射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

Ti含量对溶胶-凝胶法制备Ti、Ga共掺ZnO薄膜性能的影响

采用溶胶-凝胶旋涂法在玻璃衬底上沉积纳米结构Ti、Ga共掺ZnO薄膜(TGZO,Ga掺杂量为1.0;(原子分数,下同)),用X射线衍射仪(XRD)、扫描电子显微镜(SEM)、分光光度计(UV-Vis)、四探针测试仪、霍尔效应测试仪研究了Ti含量对TGZO薄膜的物相组成、表面形貌、电学和光学性能的影响.结果表明:所有TGZO薄膜均表现出六方纤锌矿的多晶结构,并具有(002)择优取向生长,在380～780 nm波长范围内具有良好的透射率(>86;);随着Ti含量的增加,TGZO薄膜的晶粒尺寸和可见光平均透射率均先增加后减小,而光学带隙和电阻率先减小后增加;Ti掺杂量为1.0;时,具有最高的可见光透射率92.82;,最窄的光学带隙3.249 eV,以及最低电阻率2.544×10-3Ω·cm.     

Noninvasive Temperature Measurement in Dental Materials Using Nd3+, Yb3+ Doped Nanoparticles Emitting in the Near Infrared Region

In this work, the application of near infrared (NIR)-emitting NaYbF₄:1%Tm³⁺@NaLuF₄:30%Nd³⁺ core–shell nanoparticles is reported for noninvasive probing and monitoring the temperature during photopolymerization of dental materials. When excited at 808 nm, the synthesized nanoparticles emit NIR photoluminescence (PL) with two distinctive peaks at 865 and 980 nm which correspond to radiative transitions from the doped Nd³⁺ and Yb³⁺ ions, respectively. Luminescence intensity ratio between these two bands is found to vary with temperature due to temperature-dependent electronic excitation energy transfer between Nd³⁺ and Yb³⁺ ions at the core/shell interface. This finding allows luminescence ratiometric evaluation of the in situ temperature during photopolymerization of resin cement (doped with nanoparticles) in a veneer placement procedure. In addition, the NIR emission also enables PL imaging of the distribution of the adhesive under the veneer. The results highlight that rare-earth ions–doped nanoparticles with both excitation and emission in the NIR spectral range are advantageous for both PL-based nanothermometry and imaging due to the reduced attenuation of NIR light by dental ceramics.     

Use of the internal standardization for difficult sampling by graphite furnace atomic absorption spectrometry

This work shows the potentiality of As as internal standard to compensate errors from sampling of sparkling drinking water samples in the determination of selenium by graphite furnace atomic absorption spectrometry. The mixture Pd(NO₃)₂/Mg(NO₃)₂ was used as chemical modifier. All samples and reference solutions were automatically spiked with 500 μg l⁻¹ As and 0.2% (v/v) HNO₃ by the autosampler, eliminating the need for manual dilutions. For 10 μl dispensed sample into the graphite tube, a good correlation (r=0.9996) was obtained between the ratio of analyte absorbance by the internal standard absorbance and the analyte concentrations. The relative standard deviations (R.S.D.) of measurements varied from 0.05 to 2% and from 1.9 to 5% (n=12) with and without internal standardization, respectively. The limit of detection (LD) based on integrated absorbance was 3.0 μg l⁻¹ Se. Recoveries in the 94-109% range for Se spiked samples were obtained. Internal standardization (IS) improved the repeatability of measurements and increased the lifetime of the graphite tube in ca. 15%.     

基于荧光内滤效应的锂离子荧光化学传感器研究

报道了一种基于荧光内滤效应的荧光增强型锂离子光化学传感器,将荧光试剂、亲脂性pH指示剂和锂离子中性载体结合在增塑的PVC膜中,Li⁺与H⁺在膜相中的竞争萃取效应引起受亲脂性pH指示剂调制的敏感膜荧光值的变化.推导了有关理论关系式,研究了该传感器的响应特性,并对人工合成样品进行测试,结果较为满意.     

角膜基质细胞在p(HEMA-MMA)改性前后的粘附率、形貌与力学性能变化

采用原子力显微镜(AFM)对改性前后材料表面粘附生长的角膜基质细胞的亲和力、三维形貌和力学性能进行了分析。结果显示,改性后材料的细胞亲和力有较大改善,且材料表面细胞三维形态更加正常,铺展更为舒展,与材料的接触面积较大。细胞力学性能分析也发现改性后材料表面细胞具有更高的粘附力和杨氏模量,以及更低的硬度,说明未改性p(HEMA-MMA)材料具有明显的细胞毒性,这种毒性作用导致在其表面生长的细胞的细胞骨架遭到破坏,细胞健康状态明显不如改性后材料表面细胞。因此,改性后的Col/bFGF-p(HEMA-MMA)更适合作为人工角膜材料使用。     

高效液相色谱-荧光检测法测定血清中的犬尿氨酸

建立了高效液相色谱-荧光检测(HPLC-FLD)测定血清中犬尿氨酸(kynurenine,Kyn)含量的方法。采用Hypersil C8色谱柱(300 mm×6.0 mm,10 μm), 流动相为0.25 mol/L醋酸锌及50 mmol/L醋酸溶液(含3%乙腈),流速为1.5 mL/min, 荧光检测激发波长和发射波长分别为365 nm和480 nm。血清标本经5%(v/v)高氯酸溶液去除蛋白质后取上层清液直接进样, Kyn经流动相等度洗脱分离后,用FLD进行测定。研究结果表明Kyn保留时间约为8.3 min,线性范围为0.098～19.6 μmol/L,最低检出浓度为0.04 μmol/L,回收率为90.8%～96.2%,日内、日间测定的相对标准偏差均小于5%,苯丙氨酸、酪氨酸、色氨酸、5-羟色胺和犬尿喹啉酸等物质对犬尿氨酸的测定均无干扰。建立的方法简便、快速、灵敏、特异,适用于临床和科研应用。     

一种紫外-可见光谱法检测水质COD的浊度影响实验研究

消除浊度影响是直接光谱法检测水质COD的关键技术问题。此源于紫外-可见光谱法检测水质参数的关键依赖于化学计量法所建立的准确的水质参数分析模型,而浊度是影响其建模的一个重要参数。为此,选取福尔马肼浊度液和邻苯二甲酸氢钾标准溶液,开展了紫外-可见吸收光谱法检测水质COD的浊度影响实验研究,获得了选定溶液在245,300,360和560 nm几个特征波长点的吸光度随浊度变化的最小二乘法拟合曲线,分析了吸光度随浊度的变化规律。研究结果表明,在240～380 nm的紫外光谱段,由于引起浊度的颗粒物对有机物产生了吸附,致使浊度对水样的紫外光谱影响较为复杂;在380～780 nm的可见光谱区域,浊度对光谱的影响则是随着波长的增大而减弱。基于此,开展了多元散射校正法对受浊度影响的水样光谱进行校正试验。对某溪水水样的紫外-可见吸收光谱进行多元散射校正,通过处理前后光谱对比表明,浊度引起各个波长点的基线偏移都得到了有效的校正,而在紫外区域特征并未减弱。接着对选取的三种液体的紫外-可见吸收光谱进行多元散射校正,实验结果表明：该方法可在不影响水样紫外-可见吸收光谱特征的前提下对其吸收曲线进行有效的校正,这不仅提高了光谱法检测水质COD的信噪比,而且还为化学计量法建立准确、有效的水质检测COD分析模型进行数据预处理提供了一种新途径。     

Study of Blood Porphyrin Spectral Profile for Diagnosis of Chronic Renal Failure

The progression to end-stage renal failure is independent of the initial pathogenic mechanism. Metabolic acidosis is a common consequence of chronic renal failure that results from inadequate ammonium excretion and decreased tubular bicarbonate reabsorption. Protoporphyrin IX (PpIX) is the immediate metabolic precursor of the heme molecule. The purpose of this study was to evaluate the levels of erythrocytes protoporphyrin IX at an animal model during progressive renal disease. A total of 36 eight-week-old male Wistar rats were divided into six groups: Normal, 4 and 8 weeks after 5/6 nephrectomy (NX). Renal function was evaluated by creatinine clearance and plasma creatinine levels. The autofluorescence of erythrocytes porphyrin of healthy and NX rats was analyzed using fluorescence spectroscopy. Emission spectra were obtained by exciting the samples at 405 nm. Significant differences between normal and NX rats autofluorescence shape occurred in the 600–700 nm spectral region. A correlation was observed between emission band intensity at 635 nm and progression of renal disease.