一类新的手性β-二酮铜(Ⅱ)配合物合成及性质 Ⅰ.( )双[1-对烷氧基苯基-3-对-(2′-甲基丁氧基)苯基-1,3-丙二酮]合铜(Ⅱ)

本文合成了一类新的含手性基团的β－二酮铜（Ⅱ）配合物，双［１－对烷氧基苯基－３－对－（２′甲基丁氧基）苯基－１，３－丙二酮］合铜（Ⅱ），经元素分析、红外光谱及比旋光度测定确定了结构。通过偏光显微镜下相变观察及ＤＳＣ图谱，证实这些配合物没有液晶性，其原因可能在于分子的对称性不好     

材料化学实验课程体系的改革与建设

结合材料化学实验课程自身的特点及材料化学实验教学的经验，系统阐述我院材料化学实验改革的思路，通过深化材料化学实验教学改革，提高任课教师的学术水平，更新教学内容，优化教学模式，推进教材的系统性建设，实现材料化学实验教学质量的提高，激发学生的学习热情与兴趣，进一步培养学生的创新能力。     

General solution for Poisson-Boltzmann equation in semiinfinite planar symmetry

Self-assembled multilayer thin films have been prepared on Au substrate by alternate surface derivatization with L-cysteine hydrochloride and cupric perchlorate. The layer-by-layer structure at each step of multilayer formation was investigated by X-ray photoelectron spectroscopy. The measurements indicate that there are two structure modes in the multilayers. One is that Cu(2+) sandwiches between two amino acid groups. The other one is that Cu(+) is bonded through disulfide and thiolate. This process is also confirmed by cyclic voltammetry of Cu ion at different self-assembled multilayers. Steps further on will lead to repeated multilayer films.     

硫化态K—Mo合成低碳醇催化剂的制备条件和载体效应研究

用浸渍法制备以KCl为助剂的ZrO_2、γ-Al_2O_3和SiO_2负载硫化态钼基催化剂,研究了钼和助剂钾两种组分浸渍顺序、助剂含量、载体差别以及浸渍溶液的酸碱性对催化剂上CO加氢合成低碳混合醇性能的影响。ZrO_2按先钼后钾、γ-Al_2O_3和SiO_2则按相反的顺序浸渍两种组分、且K/Mo原子比分别为0.5,0.8和1.0制备催化剂,其合成醇活性最佳。由于载体性质的差异,K-Mo/SiO_2、特别是K-Mo/ZrO_2的合成醇活性强烈依赖于钾助剂含量。而K-Mo/SiO_2在较宽的钾含量范围内,其活性差别不明显。适当选择较高碱性的浸渍溶液制备K-Mo/γ-Al_2O_3催化剂,有利于醇活性的提高。     

磷脂酰胆碱与牛血清白蛋白相互作用的FT-IR研究

利用傅立叶变换红外(FT-IR)和拉曼(FT-Raman)光谱研究了高浓度磷脂酰胆碱(PC)与牛血清白蛋白(BSA)的相互作用,及Eu3＋对该作用的影响.FT-IR结果显示,PC/BSA混合体系中二者的相互作用主要发生在PC头部极性基团,且这一作用随BSA含量的增加而增强,作用后蛋白质二级结构中α螺旋的比例有所增加. FT-Raman光谱说明PC与BSA的相互作用影响磷脂CH链的排列有序程度. PC/BSA/Eu3＋体系的红外光谱显示, Eu3＋与PC的磷氧键发生了强相互作用,并使蛋白α螺旋的比例进一步增加.     

直键与弯键的对称性判据

一穹键的提出人们认为,杂化轨道(HAO)角函数的最大值方向(亦即HAO的方向)指向与之键合的原子,这样形成的化学键称为“直键”。但环丙烷分子中的三个碳原子构成三元环,有60°的键角。而任意两个正交的S-P杂化轨道之间的夹角θ都不可能小于90°,因而形成C-C键的HAO,不可能指向键合原子,环上的C-C键不可能是直键,而是“弯键”(BentBond)。通常,人们认为张力分子环上的键是弯键,其他的键为直键。     

K-Mo基催化剂的表面酸性与其合成醇选择性

对500℃和800℃焙烧制得的氧化态K－MoO3／γ－AlO3，K－MoO3／SiO2及非负载K－Mo催化剂进行硫化后，测试其合成醇活性．结果表明500℃焙烧制得的负载型催化剂显示较高的合成低碳烃活性和较低的合成低磷醇选择性，经800℃焙烧后，合成低磷醇的选择性大幅度提高．500℃焙烧的非负载K－Mo催化剂显示较高的合成醇选择性，经800℃焙烧后，促碳醇的选择性保持不变．用氨的吸附及TPD方法测定了各样品的酸性，并与催化剂活性对照，发现催化剂酸性越强，酸量越大，则其合成醇选择性越低．催化剂上的乙醇分解实验证实，催化剂的酸量大小与它的醇分解活性成正变关系，这些结果说明催化剂酸性对其合成醇性能有直接的影响．     

制备方法对Mg1.9Al0.1Ni合金储氢性能的影响

文中采用机械合金化(MA)和氢化燃烧法(HCS)制备了Mg1.9Al0.1Ni,通过对它们储氢性能的对比研究发现,MA优于HCS.采用MA制得的Mg1.9Al0.1Ni储氢合金具有较高的活性和高储氢量,对PCT结果进行计算,得出温度和氢平衡压的关系式.Mg1.9Al0.1Ni(MA)553K时100s内吸放氢量分别为2.67和2.54 mass%H.用XRD方法进行物相分析,表明添加适量Al没有改变Mg2Ni的物相结构,由于MA能够制备出纳米晶粒,使得Mg1.9Al0.1Ni合金具有更好的储放氢动力学性能.     

Longistylumphyllines A–C,Three New Alkaloids from Daphniphyllum longistylum

Three new alkaloids, longistylumphyllines A–C (1–3), together with the six known alkaloids deoxycalyciphylline B, deoxyisocalyciphylline B, methyl homosecodaphniphyllate, daphnicyclidin A, daphnicyclidin B, and daphnicyclidin F, were isolated from the stems and leaves of Daphniphyllum longistylum. Their structures and relative configuration were elucidated on the basis of spectroscopic data, especially 1D and 2D NMR techniques.     

Maximum overlap symmetry molecular orbital model

This paper provides a brief and systematic presentation of the basic principle and method of the maximum overlap symmetry molecular orbital (MOSMO ) model and its application to simplification of molecular orbital calculation and to calculation of molecular structures and properties, together with some new results about the MOSMO calculation and new insights concerning the further extension of the principle and method. It has been shown that the theoretical method of the MOSMO model is very simple, reliable, and useful and can be employed to study the structure–property relation in even very large molecular systems. The numerical results obtained from the MOSMO calculation on various semiempirical molecular orbital approximation levels show that when the same parametrization, such as one of those employed in EHMO , CNDO /2, and HMO methods, is adopted, the MOSMOS are very close to the canonical molecular orbitals obtained from the customary LCAO method and the MOSMO calculation requires less computing time than does the LCAO method. The MOSMO calculation can be used for rapidly obtaining reasonably good molecular geometries, vibrational frequencies, and other properties of molecules by employing a simple improved semiempirical parametrization. Equilibrium geometries, vibrational frequencies, and other results are in good agreement with the experimental data and the results obtained from ab initio molecular orbital calculation. The basic calculational procedure of the MOSMO model can be extended further and has been employed to give some new results, to propose some new theoretical schemes and principles, and to introduce some new interesting theoretical problems that deserve to be studied further.