A comparative study of solvent extraction of total petroleum hydrocarbons in soil

Three non-specific methods for the extraction of total petroleum hydrocarbons (TPH) from soil into organic solvent were compared. The techniques used for sample preparation were Soxhlet extraction, closed-vessel microwave-assisted extraction, and CEN shake extraction. The total concentrations of extracted compounds in the boiling point range of C10–C40 were determined by gas chromatography with flame ionization detection. The best recovery (99%) and repeatability (±3%) from standard oil mixtures were obtained with microwave-assisted extraction. However, the different extraction methods exhibited different behaviour when spiked soil samples were extracted. The best repeatability was obtained with CEN shake extraction (±6%) but the repeatability values for Soxhlet and microwave-assisted methods were quite high (>20%). However, the larger uncertainties of the latter extraction methods does not necessarily limit the applicability of these methods to the determination of petroleum hydrocarbons in soil, as in the assessment of soil contamination the expanded uncertainty of the result is usually not limited by analytical uncertainty, but rather by the uncertainty of the primary sampling stage. However, distinctive variation found in the chromatographic profiles illustrates that discretion should be obeyed when chromatograms obtained after application of different extraction methods on petroleum contaminated samples are to be used in the fingerprinting or age dating studies. Otherwise, misleading conclusions concerning the age of spillage could be drawn.     

A comparison of the mechanism for the reductive half-reaction between pea seedling and other copper amine oxidases (CAOs)

In a previous DFT study a mechanism for the reductive half-reaction of pea seedling amine oxidase (PSAO) was suggested. In many of the suggested steps a lysine at the active site plays an important role. However, this lysine is not found in other amine oxidases. The primary aim of the present DFT study is therefore to investigate alternative mechanisms for those amine oxidases (CAO) where the lysine residue is not present. One of the most important roles suggested for the lysine in PSAO was to protonate the O2-site of TPQ before the critical Cbond;H bond cleavage of the substrate. In the absence of lysine the O2-site of TPQ is now suggested to be protonated by a water ligand on the copper metal complex, in line with experimental suggestions. In other steps the role of lysine is taken over by an asparagine. All results are compared with experimental observations and good agreement is generally found.     

Reactions of polystyryl anions with carbon dioxide and oxygen. Analysis of products by silica gel chromatography

Polystyryllithium was prepared by anionic polymerization. This “living polymer” and the polystyrylmagnesium bromide derived from it were treated with carbon dioxide (solid or gas). The highest yields of carboxylic acid were obtained when solid carbon dioxide was used with polystyryllithium or by treatment of polystyrylmagnesium bromide with gaseous carbon dioxide. The products from the reaction of polystyryllithium with oxygen were polymeric ketone X, the alcohols IXa and IXb, and coupling products (e. g., XI). The various functionalized and unfunctionalized polystyrene products were isolated by chromatography on silica gel and were characterized by gel permeation chromatography (GPC), thin layer chromatography (TLC), and high-performance liquid chromatography (HPLC) in combination with chemical transformations.     

MM-PBSA free energy analysis of endo-1,4-xylanase II (XynII)-substrate complexes: binding of the reactive sugar in a skew boat and chair conformation

The binding of xylotetraose in different conformations to the active site of endo-1,4-beta-xylanase II (XynII) from Trichoderma reesei was studied using molecular dynamics (MD) simulations and free energy analyses employing the MM-PBSA (Molecular Mechanics-Poisson-Boltzmann Surface Area) method. MD simulations of 1 ns were done for the substrate xylotetraose having the reactive sugar, which is bound in the -1 subsite of XynII in the 4C1 (chair) and 2So (skew boat) ground state conformations, and for the transition state of the XynII catalysed hydrolysis of the beta-glycosidic linkage. According to the simulations and free energy analysis, XynII binds the substrate with the -1 sugar in the 2So conformation 59.8 kJ mol(-1) tighter than the substrate with the sugar in the 4C1 conformation. The reactive 2So conformation resembles closely the reaction transition state and has the breaking glycosidic bond in a pseudo-axial orientation ready for facile bond cleavage. The transition state was calculated to be bound 77.1 kJ mol(-1) tighter than the 4C1 ground state conformation. The molecular mechanical interaction energy between the enzyme and the reactive pyranoside unit at the -1 subsite was 75.7 kJ mol(-1) more favorable for the binding of the 2So conformation than the 2C1 conformation, explaining the clearly tighter binding of the reactive structure The results of this study indicate that in the Michaelis complex XynII, a member of the family 11 xylanase, the substrate is bound in a skew boat conformation and in the catalytic reaction, the -1 sugar proceeds from the 4C1 conformation through 2So to the transition state with the -1 sugar in the 2,5B conformation.     

Quantum chemical studies of dioxygen activation by mononuclear non-heme iron enzymes with the 2-His-1-carboxylate facial triad

Density functional theory with the B3LYP hybrid functional has been used to study the mechanisms for dioxygen activation by four families of mononuclear non-heme iron enzymes: alpha-ketoacid-dependent dioxygenases, tetrahydrobiopterin-dependent hydroxylases, extradiol dioxygenases, and Rieske dioxygenases. These enzymes have a common active site with a ferrous ion coordinated to two histidines and one carboxylate group (aspartate or glutamate). In contrast to the heme case, this type of weak field environment always leads to a high-spin ground state. With the exception of the Rieske dioxygenases, which have an electron source outside the active site, the dioxygen activation process passes through the formation of a bridging-peroxide species, which then undergoes O-O bond cleavage finally leading to the four electron reduction of O(2). In the case of tetrahydrobiopterin- and alpha-ketoacid-dependent enzymes, the O-O heterolysis yields a high-valent iron-oxo species, which is capable of performing a two-electron oxidation chemistry on various organic substrates. For the other two families of enzymes (extradiol dioxygenases and Rieske dioxygenases) the substrate oxidation and the O-O bond cleavage are found to be coupled. In the extradiol dioxygenases the product of the O-O bond cleavage is a ferric iron with an oxy-substrate with a mixture of radical and anionic character, which is essential for the selectivity of the catechol cleavage.     

Hydration state of nonionic surfactant monolayers at the liquid/vapor interface: structure determination by vibrational sum frequency spectroscopy

The OH stretching region of water molecules in the vicinity of nonionic surfactant monolayers has been investigated using vibrational sum frequency spectroscopy (VSFS) under the polarization combinations ssp, ppp, and sps. The surface sensitivity of the VSFS technique has allowed targeting the few water molecules present at the surface with a net orientation and, in particular, the hydration shell around alcohol, sugar, and poly(ethylene oxide) headgroups. Dramatic differences in the hydration shell of the uncharged headgroups were observed, both in comparison to each another and in comparison to the pure water surface. The water molecules around the rigid glucoside and maltoside sugar rings were found to form strong hydrogen bonds, similar to those observed in tetrahedrally coordinated water in ice. In the case of the poly(ethylene oxide) surfactant monolayer a significant ordering of both strongly and weakly hydrogen bonded water was observed. Moreover, a band common to all the surfactants studied, clearly detected at relatively high frequencies in the polarization combinations ppp and sps, was assigned to water species located in proximity to the surfactant hydrocarbon tail phase, with both hydrogen atoms free from hydrogen bonds. An orientational analysis provided additional information on the water species responsible for this band.     

Potential-energy surface for the electronic ground state of NH3 up to 20,000 cm-1 above equilibrium

Ab initio coupled cluster calculations with single and double substitutions and a perturbative treatment of connected triple excitations [CCSD(T)] with the augmented correlation-consistent polarized valence triple-zeta aug-cc-pVTZ basis at 51 816 geometries provide a six-dimensional potential-energy surface for the electronic ground state of NH3. At 3814 selected geometries, CBS+ energies are obtained by extrapolating the CCSD(T) results for the aug-cc-pVXZ(X=T,Q,5) basis sets to the complete basis set (CBS) limit and adding corrections for core-valence correlation and relativistic effects. CBS** ab initio energies are generated at 51,816 geometries by an empirical extrapolation of the CCSD(T)/aug-cc-pVTZ results to the CBS+ limit. They cover the energy region up to 20,000 cm-1 above equilibrium. Parametrized analytical functions are fitted through the ab initio points. For these analytical surfaces, vibrational term values and transition moments are calculated by means of a variational program employing a kinetic-energy operator expressed in the Eckart-Sayvetz frame. Comparisons against experiment are used to assess the quality of the generated potential-energy surfaces. A "spectroscopic" potential-energy surface of NH3 is determined by a slight empirical adjustment of the ab initio potential to the experimental vibrational term values. Variational calculations on this refined surface yield rms deviations from experiment of 0.8 cm-1 for 24 inversion splittings and 0.4 (3.0) cm-1 for 34 (51) vibrational term values up to 6100 (10,300) cm-1.     

Microwave heated vapor-phase digestion method for biological sample materials

A microwave heated, vapor-phase nitric acid-hydrogen peroxide digestion method for pulverized, biological sample materials was developed. Sample masses up to 200 mg were digested using calibrated quartz inserts inside first generation type, low-pressure, Teflon-PFA microwave vessels. In the first step, samples were digested in the vapor-phase for 80 min using a progressive heating pattern. Three mL of 70% nitric acid and 0.5 mL of 30% hydrogen peroxide were used as digestion reagents. In the second step, the small residue left after first step digestion was dissolved in 1.4% nitric acid or additionally with 0.5% hydrofluoric acid by heating for 15 min. The digestion method was optimized using pike (Esox lucius) muscle as a test material. The method was further optimized using three certified reference materials. Ca, Cu, Fe, Mg and Zn were determined from NIST-SRM 1577a bovine liver by ICP-AES. Cr and Ni were determined from NIST-SRM 8433 corn bran and NRCC DOLT-2 dogfish liver by GFAAS. For all elements the values obtained were close or within certified limits. Spike recoveries were between 96 to 107%. Digestion efficiency ranged from 91 to 99%.     

Direct identification of all oncogenic mutants in KRAS exon 1 by cycling temperature capillary electrophoresis

Over the past few decades, advances in genetics and molecular biology have revolutionized our understanding of cancer initiation and progression. Molecular progression models outlining genetic events have been developed for many solid tumors, including colon cancer. Previous reports in the literature have shown a relationship between different KRAS mutations and prognosis and response to medical treatment in colon cancer patients. Furthermore, the presence of a mutated KRAS has been correlated with different clinicopathological variables including age and gender of patients and tumor location. To our knowledge, few institutions screen for KRAS mutations on regular basis in colon cancer patients despite such evidence that knowledge of KRAS exon 1 status is informative. Here, we report on a mutation analysis method adapted to a 96-capillary electrophoresis instrument that allows identification of all 12 oncogenic mutations in KRAS exon 1 under denaturing conditions. To determine the optimal parameters, a series of DNA constructs generated by site-directed mutagenesis was analyzed and the migration times of all mutant peaks were measured. A classification tree was then made based on the differences in migration time between the mutants and an internal standard. A randomized series of 500 samples constructed with mutagenesis as well as 60 blind samples from sporadic colon carcinomas was analyzed to test the method. No wild-type samples were scored as mutants and all mutants were correctly identified. Post polymerase chain reaction (PCR) analysis time of 96 samples was performed within 40 min.     

Effects of methyl substitution on radiative and solvent quenching rate constants of [Ru(phen)2dppz]2+ in polyol solvents and bound to DNA

Methyl substituents on the distant benzene ring of the dppz ligand in the "light switch" complex [Ru(phen)(2)dppz](2+) have profound effects on the photophysics of the complexes in water as well as in the polyol solvents ethylene glycol, glycerol, and 1,2- and 1,3-propanediol. Whereas 11,12-dimethyl substitution decreases the rate of quenching by diminishing hydrogen bonding by solvent, the 10-methyl substituent in addition also decreases both the radiative and the nonradiative rate constant for decay to the ground state of the non-hydrogen-bonded excited state species. For both the 10-methyl and the 11,12-dimethyl derivatives, the effect of methyl substitution on the equilibrium of solvent hydrogen bonding to the excited state is due to changes in the entropy terms, rather than in the enthalpy, indicating that the effect is a steric perturbation of the solvent cage around the molecule. When intercalated into DNA, the effects of methyl substitution is smaller than those in polyol solvent or water, suggesting that the water molecules that quench the excited state by hydrogen bonding to the phenazine aza nitrogens mainly access them from the same groove as in which the Ru(II) ion resides. Since the Delta-enantiomer of [Ru(phen)(2)10-methyl-dppz](2+) has an absolute quantum yield of up to 0.23 when bound to DNA, a value 7000 times higher than in pure water solution, it is promising as a new luminescent DNA probe.