Studies on the growth, optical, electrical and spectral properties of potassium pentaborate (KB5) single crystals

The bulk single crystals of nonlinear optical material potassium pentaborate (KB5) have been grown by slow evaporation solution growth technique using water as solvent. The grown crystal was confirmed by single crystal X-ray diffraction studies. The structural perfection of the grown crystals has been analyzed by high resolution X-ray diffraction (HRXRD) studies by recording rocking curve. The photoluminescence (PL), UV-vis spectral studies were performed and the optical bandgap of the material was calculated. FTIR and FT-Raman measurements enumerate the functional groups present in the compound. The factor group analysis on KB5 reveals that there are 117 vibrational optical modes. The dielectric behavior of KB5 was investigated with different frequencies and temperatures.     

Synthesis and NMR spectral studies of some 2,6-diarylpiperidin-4-one O-benzyloximes

Variously substituted 2,6-diarylpiperidin-4-one O-benzyloximes were synthesized by the direct condensation of the corresponding 2,6-diarylpiperidin-4-ones with O-benzylhydroxylamine hydrochloride. All the synthesized compounds are characterized by IR, Mass and NMR spectral studies. NMR spectral assignments are made unambiguously by their one-dimensional (1H NMR and 13C NMR) and two-dimensional (1H-1H COSY, NOESY, HSQC and HMBC) NMR spectra. All the synthesized compounds are resulted as single isomer, i.e., exclusively E isomer (9-14). The conformational preference of 2,6-diarylpiperidin-4-one oxime ethers with and without alkyl substituents at C-3 and C-5 has also been discussed using the spectral studies. The observed chemical shifts and coupling constants suggest that compounds 8-13 adopt normal chair conformation with equatorial orientation of all the substituents while compound 14 contributes significant boat conformation along with the predominant chair conformation in solution. The effect of oximination on ring carbons, their associated protons, alkyl substituents and ipso carbons are studied. Every proton in the piperidone ring of the oxime ether is observed as distinct signal due to oximination. The order of chemical shift magnitude in compound 8 is H-2a>H-6a>H-5e>H-3e>H-3a>H-5a. For 9-12, the order is H-6a>H-5e>H-2a>H-3a>H-5a, for 13, H-6a>H-2a>H-5e>H-3a>H-5a and for 14, the order is H-2a>H-6a>H-5e>H-3a>H-5a while the 13C chemical shift magnitude for 8-14 due to oximination is C-2>C-6>C-3>C-5.     

Growth and characterization of sodium pentaborate [Na(H4B5O10)] single crystals

The bulk single crystals of sodium pentaborate [Na(H4B5O10)] were grown by slow evaporation solution growth technique using deionized water as solvent. The grown crystal was confirmed by single crystal X-ray diffraction studies. The structural perfection of the grown crystals has been analyzed by high resolution X-ray diffraction (HRXRD) studies by recording rocking curve. The photoluminescence (PL), UV-vis spectral studies were performed and the optical bandgap of the material was calculated. The presence of the functional groups was identified by FT-IR measurement. The factor group analysis was done on Na(H4B5O10) to reveal the vibrational optical modes. The thermal and mechanical properties of the grown crystal were studied by TG-DTA and Vickers microhardness tester, respectively. The dielectric behavior of Na(H4B5O10) was investigated with different frequencies and temperatures.     

Advancing MXene Electrocatalysts for Energy Conversion Reactions: Surface,Stoichiometry, and Stability

MXenes, due to their tailorable chemistry and favourable physical properties, have great promise in electrocatalytic energy conversion reactions. To exploit fully their enormous potential, further advances specific to electrocatalysis revolving around their performance, stability, compositional discovery and synthesis are required. The most recent advances in these aspects are discussed in detail: surface functional and stoichiometric modifications which can improve performance, Pourbaix stability related to their electrocatalytic operating conditions, density functional theory and advances in machine learning for their discovery, and prospects in large scale synthesis and solution processing techniques to produce membrane electrode assemblies and integrated electrodes. This Review provides a perspective that is complemented by new density functional theory calculations which show how these recent advances in MXene material design are paving the way for effective electrocatalysts required for the transition to integrated renewable energy systems.     

Insecticidal activity of a novel fatty acid amide derivative from Streptomyces species against Helicoverpa armigera

Helicoverpa armigera, an important pest causes serious damage to grain legumes. The main objective of this study was to isolate and identify the metabolite against H. armigera from a previously characterised Streptomyces sp. CAI-155. The culture filtrate of CAI-155 was extracted using Diaion HP-20 and the active fractions were fractionated on Silica and C18 column chromatography. The C18 active fraction was further fractionated on Silica gel 60 F₂₅₄ thin layer chromatography (TLC). The most active fraction (Rf 0.64) purified from TLC led to the identification of a novel metabolite N-(1-(2,2-dimethyl-5-undecyl-1,3-dioxolan-4-yl)-2-hydroxyethyl)stearamide by spectral studies. The purified metabolite showed 70–78% mortality in 2nd instar H. armigera by diet impregnation assay, detached leaf assay and greenhouse assay. The LD₅₀ and LD₉₀ values of the purified metabolite were 627 and 2276 ppm, respectively. Hence, this novel metabolite can be exploited for pest management in future.     

Oxygen-release/storage properties of Ce0.5M0.5O2 (M = Zr, Hf) oxides: interplay of crystal chemistry and electronic structure

Fluorite-type Ce0.5Zr0.5O2 and Ce0.5Hf0.5O2 have been synthesized by a solution combustion route, and their oxygen release and reduction have been investigated up to 850 degrees C. On reduction, the zirconium system forms two pyrochlore phases, Ce2Zr2O7 (pyrochlore-I) and Ce2Zr2O6.2 (pyrochlore-II), while the hafnium system forms only a disordered fluorite phase with the composition Ce0.5Hf0.5O1.77, under the same experimental conditions. The crystal structures of the reduction products have been characterized by powder X-ray diffraction and Rietveld refinement, and their electronic structures have been investigated by photoelectron spectroscopy and electrical conductivity measurements. Pyrochlore-I (a = 10.6727(4) A) is a semiconductor, while pyrochlore-II (a = 10.6463(8) A) is a good conductor (with a nearly temperature independent resistivity of approximately 2.5 ohm.cm in the 400-1000 K range). X-ray photoelectron spectroscopy (XPS) shows an admixture of Ce(5d,6s) with Zr(4d) and O(2p) and a significant density of states near EF in the highly reduced pyrochlore-II phase. The changes have been rationalized in terms of a qualitative energy band scheme that brings out the special role of zirconium vis-à-vis hafnium in the reduction/oxygen release properties of Ce0.5Zr0.5O2 and Ce0.5Hf0.5O2.     

Ferroelectric liquid crystalline polysiloxanes containing a naphthalene moiety

The synthesis and thermal properties of side-chain liquid-crystalline polysiloxanes containing a naphthalene moiety are described. The hydrosilylation of the monomers (ω-alkenenaphthoic acid derivatives) with poly(hydrogenmethylsiloxane) resulted in the desired ferroelectric polymers. Two series of polymers were prepared using two slightly different core unit structures. Preliminary results of optical polarising microscopy and differential scanning calorimetric investigations are reported. The polymers show smectic A and chiral smectic C phases.     

8‐(2‐Bromo‐3‐methoxy‐3‐methylbutyl)‐7‐methoxycoumarin

The title compound, C₁₆H₁₉BrO₄, is a derivative of osthol, isolated from the seeds of Imperatoria Osthruthium. The structure was solved in space group P, with two mol­ecules in the asymmetric unit, and was refined to a final R factor of 0.064. The two mol­ecules in the asymmetric unit differ in the orientation of their brominated substituent group. The benzo­pyran ring displays aromatic character. The packing of the mol­ecules in the lattice is mainly due to C—H⋯O hydrogen bonds.     

Fast Quantum-Dot Cellular Automata Adder/Subtractor Using Novel Fault Tolerant Exclusive-or Gate and Full Adder

Quantum-dot Cellular automata is a promising area to implement digital systems at nano scale level. Adders and subtractors are widely used in almost every digital information processing system. This work targets to design an efficient 8-bit adder/subtractor that can perform addition as well as subtraction by using a novel control signal distribution scheme. To perform controlled inversion of inputs a novel exclusive-or gate with fewer cells is proposed. During Quantum-dot Cellular automata circuit fabrication, missing cell defects have the potential to affect the performance of a circuit. The proposed designs have higher fault resistance to missing cell defects compared to the existing state-of-the-art designs. Results demonstrate that the proposed design has (N-2) less clock phases compared to the existing state-of-the-art designs. The proposed design can be extended to implement any N-bit adder/subtractor. All the designs are designed and verified using coherence vector simulation engine in QCADesigner.

     

Time reversal technique for health monitoring of metallic structure using Lamb waves

Time reversal active sensing using Lamb waves is investigated for health monitoring of a metallic structure. Experiments were conducted on an aluminum plate to study the time reversal behavior of A₀ and S₀ Lamb wave modes under narrow band and broad band pulse excitation. Damage in the form of a notch was introduced in the plate to study the changes in the characteristics of the time reversed Lamb wave modes experimentally. Time–frequency analysis of the time reversed signal was carried out to extract the damage information. A measure of damage based on wavelet transform was derived to quantify the hidden damage information in the time reversed signal. It has been shown that time reversal can be used to achieve temporal recompression of Lamb waves under broadband signal excitation. Further, the broad band excitation can also improve the resolution of the technique in detecting closely located defects. This is demonstrated by picking up the reflection of waves from the edge of the plate, from a defect close to the edge of the plate and from defects located near to each other. This study shows the effectiveness of Lamb wave time reversal for temporal recompression of dispersive Lamb waves for damage detection in health monitoring applications.