High-performance liquid chromatographic determination of cocaine and benzoylecgonine by direct injection of human blood plasma sample into an alkyl-diol-silica (ADS) precolumn

A column-switching high-performance liquid chromatographic method with UV detection for the determination of cocaine (COC) and benzoylecgonine (BZE) in human blood plasma samples is described. The method uses an alkyl-diol-silica ADS-C18 extraction precolumn. A 50- micro L plasma sample was introduced to the ADS precolumn in order to separate the analytes from proteins and endogenous compounds. The fraction containing COC and BZE was back-flushed and transferred to an Alltech mixed-mode C(18)/cation-exchange analytical column for final separation. The validation of the method revealed quantitative recoveries from 95.0 to 99.0% for COC at three different concentrations (0.5, 1.0 and 2.0 micro g mL(-1)), and from 96.0 to 99.0% for BZE at the same concentration levels with coefficients of variation <4.00% (n=5). The detection limit (signal to noise ratio (S/N)>3) was 0.03 micro g mL(-1) for all the compounds with an injection volume of 50 micro L. However, it was possible to enhance the sensitivity further by injecting larger plasma volumes, up to 200 micro L, at the same optimal conditions. The overlap of sample preparation, analysis and reconditioning of the extraction column, increase the overall sample throughput to 5 samples h(-1). The developed method has been applied to human blood plasma samples from subjects suspected of cocaine abuse.     

Determination of zinc by flow injection with fluorimetric detection in a micellar medium

A room-temperature flow injection spectrofluorimetric method is presented for the determination of Zn(II), based on the use of salicylaldehyde thiocarbohydrazone in the presence of Triton X-100 and sodium acetate-acetic acid buffer. Various physical and chemical variables affecting the reaction in the flow system were evaluated. The proposed method is very selective. The calibration graph is linear over the range 10-1000 ng/ml, with a detection limit of 5 ng/ml and a relative standard deviation at the 50 ng/ml level of 1.8 %. The method was successfully applied to the determination of Zn(II) in drinking waters and biological samples.     

X‐ray absorption study of the local structure at the NiO/oxide interfaces

This work reports an X‐ray absorption near‐edge structure (XANES) spectroscopy study at the Ni K‐edge in the early stages of growth of NiO on non‐ordered SiO₂, Al₂O₃ and MgO thin films substrates. Two different coverages of NiO on the substrates have been studied. The analysis of the XANES region shows that for high coverages (80 Eq‐ML) the spectra are similar to that of bulk NiO, being identical for all substrates. In contrast, for low coverages (1 Eq‐ML) the spectra differ from that of large coverages indicating that the local order around Ni is limited to the first two coordination shells. In addition, the results also suggest the formation of cross‐linking bonds Ni—O—M (M = Si, Al, Mg) at the interface.     

Collective Tunnelling of Strongly Interacting Cold Atoms in a Double-Well Potential

It is known that under resonance conditions, a group of strongly interacting bosonic atoms, trapped in a double-well potential, mimics a single particle, performing Rabi oscillations between the wells. By implication, all atoms need to tunnel at roughly the same time, even though the Bose–Hubbard Hamiltonian accounts only for one-atom-at-a-time transfers. The mechanism of this collective behavior is analyzed, the Rabi frequencies in the process are evaluated, and the limitation of this simple picture is discussed. In particular, it is shown that the small rapid oscillations superimposed on the slow Rabi cycle result from splitting the transferred cluster at the sudden onset of tunnelling, and disappear if tunnelling is turned on gradually.     

Growth by laser ablation of Ti-based oxide films with different valency states

x La_2/3+yTiO_3-δ perovskite (with δ≤0.5) were deposited by the laser ablation technique from Li_0.33La_0.56TiO₃ targets. Their growth onto MgO substrateswas studied as a function of the oxygen pressure. For films grown in vacuum (10^-6 mbar), a La_0.63TiO_2.5 composition was obtained, meaning that Ti³⁺ alone is present in the films, while Li ions are not incorporated under these conditions. This material shows good electric conductivity (ρ=500 mΩ cm). By contrast, insulating films with a Li_0.1La_0.70TiO₃ composition corresponding to the Ti⁴⁺ species were obtained at high oxygen pressures (>0.05 mbar). For all conditions, textured films were grown with different orientations depending on the temperature and the oxygen pressure. Received: 10 September 1997/Accepted: 24 November 1997     

Finite element approximation of nematic liquid crystal flows using a saddle-point structure

In this work, we propose finite element schemes for the numerical approximation of nematic liquid crystal flows, based on a saddle-point formulation of the director vector sub-problem. It introduces a Lagrange multiplier that allows to enforce the sphere condition. In this setting, we can consider the limit problem (without penalty) and the penalized problem (using a Ginzburg–Landau penalty function) in a unified way. Further, the resulting schemes have a stable behavior with respect to the value of the penalty parameter, a key difference with respect to the existing schemes. Two different methods have been considered for the time integration. First, we have considered an implicit algorithm that is unconditionally stable and energy preserving. The linearization of the problem at every time step value can be performed using a quasi-Newton method that allows to decouple fluid velocity and director vector computations for every tangent problem. Then, we have designed a linear semi-implicit algorithm (i.e. it does not involve nonlinear iterations) and proved that it is unconditionally stable, verifying a discrete energy inequality. Finally, some numerical simulations are provided.     

Diffractively produced charm final states in 800-GeV/c pp collisions

We report the first observation of diffractively produced open charm in 800-GeV/c pp collisions of the type pp-->pD*X. We measure cross sections of sigma(diff)(D*+) = (0.185+/-0.044+/-0.054) (mu)b and sigma(diff)(D(*-)) = (0.174+/-0.034+/-0.029) (mu)b. Our measurements are based on 4.3x10(9) events recorded by FNAL E690 in the fixed-target run of 1991. We compare our results with previous fixed-target charm experiments.     

Thermal diffusivity study of cheese fats by thermal lens detection

In this paper we used thermal lens spectrometry to determine the thermal diffusivity of cheese fats. We have used equal concentrations of cheese fats from oaxaca, chihuahua, gouda, manchego and mozzarella cheeses at 42°C temperature. The two lasers mismatched mode experimental configuration was used with a He-Ne laser, as a probe beam and an Ar⁺ laser as the excitation one. The characteristic time constant of the transient thermal lens was obtained by fitting the theoretical expression to the experimental data in order to obtain the thermal diffusivity of the cheese fat samples. This measured thermal property may contribute to a better understanding of the cheese fats quality, which is very important in food industry.