶显示器进行了光辐照,研究了光辐照对液晶显示器件显示品质的影响。采用偏光显微镜观察到了辐照后液晶的偏光织构的变化,液晶中出现了平行的条纹状织构和失去消光作用的黑洞,随着接受光辐照时间的增加,黑洞数量越来越多,面积越来越大。通过由计算机控制的双光束紫外-可见分光光度计测试了透射光谱的变化,发现其透射率随着接受光辐照时间的增加而降低。分析结果表明,条纹状织构和黑洞的出现是由于液晶分子结构在紫外线的照射下发生了变化所致,失去消光作用的黑洞是导致液晶器件透射率持续下降的主要原因。     

对探究影响摩擦力大小因素实验的分析及改进

对传统的影响滑动摩擦力大小因素的实验进行改进,把物块的运动变换成下面木板的运动,并用定滑轮改变拉力的方向.使用改进后的装置不但可以降低操作的难度,还可提高实验的准确性.     

微型同轴脉管制冷机最低制冷温度影响因素的实验研究

本文对微型同轴脉管制冷机最低制冷温度的影响因素进行了实验研究。试验结果表明:在其他运行参数不变的情况下,随着氢浓度的逐渐减少,最低制冷温度也逐渐降低,当氢的摩尔浓度小于20％时,其最低制冷温度和纯氦相差不大。不同的氢氦配比下,该脉管制冷机的最佳运转频率为16.7 Hz。随着系统平均压力的提高,最低制冷温度也随之下降,但变化幅度越来越小。     

谱峰相对强度比法在碳炔含量测定中应用

碳炔材料是一种不溶不熔高聚物 ,红外谱图是最简易的一种分析测试工具。将 C—H键的振动峰面积与 C C键的振动峰面积相关联 ,用谱峰相对强度比法测定不同制备条件下产生的碳炔材料的相对含量。结果表明 ,两者比值对反应物浓度的变化具有相关性 ,可用作碳炔材料制备中实验条件的优选手段。     

STUDY OF OPTICAL PUMPING OF ALKALI ATOMIC BEAM IN STRONG MAGNETIC FIELDS

We have gained a very comprehensive set of results for infrared diffraction (10.6μm wavelength) from fabricated single grooves of reflection with widths in the range of 5μm to 65μm. The experimental results show that the diffraction can still occur when the groove width becomes comparable to or less than the wavelength of the probing light. Variations of the diffraction intensities have a very regular sinusoidal relationship with the polarization angle of the incident light; and the diffraction intensities are the when the incident light is TM polarized. However, the diffraction intensities will be a minimum when the incident light is TE polarized; and the biger the diffraction angle, the higher the rate of change of the diffractive intensity with increasing polarization angle of the incident light.     

单道扫描式ICP—AES法测定婴儿乳粉,代乳粉中K,Na,Ca,Mg,P,Fe,Zn,Cu,Mn和Sr

本文采用HNO_3-HClO_4湿法消解样品,用乳化剂OP解决雾化器堵塞问题,利用单道扫描式ICP-AES仪测定婴儿乳粉、代乳粉中十种元素(K、Na、Ca、Mg、F、Fe、Zn、Cu、Mn和Sr)。方法简便快速,回收率在90-105%,相对标准偏差均小于10%,适用于婴儿乳粉、代乳粉中上述元素的测定。     

镶嵌于基质中的金属超微粒子特性研究(Ⅰ)——超微粒子的量子阱点模型

提出超微粒子(UFP)的量子阱点模型。模型假定UFP的主要特性由其非定域电子(简称电子)决定,电子被束缚在三维有限深势阱内。电子的行为由二部分组成:单电子的和集体化的。电子能谱主要由单电子行为决定。模型反映了UFP的一些重要特性,例如块体材料逸出功,UFP原子半径和第一电离能,而忽略UFP更精细的结构。这种近似被证明是合理的。一系列有用的公式和预言被导出。(1)主要的UFP特性,量子尺寸效应和电子能谱的壳层结构。(2)UFP的逸出功和费密能级公式,这对于其他模型是困难的。导出的UFP逸出功随尺寸变化的公式 关键词：