MIR imaging bundles of ordered silver halide polycrystalline fibres for thermal transmission and imaging

This study aims to experimentally examine the energy-saving potential by using R-134a filled separated two-phase thermosiphon loop (STPTL) for data center applications. A parametric study had been made to compare the energy consumption of two data center racks. Two fin-and-tube heat exchangers were attached to one of the racks to form two individual thermosiphon loops. The experiments were carried out subject to different operating conditions, including three ambient temperatures (20 °C, 23 °C, and 27 °C) and filling ratios ranging from 30 to 90% in association with heating loads ranging between 1.5 kW and 6 kW. Parametric influences regarding concentrated heat loading or uniform heat loading are studied. It was found that an appreciable energy-savings can be obtained at high filling ratios and a maximum of 49% energy-saving with the assistance of thermosiphon is observed. Accordingly, the rising of system pressure will result in noticeable savings. Relative to the uniform heat loading of the data rack, the thermosiphon shows even more energy-saving potential in concentrated heat loading. This phenomenon is more pronounced at a lower ambient temperature like 20 °C. On the other hand, there is no appreciable energy-saving for the thermosiphon between concentrated and uniform heating loads when the ambient temperature is high (27 °C). Furthermore, the influence of airflow rate was also investigated under various ambient temperatures with a 90% filling ratio and a heating load of 6 kW. The results revealed that the lower airflow rate in the thermosiphon yields comparatively better energy-saving than the higher flow rate. The study on the influence of using two STPTLs indicated that 15–23% energy-saving can be achieved at a 90% filling ratio and 6 kW heating load for all the studied ambient conditions if compared with testing each loop separately. Lower thermal resistance is seen at the higher filling ratios, ambient temperatures, and heating loads.

     

Pressure Improvement on a Supercritical High-Lift Wing Using Simple and Modulated Pulse Jet Vortex Generator

In this paper, an experimental study, aimed at delaying flow separation on a high-lift device using a pulsed blowing excitation method, is reported. The main objective of this investigation was to evaluate a new pulsed jet generation strategy to enhance flow control performance. In these experiments, two types of signal waveform were implemented to produce the unsteady blowing; a simple square-wave excitation signal for the first case, and a burst modulated excitation signal for the second case. The signal modulation was the first time to be used for a fast-switching solenoid valve actuator. Another objective of this study was to evaluate a new arrangement of the jet exit slots, in the form of a vortex generator which was employed for the first time on the high-lift device. For this purpose, a NASA SC(2)-0714 airfoil with a single slotted flap was employed. The vortex generator jets emanated from the shoulder of the trailing-edge flap with excitation frequencies from 40 to 1000 Hz. Pressure distribution around the model and wake total pressure deficit were measured. The results indicated that ejection from vortex generator slot pairs was able to prevent flow separation completely in most conditions. These measurements revealed that the burst modulated excitation signal was accompanied by more aerodynamic improvements and less air consumption relative to the simple pulsed jet excitation signal. In the best flow control mode, the results showed about a 53% increase in the value of the suction pressure peak on the flap and a 38% decrease in drag with a reduction in total pressure loss.

     

Biotechnological Innovations from Ocean: Transpiring Role of Marine Drugs in Management of Chronic Disorders

Marine drugs are abundant in number, comprise of a diverse range of structures with corresponding mechanisms of action, and hold promise for the discovery of new and better treatment approaches for the management of several chronic diseases. There are huge reserves of natural marine biological compounds, as 70 percent of the Earth is covered with oceans, indicating a diversity of chemical entities on the planet. The marine ecosystems are a rich source of bioactive products and have been explored for lead drug molecules that have proven to be novel therapeutic targets. Over the last 70 years, many structurally diverse drug products and their secondary metabolites have been isolated from marine sources. The drugs obtained from marine sources have displayed an exceptional potential in the management of a wide array of diseases, ranging from acute to chronic conditions. A beneficial role of marine drugs in human health has been recently proposed. The current review highlights various marine drugs and their compounds and role in the management of chronic diseases such as cancer, diabetes, neurodegenerative diseases, and cardiovascular disorders, which has led to the development of new drug treatment approaches.     

Demonstration of a 1/4-cycle phase shift in the radiation-induced oscillatory magnetoresistance in GaAs/AlGaAs devices

We examine the phase and the period of the radiation-induced oscillatory magnetoresistance in GaAs/AlGaAs devices utilizing in situ magnetic field calibration by electron spin resonance of diphenyl-picryl-hydrazal. The results confirm a f-independent 1/4-cycle phase shift with respect to the hf=j variant Planck's over 2pi omega(c) condition for j>/=1, and they also suggest a small ( approximately 2%) reduction in the effective mass ratio, m(*)/m, with respect to the standard value for GaAs/AlGaAs devices.     

Convenient Preparation of Glycosyl Bromides

Glycosyl bromides were prepared in very good yields by bromination of the corresponding anomeric hydroxyl group using a 1:1 mixture of triphenyl phosphite and bromine as reagent.