Pressure effects in a plastic columnar discotic triphenylene

The effect of hydrostatic pressure on the structure of a plastic columnar discotic triphenylene has been investigated. The goal was to determine whether pressure can be used to modify electronic properties via changes in structural properties of columnar discotics to any significant extent. The findings are that (i) the intra- and inter-columnar distances are reduced in a nearly isotropic fashion, (ii) that the crystal sizes are reduced and (iii) that a transition takes place from a more highly ordered plastic columnar to a less ordered hexagonal columnar state with increasing pressure. The induced decrease of the molecular distances, amounting to 6% for pressures up to 17 kbar, are clearly too small to induce an appreciable modification of the electronic structure and thus opto-electronic properties.     

Control of a liquid–liquid heat exchanger

 The analytical solutions of equations describing the dynamics of distributed parameter systems are usually complicated in form and derivations and inconvenient to use for simulation and control system design. The liquid–liquid counter flow heat exchanger is an example of these disturbed parameter systems. An analytical solution of the dynamics of a symmetrically operated counter flow heat exchanger in the form of transfer function matrix is investigated in open-loop and close-loop conditions. The resulting non-linear model was linearized using perturbation approach. A feed-forward path controller to counteract at any disturbances in the boundary temperature and a non-interactive controller to decouple the outputs were implemented. Received on 22 February 2001 / Published online: 29 November 2001     

On Critical Stability of Three Quantum Charges Interacting Through Delta Potentials

We consider three one-dimensional quantum, charged and spinless particles interacting through delta potentials. We derive sufficient conditions which guarantee the existence of at least one bound state.     

Butyltins in california river and lake marina waters

Butyltins were analyzed in waters from California river and lake marinas and were detected at the part per trillion (ppt) level in most locations. The tributyltin:dibutyltin (TBT/DBT) ratios in the fresh waters were similar to those in their saline counterparts indicating like rates of degradation in the two salinity regimes.     

Reductions in overshoot following intense sound exposures

Overshoot refers to the poorer detectability of brief signals presented soon after the onset of a masking noise compared to those presented after longer delays. In the present experiment, brief tonal signals were presented 2 or 190 ms following the onset of a broadband masker that was 200 ms in duration. These two conditions of signal delay were tested before and after a series of exposures to a tone intense enough to induce temporary threshold shift (TTS). The magnitude of the overshoot was reduced after the exposure when a TTS of at least 10 dB was induced, but not when smaller amounts of TTS were induced. The reduction in overshoot was due to a decrease in the masked thresholds with the 2-ms delay; masked thresholds with the 190-ms delay were not different pre- and post-exposure. The implication is that the mechanisms responsible for the normal overshoot effect are temporarily inactivated by the same stimulus manipulations that produce a mild exposure-induced hearing loss. Thus the result is the paradox that exposure to intense sounds can produce a loss of signal detectability in certain stimulus conditions and a simultaneous improvement in detectability in other stimulus conditions.     

Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China