Lifetime study of high-spin states in 104,105In

In the neutron deficient isotopes _104,105In lifetimes of high spin states in the range from 0.5 ps to 600 ps have been measured in a coincidence recoil distance Doppler shift (RDDS) experiment. By combining the Doppler shift attenuation (DSA) and RDDS methods at few μm flight distances, the problem of delayed feeding has been avoided and very short lifetimes in the range 0.5–0.8 ps have been determined. Shell model calculations with strong restrictions for the neutron orbitals reveal good agreement with experimental level energies and still fair agreement for most measured B(M1) and B(E2) values. Received: 30 June 1998     

Magnetism in electron-doped copper oxides

We report muon spin relaxation/rotation measurements on sintered powder samples of Nd_2−x Ce _x CuO_4−y and a large single crystal of Nd₂CuO_4−y . We find an electronic phase diagram which is quite similar to that of hole-doped superconductors such as La_2−x Sr _x CuO_4−y , although the doping of electrons into the system is less efficient in destroying the static moments on the copper spins. Static magnetic order in Nd₂CuO_4−y appears below about 250 K, and two spin reorientations are seen atT=75 K andT=35 K. Measurements of the magnetic field penetration depth have been unsuccessful due to the rare-earth paramagnetism of these materials.     

Cems characterization of SnO2 films obtained by sputtering and sol-gel route

Conversion electron Mössbauer spectroscopy (CEMS) has been used to study tin oxide films prepared by sol-gel dipping and sputtering. The spectra of films prepared by sol-gel route result close to that of crystalline SnO₂ after heat treatment at a temperature as low as 150°C. The Mössbauer parameters of as sputter deposited films indicate that the structure of the deposited stannic oxide has an amorphous character more pronounced for thinner samples. The structure becomes predominantly that of crystalline SnO₂ by heating at 550°C for 30 min provided the film thickness is higher than 10 nm.     

Novel optical techniques for the analysis of polymer surfaces and thin films

Summary We report on novel optical techniques, based on evanescent waves, for the characterization of polymer surfaces and thin films. We first describe photo-ablation studies with polysilane films investigated by surface plasmon microscopy, a technique which is particularly well-suited for ultrathin samples. Thicker films that are homogeneous enough to carry optical waveguide modes can be characterized with high lateral resolution by the recently developed waveguide microscopy. We demonstrate this for a thin film of a solid polyelectrolyte. Finally, we report on surface plasmon field-enhanced Raman-spectroscopic and -imaging investigations of ultrathin Langmuir-Blodgett-Kuhn-layers of cadmium arachidate.W. Hickel is now with HOECHST AG, Angewandte Physik, W-6230 Frankfurt 80     

The liquid-crystalline behaviour of amphiphilic ethane-1,2-diol derivatives incorporating a six membered ring in their principal structure

Novel 3-phenyloxy substituted propane-1,2-diol derivatives, 4-(4-n-hexyloxyphenyl)-butane-1,2-diol and 4-(trans-4-n-pyropylcyclohexyl)-butane-1,2-diol have been synthesized and their thermal behaviour has been studied. These compounds exhibit thermotropic and, after addition of water, also lyotropic liquid-crystalline behaviour. The clearing temperatures of the smectic mesophases were found to be strongly dependent on the alkyl chain length and on the structural units that link the aromatic ring to the alkyl chain and to the diol unit. The behaviour of the aromatic compounds is compared with that of the cyclohexane derivative. Thereby it has been realized that the mesophase stability of the amphiphilic diols incorporating a rigid unit is largely determined by both, the molecular geometry (molecular shape and intramolecular flexibility) and the amphiphilic structural pattern.     

Riccati-based preconditioner for computing invariant subspaces of large matrices

Summary. This paper introduces and analyzes the convergence properties of a method that computes an approximation to the invariant subspace associated with a group of eigenvalues of a large not necessarily diagonalizable matrix. The method belongs to the family of projection type methods. At each step, it refines the approximate invariant subspace using a linearized Riccati's equation which turns out to be the block analogue of the correction used in the Jacobi-Davidson method. The analysis conducted in this paper shows that the method converges at a rate quasi-quadratic provided that the approximate invariant subspace is close to the exact one. The implementation of the method based on multigrid techniques is also discussed and numerical experiments are reported. Received June 15, 2000 / Revised version received January 22, 2001 / Published online October 17, 2001     

μSR in oxygen deficient YBa2Cu3O x (6.5⩽x⩽7.0)

A systematic μSR study of the local magnetic field distribution in a series of oxygen deficient YBa₂Cu₃O _x samples with 6.5⩽x⩽7.0 is reported. Special attention was given to perform the experiments under the same conditions, so that the oxygen content of the measured samples was the only parameter varied. The behavior of the depolarization rate σ as a function of the oxygen contentx was found to have strong similarities with the behavior of the critical temperatureT _c as a function ofx. In particular, two step-like increases of σ were observed abovex=6.7 and 6.9. The temperature dependence of the normalized depolarization rate σ(T)/σ(0) is well described by the two-fluid model forx⩾6.781(1) and clearly deviates from this behavior forx⩽6.704(1). Our results are compared to those obtained by other groups.     

Direct laser ablation of sub-100 nm line structures into polyimide

Periodic line structures with a period of 167 nm and linewidths varying from 30 to 100 nm have been produced in polyimide by direct ablation with a KrF laser using an interferometric technique. The characteristics of this interferometer as it applies to the ablation of these line structures, including linewidth and alignment sensitivity, are analyzed. The ability to control the linewidth by varying the average incident fluence is described theoretically and demonstrated experimentally. This externally generated period of 167 nm also prevents the spontaneous growth of laser induced periodic surface structures (LIPSS).     

Existence of solutions for the time-dependent thermistor equations

The equations describing the behaviour of temperature/flow microsensorsemploy-ing polysilicon thermistors form a degenerate nonlinearparabolic system. One special feature is that different equationsof this system are to be satisfied on different domains. Bymeans of supersolutions and subsolutions, the maximum principle,and fixed point arguments, the authors show the existence ofsolutions to the equations.     

Magnetic resonance imaging and pulsed Doppler sonography of poststenotic jets: Correlation between signal void and flow velocity distribution

To correlate the appearance of poststenotic jets on gradient echo images with features of localized Doppler spectra of the jets, we studied an in vitro model of steady flow-through stenoses of 86, 96, and 99% area reduction. As fluids, water and a 40% glycerol solution in water were used. MRI was performed with a 1.5 T whole body imager and gradient echo images were obtained in planes parallel to the direction of flow. Doppler spectra were acquired separately from the MR measurements at 1 cm intervals for a distance of 10 cm downstream from the stenosis. Poststenotic signal void was observed for water and for the 40% glycerol solution only if the mean velocity within the stenosis exceeded a limit of 50–60 cm/sec. On the MR images, the jets could be divided into two segments: A proximal jet segment of uniform width equal to the diameter of the stenosis, followed by a distal jet segment which was characterized by broadening and then dissipating signal void. Except for the 99% stenosis, a high signal intensity core was present within the proximal jet segment. In the proximal jet segment, the Doppler measurements showed a low temporal fluctuation of the maximal flow velocity and only little flow opposite to the main flow direction. In the distal jet segment, the velocity fluctuation and the intensity of reverse flow increased sharply. The high signal intensity core of the jet was associated with a poststenotic zone of constant maximal flow velocity. The results demonstrate a close relationship between characteristic features of poststenotic jets in MRI and pulsed Doppler sonography.