纳秒激光诱导空气等离子体射频辐射特性研究

开展了波长为532 nm、脉宽为8 ns的纳秒激光诱导空气等离子体射频电磁辐射特性实验研究,基于锥形天线探测空气等离子体在30-800 MHz频谱范围有较强的射频电磁辐射,是等离子体内电偶极子振荡变速运动造成的.实验结果表明:随激光能量增加,30-200 MHz范围内射频辐射强度逐渐变强,但360-600 MHz频率范围射频辐射强度逐渐变弱.等离子体射频辐射的空间分布依赖于入射激光的偏振方向,当激光偏振方向与天线放置方向一致时,该方向上空气等离子体的射频辐射强度高,谱线较丰富.射频辐射总功率随激光能量先增加后降低,采用等离子体电子密度变化对等离子体频率及等离子体衰减系数影响(制约)关系,对射频辐射总功率随激光能量的变化规律进行了解释.     

High-Power Diode-End-Pumped Slab Composite Tm:YLF Compact Laser

We design a continuous-wave Tm:YLF laser with a composite slab crystal end-pumped by two fiber-coupled laser diodes at room temperature. We achieve a maximum continuous wave output power of 105 W for the bonded slab Tm:YLF laser; the corresponding slope efficiency is 47.7% and the optical-to-optical conversion efficiency is 42.0% with respect to the incident pump power. The laser operated at 1,907.5 nm with a beam quality factor of M² ～3.2 at the highest output power.     

电子辐照条件下初始电位对介质材料表面电位衰减特性的影响

为了研究航天器介质材料表面不同电位初始值对表面电位衰减特性的影响。利用航天器带电地面模拟实验设备对聚酰亚胺和聚四氟乙烯介质材料充电到不同电位值,然后关闭电子枪,用电位计测量介质材料表面电位的衰减曲线,并从理论上对cross-over现象进行分析。介质材料初始电位值越大,则表面电位衰减速度越快,且在一定的时间段内电位衰减效率随初始电位值的增大而变大;在相同的真空度条件下,对于初始电位值之和相等的两组衰减曲线,初始电位值之间差值较小的一组衰减曲线更容易出现cross-over现象;出现cross-over现象的时间和电子的迁移率相关,对于相同的两个初始电位,迁移率越大的材料则出现cross-over现象的时间越短,电位衰减会更快。航天器介质材料表面充电电位越大则衰减速度越快,在一定时间的衰减效率越高。     

Effect of replacement of Se by S on structural and physical properties of Ge–Sb–As–Se–S chalcogenide glasses

In the present study, the structural and opto-mechanical properties of Ge–Sb–As–Se–S chalcogenide glasses have been investigated. For this purpose, different bulk glasses of Ge₂₀Sb₅As₁₅Se_60?xS_x (0 ≤ x≤50) were prepared by conventional melt quenching technique in quartz ampoule and different characteristics of prepared glasses such as glass transition temperature, density, hardness, transmittance, optical band gap energy and refractive index were determined. The value of hardness and glass transition temperature of prepared glasses were found to increase with increasing the sulfur content as a result of formation of GeS₄ tetrahedral units and increasing the network connectivity and average bonding energy. The optical energy gap (according to Tauc’s relation), transmittance and refractive index of prepared glasses are in direct relation with sulfur content. In this study, the highest value of transmittance (about 70%) and lowest value of refractive index (2–2.3) was achieved in Ge₂₀Sb₅As₁₅Se₄₀S₂₀ and Ge₂₀Sb₅As₁₅Se₁₀S₅₀ glasses, respectively.     

Improvement of real time diffraction efficiency of NGD holograms by introducing electron donors

Nongelatin dichromated holographic film(NGD) is a new holographic recordingmaterial.Holograms recorded on this material have better environmental stability, higherdiffraction efficiency and stronger real time effect, etc..An experimental study to ascertainthe influence of two electron donors, namely,N,N-dimethylformamide(DMF) and dimethyl-sulfoxide(DMSO),on the real time diffraction efficiency(RTDE) of NGD holograms is car-ried out.The pressence of electron donors not only improves the sensitivity,but also enhancesthe real time effect greatly.RTDE of above 60% at±1 orders of NGD plane transimissiongrating is achieved by introducing electron donors.     

使用改进的形状优化方法设计高均匀度的超导MRI磁体

针对设计带铁磁的超导磁共振成像磁体,提出了一种确定类的优化算法来优化极靴的形状以达到匀场的目的。这种方法集合了灵敏度分析、形状优化的理论和有限元方法计算非线性铁磁材料极靴的配置,来改善两个极靴之间大体积成像区的磁场均匀度。需要指出的是,本优化方法不受极靴初始形状的限制,均可以快速收敛。我们通过一个紧凑型的1.2T双平面磁共振磁体,展示了这种方法。     

Nonautonomous solitons in the continuous wave background of the variable-coefficient higher-order nonlinear Schro¨dinger equation

We reduce the variable-coefficient higher-order nonlinear Schrdinger equation (VCHNLSE) into the constantcoefficient (CC) one. Based on the reduction transformation and solutions of CCHNLSE, we obtain analytical soliton solutions embedded in the continuous wave background for the VCHNLSE. Then the excitation in advancement and sustainment of soliton arrays, and postponed disappearance and sustainment of the bright soliton embedded in the background are discussed in an exponential system.     

Mg、B配比对MgB2材料的影响

我们通过固态反应法制备了MgxB2(x=0.2,0.6,0.8,1.0,1.2,1.4,1.8,2.2,2.6)系列超导样品.用四引线法测量了每一个样品在制备烧结过程中的高温R～T曲线.由这些曲线的升温阶段数据得知MgxB2系列样品的起始成相温度Tonset随着x值的增加而降低.由它们的X光衍射图可知,x≤1.0时,没有Mg和MgO的杂相峰;到x＞1.0后,随x值的增大,杂相Mg和MgO的衍射峰强度逐渐增强.它们的低温R～T曲线表明随x值的增加,正常态电阻减小,起始超导转变温度在39.3 K到39.9 K之间.综合Tc(onset)和△Tc,Mg1.4B2样品呈现出最好的超导状态.这些样品的单位质量M～T测量数据表明起起转变温度处于37.4～38.6 K之间,且Mg1.4B2样品呈现出最高的磁测Tc(onset)=38.60 K.在Mg含量x大于或低于1.4时,磁测Tc(onset)均小于此值.综合R～T和M～T这两种测量,为得到高Tc的MgB2超导块材,胚体MgB2的配比应取x=1.4为好.     

Spectroscopic properties of Ba 6pns (J=0,2) autoionizing series

The investigations on Ba and autoionizing states are carried out through a combination of the isolated core excitation method and proper polarization configuration of lasers. With comparison between the 6pns autoionizing states with different J, the spectroscopic properties of both the and series, such as the configuration interactions with the other series, are discussed in detail.     

乙醇在TiO2(110)表面光催化解离的动力学和超快电子动态学 (cited: 2)

采用实时双光子光电子能谱和时间分辨双光子光电子能谱技术分别研究了乙醇在该表面光催化解离的动力学和超快电子动态学过程. 通过测量与乙醇光催化解离相关的电子激发态随时间的演化,发现这个反应满足分型动力学. 乙醇在还原性TiO₂(110)上的光催化解离比在氧化性表面快,这归结于缺陷的存在降低了反应能垒. 这样一个反应的加速过程很可能是与缺陷电子相关的. 通过干涉双脉冲相关的测量,得到了乙醇-TiO₂界面电子激发态的超快动态学. 与甲醇的情况类似,这个电子激发态的寿命为24 fs. 激发态的出现为TiO₂和它周围环境的电子转移提供了一个通道.