Protection of iron corrosion by stearic acid and stearic imidazoline self-assembled monolayers

A type of stearic imidazoline (IM) inhibitor was prepared using stearic acid (SA) and diethylenetriamine (DETA) as raw materials. The monolayers of IM and SA were assembled on the iron surface. The electrochemical characterization of stearic acid (SA) and stearic imidazoline (IM) on an oxide free iron surface had been studied. The monolayers of IM inhibitor were characterized by electrochemical impedance spectroscopy (EIS), electrochemical polarization curves, double layer capacitance, X-ray photoelectron spectroscopy (XPS) and molecular simulation. The results of electrochemical studies had illustrated that the inhibition efficiency of IM was higher than SA. XPS showed that the IM molecules adsorbed on the iron surface. The molecular simulation calculations showed that the IM molecules were tilted at an angle on the iron surface.     

N-Widths and Average Widths of Besov Classes in Sobolev Spaces

In this paper, we consider the n-widths and average widths of Besov classes in the usual Sobolev spaces. The weak asymptotic results concerning the Kolmogorov n-widths, the linear n-widths, the Gel＇fand n-widths, in the Sobolev spaces on T^d, and the infinite-dimensional widths and the average widths in the Sobolev spaces on Ra are obtained, respectively.     

Structural characterization and ferromagnetic behavior of Fe-doped TiO2 powder by high-energy ball milling

Fe-doped TiO₂ powder was prepared by high-energy ball milling, using TiO₂ Degussa P-25 and α-Fe powders as the starting materials. The structure and magnetic properties of the Fe-doped TiO₂ powder were studied by X-ray diffraction, ⁵⁷Fe Mossbauer spectroscopy and vibrating sample magnetometer. The Reitveld refinement of XRD revealed that ball milling not only triggered incorporation of Fe in TiO₂ lattice but also induced the phase transformation from anatase to rutile in TiO₂ and consequently the milled Fe-doped TiO₂ powder contained only rutile.⁵⁷Fe Mössbauer effect measure showed that Fe atoms existed in Fe²⁺ and Fe³⁺ state, which were assigned to the solid solution Fe_xTi_1−xO₂. The magnetization measurements indicated that the milled Fe-doped TiO₂ powder was ferromagnetic above room temperature. The ferromagnetism in our milled Fe-doped TiO₂ powder seemingly does not come from Fe and iron oxides particles/clusters but from the Fe-doped TiO₂ powder matrices.     

新超导体MgCNi3的虚晶掺杂研究

用全势线性缀加平面波方法,考虑局域自旋密度近似研究虚晶掺杂MgCNi3的超导电性和磁性.计算了自旋极化能带结构、体弹性模量和它对压力的导数、原子磁矩 m 及其变化率.计算结果表明,对于电子掺杂的Mg1-xAlxCNi3(0≤x≤0.5), 超导电性和磁涨落随掺杂量的增加逐渐减小.空穴掺杂的Mg1-xNaxCNi3,在x＝0.12处出现铁磁相变,超导电性消失.在MgCNi3少量空穴掺杂区域(0≤x<0.12),表现为超导与磁涨落共存的不稳定状态.     

一种时延范德波尔电磁系统中的复杂行为(Ⅰ)——分岔与混沌现象

建立了一种可积的无穷维系统——时延范德波尔电磁系统，采用Poincaré映射分析了系统随参数E和λ变化发生的分岔与混沌现象，发现这种时延系统具有复杂的非线性动力学特性，例如吸引子共存、间歇性混沌、类似边界碰撞分岔通向混沌以及周期增加的现象.在研究系统时间混沌行为的同时，还对空间混沌行为进行了初步分析，通过描绘空间分布图发现时延范德波尔电磁系统随参数E和λ变化时，在空间中会呈现出周期和混沌等不同的图案. 关键词： 分岔 混沌 无穷维系统 时延范德波尔电磁系统     

LiNbO3∶Cr∶Cu晶体吸收特性及非挥发全息存储研究

研究了LiNbO3∶Cr∶Cu晶体的吸收特性,发现LiNbO3∶Cr∶Cu（含0.14 wt.% Cr2O3 和 0.011 wt.% CuO）晶体存在两个明显的吸收峰,中心波长分别位于480 nm和660 nm; 随着Cr的含量逐渐减小,Cu的含量逐渐增大,短波段不存在明显吸收峰,掺Cr的含量越大,中心波长在660 nm处的吸收越大；633 nm红光虽然位于中心波长为660 nm的吸收峰内,但它无助于光折变过程.分别采用390 nm紫外光和488 nm蓝光作为敏化光,514 nm绿光作为记录光的记录方案,实现了非挥发全息记录,掺入适量的Cr( 比如NCr=2.795×1025 m－3,NCr/ NCu=1)有助于全息记录性能的提高.     

KNSBN晶体猫式互抽动相位共轭光特性

在KNSBN：Ce晶体中，利用二波耦合作用，在单一光束无法获得相位共轭光的条件下，实现了“猫”式互抽运相位共轭光输出，获得较高的共轭光发射率，实验结果表明，晶体的二波耦合作用可以使晶体的自抽运相位共轭光的阈值光强降低。入射光的入射角范围增大，响应时间缩短。     

退火温度对低温生长MgxZn1－xO薄膜光学性质的影响

用射频磁控溅射法在80℃衬底温度下制备出Mg_xZn_1-xO(x=0.16)薄膜，用X射线衍射(XRD)、光致发光(PL)和透射谱研究了退火温度对Mg_xZn_1-xO薄膜结构和光学性质的影响.测量结果显示，Mg_xZn_1-xO薄膜为单相六角纤锌矿结构，并且具有沿c轴的择优取向；随着退火温度的升高，(002)XRD峰强度、平均晶粒尺寸和紫外PL峰强度增大，(002)XRD峰半高宽(F 关键词： xZn_1-xO薄膜')" href="#">Mg_xZn_1-xO薄膜 射频磁控溅射 退火