Generation of 131 fs mode-locked pulses from 2.8μm Er:ZBLAN fiber laser

We demonstrated a femtosecond mode-locked Er:Zr F4-Ba F2-La F3-Al F3-Na F(Er:ZBLAN)fiber laser at 2.8μm based on the nonlinear polarization rotation technique.The laser generated an average output power of 317 m W with a repetition rate of 107 MHz and pulse duration as short as 131 fs.To the best of our knowledge,this is the shortest pulse generated directly from a mid-infrared mode-locked Er:ZBLAN fiber laser to date.Numerical simulation and experimental results confirm that reducing the gain fiber length is an effective way to shorten the mode-locked pulse duration in the Er:ZBLAN fiber laser.The work takes an important step towards sub-100-fs mid-infrared pulse generation from mode-locked Er:ZBLAN fiber lasers.     

Geometric phase of an open double-quantum-dot system detected by a quantum point contact

We study theoretically the geometric phase of a double-quantum-dot(DQD) system measured by a quantum point contact(QPC) in the pure dephasing and dissipative environments, respectively. The results show that in these two environments, the coupling strength between the quantum dots has an enhanced impact on the geometric phase during a quasiperiod. This is due to the fact that the expansion of the width of the tunneling channel connecting the two quantum dots accelerates the oscillations of the electron between the quantum dots and makes the length of the evolution path longer.In addition, there is a notable near-zero region in the geometric phase because the stronger coupling between the system and the QPC freezes the electron in one quantum dot and the solid angle enclosed by the evolution path is approximately zero,which is associated with the quantum Zeno effect. For the pure dephasing environment, the geometric phase is suppressed as the dephasing rate increases which is caused only by the phase damping of the system. In the dissipative environment,the geometric phase is reduced with the increase of the relaxation rate which results from both the energy dissipation and phase damping of the system. Our results are helpful for using the geometric phase to construct the fault-tolerant quantum devices based on quantum dot systems in quantum information.     

Effects on the evolution of microstructure and properties of low-silicon cast aluminum alloys in service

ABSTRACT

The microstructure evolution and property change of four kinds of low silicon cast aluminum alloy exposed to heat for 0–50?h at 200°C were studied by means of Brinell hardness test, tensile property test, friction and wear property test and XRD analysis. The results show that with increasing thermal exposure time, the tensile strength of each group of samples decreased and the amount of wear increased. The tensile strength of samples with more Si content decreased slowly. When the time increased to 50?h, the increase of wear loss was the largest. The hardness of samples after thermal exposure increases compared with that before thermal exposure. The residual stress of (311) diffraction crystal surface of AlSi3.5Mg0.66 under different thermal exposure time was measured. The type of residual stress changed from residual tensile stress to residual compressive stress after thermal exposure. There is an abnormal phenomenon that the hardness of the sample increased and the amount of wear increased, and it is evident that the distribution of residual stress was inhomogeneous after thermal exposure. It is found that with increasing thermal exposure time to 50?h, the average lattice distortion ε of the low-index crystal plane and the high-index crystal plane in the aluminum alloys gradually increased.     

一种超导重力仪磁悬浮力的等效计算

为实现超导重力仪磁悬浮力的精确计算,以GWR型超导重力仪为模型基础,采用有限元的思想,将超导球表面电流理想化为多个等高共轴电流环,计算出各个电流环与超导线圈的作用力,求和得到线圈与超导球间的磁悬浮力。利用MATLAB完成计算程序实现,通过改变下线圈电流和上、下线圈电流比,获得满足一定条件的磁悬浮力及其梯度。选取合适的模型参数,计算出线圈对质量为m=4.069 g超导球的磁悬浮力大小为:Ftotal=3.988×10^-2N,磁悬浮力梯度为:-9.699×10^-3N/m,此时悬浮力梯度合适,满足系统稳定性和灵敏度的要求。     

基于PLC 的中央空调制冷系统变频控制研究

针对现有中央空调系统能源消耗严重的现状,基于可编程逻辑控制器(Programmable Logic Controller,PLC)对中央空调系统进行变流量节能改造。分析改造后中央空调系统的结构组成和变频运行原理,并提出适用于冷冻水泵和冷却水泵的分段速温差控制和PID温差控制设计方案。控制硬件选用三菱FX3U系列PLC和台达VFD-EL变频器,软件选用GX Work2编程软件及力控组态软件。将控制方案进行实验验证,实验结果表明,所设计的两种控制策略不仅跟随系统末端负荷变化快速达到稳定运行状态,提高运行能效比,而且节能效果显著,节能率分别为40.2%和48.7%。     

乙基苯胺的转动光谱及分子结构

本文使用傅里叶变换微波谱仪研究了乙基苯胺类物质(邻乙基苯胺,间乙基苯胺,对乙基苯胺)的分子结构. 由于此类分子含氮原子(I¹⁴N=1),因此跃迁谱线中都呈现出核四级裂分. 通过比较实验测定得到的分子结构,可总结苯胺环上不同位置乙基的取代对氨基及分子整体结构的影响.     

新型稀磁半导体Fe掺杂LiZnP的光电性质

采用基于密度泛函理论的第一性原理计算法研究了新型稀磁半导体Li_(1±)_y(Zn_(1-)_xFe_x)P (x=0, 0.0625;y=0, 0.0625)的电子结构、磁性及光学性质.结果表明,Fe的掺入使体系产生自旋极化杂质带,Fe的3d态与Li2s态,Zn4s态以及P3p态的态密度峰在费米能级处出现重叠,产生sp-d轨道杂化,此时体系净磁矩最大,材料表现出金属性,导电性增强.当Li空位时,导电性减弱,但杂质带宽度最大,居里温度最高.而Li填隙时,体系形成能最低,材料变为半金属性,表现为100%自旋注入,表明掺杂体系的磁性和电性可以分别通过Fe的掺入和Li的含量进行调控.对比光学性质发现,Li空位时,在介电函数虚部和复折射率函数的低能区出现新峰,扩大了对低频电磁波的吸收范围.能量损失函数表明掺杂体系具有明显的蓝移效应,且Li填隙时有更强的等离子共振频率.     

高温高压下CeTbO3合成过程中电阻的动态测试研究

 在0.5 GPa、4.0 GPa的压力下，从室温到800 ℃的温度范围内测量了氧化物CeTbO₃、单稀土氧化物Tb₄O₇、CeO₂和摩尔比维4∶1配比的混合物CeO₂+Tb₄O₇等的电阻随温度变化关系。对这四种物质均反映出电阻随温度增加而减小的半导体特征。在压力维0.5 GPa，温度高于600 ℃时发现了混合物CeO₂+Tb₄O₇、氧化物Tb₄O₇中电阻变化的起伏。X射线衍射谱表明，对应这一电阻变化，在结构上出现了变化。结果分析表明，这一变化与Tb⁴⁺→Tb³⁺的价态变化密切相联。     

稀土焦绿石化合物R2Fe4/3W2/3O7的高温高压稳定性研究和X射线相分析

 本文利用X射线粉末衍射和位敏探测技术，研究了R₂Fe_4/3W_2/3O₇（R=Er、Yb、Dy）化合物经高温高压处理后的变化情况。在3.7 GPa，1 200 ℃条件下，六方相R₂Fe_4/3W_2/3O₇化合物按两种方式分解，而直接由R₂O₃，Fe₂O₃和WO₃原料出发，经上述同样的高温高压条件合成所得的产物与六方相高温高压分解产物相同，均为R₂WO₆、RFeO₃、WO₃和Fe₂O₃的多相聚合物。同时给出了R₂Fe_4/3W_2/3O₇六方相高温高压下的稳定区范围。