Enhancement of electrical properties due to Cr substitution in Co-ferrite nanoparticles synthesized by two chemical techniques

Nanocrystalline cobalt ferrites with nominal composition CoCr_xFe_2−xO₄ ranging from x=0.0 to 0.5 with step increment of 0.25 were prepared by sol–gel auto combustion and chemical co-precipitation techniques. A comparative study of structural, electrical and magnetic properties of these ferrites has been measured using different characterization techniques. Structural and micro-structural studies were measured using X-ray diffraction, Fourier transform infra-red spectroscopy (FTIR), scanning electron microscopy and atomic force microscopy. Crystallite sizes of the series are within the range of 12–29±2 nm. Lattice parameters decrease by increasing Cr³⁺ concentration. FTIR confirms the presence of two lattice absorption bands. DC electrical resistivity increases to a value of ∼10¹⁰ Ω-cm with increase in Cr³⁺ concentration, but the most significant increase is in samples prepared by sol–gel combustion. Dielectric properties have been measured as a function of frequency at room temperature. Dielectric loss decreases to 0.1037 and 0.0108 at 5 MHz for chemical co-precipitation and sol–gel combustion, respectively. Impedance measurements further helped in analyzing the electrical properties and to separate the grain and grain boundary resistance effects using a complex impedance analysis. Magnetic parameters were studied using a vibrating sample magnetometer in the applied field of 10 kOe. The saturation magnetization decreased from 63 to 10.8 emu/gm with increase in Cr³⁺ concentration.     

Magnetic and electronic structure calculations of antiferromagnetic Mn2As

Magnetic and electronic structure calculations are performed for Mn₂As with antiferromagnetic (AFM), ferromagnetic (FM), and ferrimagnetic (FIM) spin ordering, using the full-potential linearized augmented plane-wave (FLAPW) method based on the generalized gradient approximation (GGA). It is shown that AFM is the magnetic ground state of Mn₂As, which is in agreement with the experimental observations. At a low temperature (0 K), AFM-FIM transition is also predicted which is consistent with the previous predictions. The ground state stability of the magnetic structure of Mn₂As is attributed to the nearest Mn (I) and Mn (II) antiferromagnetic interaction. The calculated magnetic moment of Mn (II) is found to be in good agreement with the neutron diffraction experiment while there is a disagreement for the magnetic moment of Mn (I). The different magnetic moments are reflected in the electronic structures of Mn₂As and the exchange splitting between Mn atoms is shown to be an intra-atomic effect.     

Ab initio prediction of pressure-induced structural phase transition of superconducting FeSe

External pressure driven phase transitions of FeSe are predicted using ab initio calculations. The calculations reveal that α-FeSe makes transitions to NiAs-type, MnP-type, and CsCl-type FeSe. Transitions from NiAs-type to MnP-type and CsCl-type FeSe are also predicted. MnP-type FeSe is also found to be able to transform to CsCl-type FeSe, which is easier from α-FeSe than the transition to MnP-type FeSe, but comparable to the transition from NiAs-type FeSe. The calculated electronic structures show that all phases of FeSe are metallic, but the ionic interaction between Fe-Se bonds becomes stronger and the covalent interaction becomes weaker when the structural phase transition occurs from α-FeSe to the other phases of FeSe. The experimentally observed decrease in T(c) of superconducting α-FeSe at high pressure may be due to a structural/magnetic instability, which exists at high pressure. The results suggest an increase of the T(c) of α-FeSe if such phase transitions are frustrated by suitable methods.     

Structural,magnetic and electrical properties of Co1−xZnxFe2O4 synthesized by co-precipitation method

Nanoparticles of Co_1−xZn_xFe₂O₄ with stoichiometric proportion (x) varying from 0.0 to 0.6 were prepared by the chemical co-precipitation method. The samples were sintered at 600 °C for 2 h and were characterized by X-ray diffraction (XRD), low field AC magnetic susceptibility, DC electrical resistivity and dielectric constant measurements. From the analysis of XRD patterns, the nanocrystalline ferrite had been obtained at pH=12.5–13 and reaction time of 45 min. The particle size was calculated from the most intense peak (3 1 1) using the Scherrer formula. The size of precipitated particles lies within the range 12–16 nm, obtained at reaction temperature of 70 °C. The Curie temperature was obtained from AC magnetic susceptibility measurements in the range 77–850 K. It is observed that Curie temperature decreases with the increase of Zn concentration. DC electrical resistivity measurements were carried out by two-probe method from 370 to 580 K. Temperature-dependent DC electrical resistivity decreases with increase in temperature ensuring the semiconductor nature of the samples. DC electrical resistivity results are discussed in terms of polaron hopping model. Activation energy calculated from the DC electrical resistivity versus temperature for all the samples ranges from 0.658 to 0.849 eV. The drift mobility increases by increasing temperature due to decrease in DC electrical resisitivity. The dielectric constants are studied as a function of frequency in the range 100 Hz–1 MHz at room temperature. The dielectric constant decreases with increasing frequency for all the samples and follow the Maxwell–Wagner's interfacial polarization.     

Investigation of the behavior of an Ising metamagnet under the influence of a field using Glauber dynamics

In this study, the kinetics of the Ising metamagnet where the interlayer interactions are ferromagnetic has been investigated under the mean field approximation. In describing the kinetics of the system, Glauber stochastic dynamics in the presence of an external field which performs time-dependent oscillations, has been utilized. Obtained results could be identified by two distinct types: the asymmetric solutions oscillating in the vicinity of finite values where the lattice magnetization has different values and the symmetric solutions being zero where the sublattice magnetizations are equal to each other. On the other hand, it has been observed that in the case where the system's initial state has a homogenous magnetization it exhibits two different periodical behaviors in the course of time.     

Electroreduction of Derivatives of N,N'-Dioxides of Phenazine and Quinoxaline in Nonaqueous Media and in the Presence of Proton Donors of Medium Strength

Russian Journal of Electrochemistry - The electroreduction (ER) of benzo[a]phenazine-7,12-dioxide (1) and 2-ethoxycarbonyl-3-methyl-quinoxaline-1,4-dioxide (2) in DMF on a glassy carbon electrode...     

Small Ubiquitin-Like Modifier Protein 3 Enhances the Solubilization of Human Bone Morphogenetic Protein 2 in <Emphasis Type="Italic">E. coli</Emphasis>

Small ubiquitin-like modifier (SUMO) fusion technology is widely used in the production of heterologous proteins from prokaryotic system to aid in protein solubilization and refolding. Due to an extensive clinical application of human bone morphogenetic protein 2 (hBMP2) in bone augmentation, total RNA was isolated from human gingival tissue and mature gene was amplified through RT-PCR, cloned (pET21a), sequence analyzed, and submitted to GenBank (Accession no. KF250425). To obtain soluble expression, SUMO3 was tagged at the N-terminus of hBMP2 gene (pET21a/SUMO3-hBMP2), transferred in BL21 codon+, and ~?40% soluble expression was obtained on induction with IPTG. The dimerized hBMP2 was confirmed with Western blot, native PAGE analysis, and purified by fast protein liquid chromatography with 0.5 M NaCl elution. The cleavage of SUMO3 tag from hBMP2 converted it to an insoluble form. Computational 3D structural analysis of the SUMO3-hBMP2 was performed and optimized by molecular dynamic simulation. Protein-protein interaction of SUMO3-hBMP2 with BMP2 receptor was carried out using HADDOCK and inferred stable interaction. The alkaline phosphatase assay of SUMO3-hBMP2 on C2C12 cells showed maximum 200-ng/ml dose-dependent activity. We conclude that SUMO3-tagged hBMP2 is more suited for generation of soluble form of the protein and addition of SUMO3 tag does not affect the functional activity of hBMP2.     

Biological entities as chemical reactors for synthesis of nanomaterials: Progress,challenges and future perspective

Synthesis of nanomaterials is being gained extensive attention in the fields of chemistry, applied physics, catalysis, drug delivery and the most important in diagnosis and therapeutic applications. Recently, many reports have been published on physical and chemical synthesis of magnetic as well as metallic nanoparticles (NPs) with viable surface functionalization, but still there is a dire need of such strategies that can combine synthetic methodology with stable surface modification found in nature. Synthesis of NPs via biological methods is the possible way to solve these barriers. However, systematized summary and outlooks of NPs synthesis via biological entities with various influencing factors e.g. temperature, pH, concentration of reactants and reaction time has rarely been reported. This review will present the distinct advantages of biological synthesis of NPs over physical and chemical methods. It will also highlight the recent progress on synthesis of NPs via various biological systems i.e. plant, fungus, bacteria, and yeast. Furthermore, it will explain various factors that control the size, shape, and morphology of these NPs. Finally, it would present the future perspectives of green chemistry for the development of nano-science and -biotechnology.