直流溅射法制备电致变色WO_3膜

采用ＷＯ３陶瓷靶直流溅射制作了电致变色膜．介绍了制膜工艺．分析测试表明，膜有无定形结构；除有正常成分ＷＯ３外，还含有来自衬底及反应室内的微量杂质．电致变色谱响应特性和电化学特性的测量证明，膜的电色活性良好．还对实验结果作了理论分析．     

以BBOT为电子传输层的聚合物蓝色发光二极管

在前篇文章中[1]我们报导了以perylene掺杂的PVCz聚合物单层电致发光器件,得到蓝色发光,其亮度为59(cd/m2).在这篇文章中,我们以PVCz作为空穴传导层,BBOT为电子传导层制成了双层结构的发光二极管.亮度和效率都大大超过单层器件.     

有消费或投资的华氏宏观经济模型

本文对华罗庚教授的宏观经济模型进行了推广 ,在原来模型的基础上 ,分别增加了消费、投资 ,得到两种不同的模型 ,并对模型具有经济意义的解进行了研究     

二维稳态各向异性介质渗透率的反演问题

1.引 言由多孔介质的渗流理论,二维稳态各向异性介质的渗流问题满足下列偏微分方程 -div(u(x,y)(?)u(x,y))=f(x,y),(x,y)∈Ω(?)R2, (1.1)     

关于3连通图的容错直径和宽直径

容错直径和宽直径是度量网络可靠性和有效性的重要参数．对任意k连通图，它的容错直径Dk不超过宽直径dk,本证明：当D2=2时，d3≤max{D， l，2D3-2}；当D2≥3时，d3≤(D2-1)[2(D2-1)(D3-1)-D2-2] 1．     

Fast spin state initialization in a singly charged InAs-GaAs quantum dot by optical cooling

Quantum computation requires a continuous supply of rapidly initialized qubits for quantum error correction. Here, we demonstrate fast spin state initialization with near unity efficiency in a singly charged quantum dot by optically cooling an electron spin. The electron spin is successfully cooled from 5 to 0.06 K at a magnetic field of 0.88 T applied in Voigt geometry. The spin cooling rate is of order 10(9) s-1, which is set by the spontaneous decay rate of the excited state.     

量子点中磁激子的极化子效应

采用推广的LLP方法研究了自组织量子点中磁激子的极化子效应。考虑带电粒子和声子的相互作用,得到了激子能量随磁场的变化关系。结果表明,激子-声子的相互作用降低了激子的能量,但影响很小;极化子效应在没有外磁场时较明显,随着外磁场的增加,这种效应变得越来越弱。     

K9和石英玻璃基片上Au膜真空紫外反射特性研究

采用离子束溅射法,分别在经过不同前期清洗方法处理过的K9及石英玻璃光学基片上,选择不同的镀膜参量,镀制了多种厚度的Au膜。对镀制的Au膜在真空紫外波段较宽波长范围内的反射率进行了连续测量。测试结果表明:辅助离子源的使用方式、Au膜厚度对反射镜的反射率有重大影响。基片材料、镀前基片表面清洗工艺等对反射率也有一定影响。采用镀前离子轰击,可显著提高Au膜反射率及膜与基底的粘合力;获得最高反射率时的最佳膜厚与基片材料、镀膜工艺密切相关。对经过离子清洗的石英基片,膜厚在30 nm左右反射率最高;比较而言,石英基片可获得更高的反射率;辅助离子源的使用还显著影响获得最高反射率时对应的最佳膜厚值,且对K9基片的影响更显著。     

Mode Matching Analysis for a New Millimeter Wave Omni-Directional Antenna Consisting of Circular Rod Corrugations Gloved with a Dielectric Shell

A new millimeter-wave omnidirectional antenna consisting of circular rod corrugations gloved with a dielectric shell is investigated. As an eigenvalue problem, the antenna is analyzed with the rigorous mode matching method. The radiation characteristics of the antenna are calculated in the Ka-band frequency range. A comparison of the leaky characteristics is made between the antennas with and without dielectric shell. It is found that the circular dielectric shell layer greatly affects the leaky characteristics of the antenna and the leakage constant increases considerably. In such a way, the length of the antenna can be reduced tremendously with higher radiation efficiency. This fact indicates that the proposed leaky wave antenna is of essentially practical significance for the case where the limitation in size and weight of system is strictly required. The effectiveness and reliability of the present analysis are verified by the calculated and experimental results given in the literature.     

Preparation and characterization of a poled nanocrystal and polymer composite PbTiO3/PEKc film for electro-optic applications

Composite thin films of PbTiO₃ nanocrystals and high-transparency PEKc polymer for applications in electro-optical devices were prepared using the spin coating technique. The size of the PbTiO₃ nanocrystals was estimated to be 30–40 nm using a transmission electron microscope. The transmission technique, a simple method for measuring the electro-optic coefficients of poled composite polymer films was developed. The electro-optic coefficient γ₃₃ of poled PbTiO₃/PEKc composite polymer films was measured to be 18.34 pm  V^-1 at 633 nm under room temperature. The index at 633 nm and the dielectric constant at 100 kHz under room temperature were determined to be 1.65248 and 7.32, respectively. The figure of merit F₂=n⁷γ²/ε was estimated to be 1546, showing very good electro-optical properties. Received: 5 February 2002 / Accepted: 12 March 2002 / Published online: 19 July 2002 RID="*" ID="*"Corresponding author. Fax: +852/2788-7791, E-mail: eeytc@cityu.edu.hk