40,48Ca+90,96Zr融合反应的动力学模型研究

应用改进的量子分子动力学模型,在严格挑选初始核考虑弹靶结构效应的基础上,研究了近垒和垒上融合反应^40,48Ca+^90,96Zr. 研究表明: 4个反应的理论计算截面与实验值很好符合; 丰中子反应⁴⁰Ca+⁹⁶Zr的垒下融合截面比其他3个反应有明显增强的现象.为了理解丰中子反应⁴⁰Ca+⁹⁶Zr与⁴⁰Ca+⁹⁰Zr相比垒下融合截面增强,而Ca+⁹⁶Zr垒下融合截面没有明显增强的原因, 进一步分析了484个反应的融合位垒,中子转移与融合位垒的关系、中子转移与Q值的关系,结果表明: 正反应Q值会引起核子(特别是中子)转移的增强,从而导致动力学融合位垒的下降和垒下融合截面增强.     

应力对La0.83Sr0.17MnO3薄膜输运性能的影响

采用溶胶-凝胶方法在Si(111)上制备了LSMO(x=0.17)薄膜.研究了块体材料和不同厚度薄膜R -T曲线、红外光谱和X射线衍射.结果表明，LSMO薄膜属于正交晶体结构，薄膜取向与膜厚度 有关，当膜厚度为450nm或680nm时，主要取向〈200〉，而膜厚度为900nm时取向为〈020〉 ：根据离子对相互作用能和谐振子模型，得到了红外吸收与Mn—O—Mn键长和键角关系式，6 00cm^-1附近红外吸收与晶格常数b的变化有关；块体与薄膜的金属—绝缘体转变 温度(T_MI)存在较大差别，薄膜转变温度显著低于块体，并与厚度有一定关系. 认为是LSMO薄膜中的应力诱导了晶格常数变化，引起键角改变及JT效应是转变温度变化的主 要原因. 关键词： 单晶硅 晶格常数 金属—绝缘体转变温度 应力诱导     

电沉积富铁Fe-Ni合金箔工艺的研究

对硫酸盐-氯化物电解液中电沉积富铁Fe-Ni合金箔的工艺进行了研究,讨论了电解液组成、电流密度、温度及pH值等因素与合金箔组成之间的相互关系,得到了制备富铁合金箔的最佳镀液组成及工艺条件,并通过实验确定在阴阳极比为1:2时,镍铁联合阳极配比为1.5:1.通过扫描电镜,能谱和X-衍射对富铁Fe-Ni合金箔的形貌及结构进行分析表明合金箔晶粒细致,尺寸均匀,结构紧密,表面光滑平整,无孔洞和裂纹,晶粒结构为(111),(200),(311)及(222)织构,并表现为较强的(111)择优取向.     

气-固流化床反应器内双流体力学模型及其验证 Ⅱ.单组分两维射流床内流场特性分析

由以质量、动量和能量三大守恒定律为基础的湍流两相流理论出发,建立了描述气固流化床内两相流动的数学模型;在微型计算机上编写了相应的数值计算和图形处理程序;为了验证模型的可靠性,本文着手模拟与分析了单组分颗粒体系两维射流流化床内气、固相速度场、空隙度和压力场随时间、空间变化规律;得到了与前人实验结果相吻合的结论。     

穿过液膜的自发电势振荡

An artificial membrane consisting of pricramic acid in nitrobenzene was used as an oil phase imposed between two aqueous phases. The right one contained trimethyl-slearylammonium chloride and aicohol; and the left contained sucrose solution (or H_2O). We found that this system exhibited rhythmic oscillation of electrical potential. The amplitude of the oscillations was between 20—150 mV. The oscillations were observed even when ethyl alcohol was absent in the aqueous of trimethylslearylammonium Chloride, and the increase in amplitude of oscillation with time was found to be less in the presence of sucrose. Some of the expremental results have been explained.     

SUPER TOUGH GELS WITH A DOUBLE NETWORK STRUCTURE

 Living tissues work with fantastic functions in soft and wet gel-like state. Thus, hydrogels have attracted much attention as excellent soft & wet materials, suitable for making artificial organs for medical treatments.However, conventional hydrogels are mechanically too weak for practical uses. We have created double network (DN) hydrogels with extremely high mechanical strength in order to overcome this problem. DN gels are interpenetrating network (IPN) hydrogels consisting of rigid polyelectrolyte and soft neutral polymer. Their excellent mechanical properties cannot be explained by the standard fracture theories. In this paper, we discuss about the toughening mechanism of DN gels in accordance with their characteristic behavior, such as large hysteresis and necking phenomenon. We also describe the results on tissue engineering application of DN gels.     

过硫酸铵水溶液对聚乙烯表面作用的研究

本文利用X光电子能谱(XPS)及其它技术对过硫酸铵水溶液处理聚乙烯表面改进粘合性的作用机理进行了研究。结果表明,过硫酸铵的氧化作用使聚乙烯表面引入酮、醛、羧基等含氧基团,使其粘合强度显著提高。高密度聚乙烯表面的氧化深度小于40,低密度聚乙烯的均匀氧化深度在40—90之间。处理后的聚乙烯表面未发现明显的交联产物。     

A Two-dimensional Lanthanide Coordination Framework with a New Amide-type Tripodal Ligand, 2,2′,2＂-Nitrilotris{[（2′- benzylaminoformyl）phenoxy]ethyl}amine

The La(III) complex with a new amide‐type tripodal ligand,2,2′.2″‐nitrilotris{[(2′‐benzylaminofomyl)‐phenoxylethyl)amine (L), was synthesized and characterized by X‐ray crystallographic analysis. Crystal data: C₄₈H_55.50LaN₇O_18.75, M_r=1169.40, monoclinic. space group, P2₁/n, a= 1.0644(3) nm. b=2.3889(5) nm, c= 2.1917(5) nm, β=90.65°, V=5.573(2) nm³, Z=1, D_c=1.394 g°cm^?3, R₁=0.0487, wR [1>2s?(I)]=0.1266. The results reveal that each La(III) ion binds to 9 oxygen atoms, three of which belong to carbonyl groups from three tripodal ligands and six to three bidentate nitrate groups and a two‐dimensional sheet of 4.8² networks is assembled by metal‐ligand coordination interaction. L, a heptadentate compound, merely acts as a tridentate bridging spacer due to its steric hindrance and links the La(III) ions as three‐connected nodes.     

1-烃基-1-硅杂环丁烷的合成及其Si—H键伸缩振动频率与结构关系的研究

硅杂环丁烷在有机硅化学中是一类非常重要的小分子环系化合物。由于硅杂环丁烷和环丁烷的环张力相似,因而显示出较高的反应活性。例如能与某些试剂作用,生成开环产物;在光解或热解条件下,产生具有Si=C结构的高活性中间体,可用以合成多种有机硅化合物。     

Synthesis of monodisperse poly(chloromethylstyrene-co-divinylbenzene) beads and their application in separation of biopolymers

The monodisperse, porous poly(chloromethylstyrene-co-divinylbenzene) beads of 7.9 microm were prepared by a single-step swelling and polymerization method. The seed particles prepared by dispersion polymerization exhibited good absorption of the monomer phase. Based on this media, a weak cation-exchange (WCX) stationary phase for HPLC was synthesized by a new chemically modified method. The prepared resin has advantages of biopolymer separation, high column efficiency, low column backpressure, high protein mass recovery, and good resolution for proteins. The dynamic protein-loading capacity of the synthesized WCX packings was 18.2 mg/g. Five proteins were separated in 3.0 min using the synthesized WCX stationary phase. The experimental results show that the obtained WCX resin has very weak hydrophobicity. The WCX resin was also used for the rapid separation and purification of lysozyme from egg white in 5.0 min with only one step. The purity and specific bioactivity of the purified lysozyme were found to be more than 93% and 70 245 U/mg, respectively.