Synthesis and thermal characterization of copper and calcium mixed phosphates

A series of compounds with composition of Ca_1–xCu_xHPO₄, where x varied from 0.05 to 0.5 were synthesized by precipitation method. The compounds were characterized by elemental analysis, X-ray diffraction, infrared spectroscopy, scanning electron microscopy, and thermogravimetry. The chemical stabilities of solids were investigated at several pH. Elemental analysis of copper, calcium and phosphorus are in agreement with the proposed composition. The formation of lamellar phosphates was evidenced. The stability of the set of compounds was better for samples with high copper content.     

Determination of volatile organic compounds in urban and industrial air from Tarragona by thermal desorption and gas chromatography-mass spectrometry

This study describes the optimisation of an analytical method to determine 54 volatile organic compounds (VOCs) in air samples by active collection on multisorbent tubes, followed by thermal desorption and gas chromatography-mass spectrometry. Two multisorbent beds, Carbograph 1/Carboxen 1000 and Tenax/Carbograph 1TD, were tested. The latter gave better results, mainly in terms of the peaks that appeared in blank chromatograms. Temperatures, times and flow desorption were optimised. Recoveries were higher than 98.9%, except methylene dichloride, for which the recovery was 74.9%. The method's detection limits were between 0.01 and 1.25 μg m⁻³ for a volume sample of 1200 ml, and the repeatability on analysis of 100 ng of VOCs, expressed as relative standard deviation for n = 3, was lower than 4% for all compounds. Urban and industrial air samples from the Tarragona region were analysed. Benzene, toluene, ethylbenzene and xylenes (BTEX) were found to be the most abundant VOCs in urban air. Total VOCs in urban samples ranged between 18 and 307 μg m⁻³. Methylene chloride, 1,4-dichlorobenzene, chloroform and styrene were the most abundant VOCs in industrial samples, and total VOCs ranged between 19 and 85 μg m⁻³.     

Study on metal complexes of chelating resins bearing iminodiacetate groups

Cu(II), Co(II) and Ni(II) complexes of chelating resins (CR) bearing iminodiacetate (IDA) ligands were prepared. The CR-metal complexes were characterized by FT-IR spectroscopy, X-ray diffraction (XRD), thermal behavior (TG and DTG) under nitrogen atmosphere, and electron paramagnetic resonance (EPR). FT-IR spectra of the CR-metal complexes showed the characteristic bands of CR were still present but red-shifted after the metal complexation, and new bands assigned to Me-N bonds were observed. Thermal behavior of the metal-CR complexes supported the metal complexation, metal complexation leading to the decrease of the thermal stability of the CR, the lowest thermal stability being found when the highest amount of Cu(II) was loaded. Based on the EPR results and the thermal behavior of Cu(II)-CR complexes, the scheme for the complexation of Cu(II) on the CR was suggested.     

Comparison of photodynamic efficacy of tetraarylporphyrin pegylated or encapsulated in liposomes: In vitro studies

Two photosensitizing systems: (1) tetrakis(4-hydroxyphenyl)porphyrin (p-THPP) encapsulated in sterically stabilized liposomes (SSL) and (2) p-THPP functionalized by covalent attachment of poly(ethylene glycol) (p-THPP–PEG₂₀₀₀) were studied in vitro. The dark and photo cytotoxicity of these systems were evaluated on two cell lines: HCT 116, a human colorectal carcinoma cell line, and DU 145, a prostate cancer cell line and compared with these determined for free p-THPP. It was demonstrated that both encapsulation in liposomes as well as attachment of PEG chain result in pronounced reduction of the dark cytotoxicity of the parent porphyrin. The liposomal formulation showed higher than p-THPP–PEG₂₀₀₀ photocytotoxicity towards both cell lines used in the studies.     

A comparative study of calibration transfer methods for determination of gasoline quality parameters in three different near infrared spectrometers

This work presents a comparative study of calibration transfer among three near infrared spectrometers for determination of naphthenes and RON (Research Octane Number) in gasoline. Seven transfer methods are compared: direct standardization (DS), piecewise direct standardization (PDS), orthogonal signal correction (OSC), reverse standardization (RS), piecewise reverse standardization (PRS), slope and bias correction (SBC) and model updating (MU). Two pre-treatment procedures, namely standard normal variate (SNV) and multiplicative scatter correction (MSC), are also investigated. The choice of an appropriate number of transfer samples for each technique, as well as the effect of window size in PDS/PRS and OSC components, are discussed. A broad set of gasoline samples representative of the Northeastern states of Brazil is employed in the investigation. The results show that the use of calibration transfer yields prediction errors comparable to those obtained with complete recalibration of the secondary instrument. Overall, the results point to RS as the best method for the analytical problem under consideration. When storage and/or physical transportation of transfer samples are impractical, MU is more appropriate. The comprehensive investigation carried out in the present work will be of value for practitioners involved in networks of fuel monitoring.     

Comparison of analytical methods for the quality control of a new formulation containing soy extract and melatonin

Three analytical methods have been developed and compared for the quality control of a new formulation (Soymen GN(R) capsules) containing soy extract and melatonin for the treatment of menopausal symptoms. The first method is based on MEKC with diode-array detection, using a mixture of basic carbonate buffer (95%) and methanol (5%), containing 55 mM SDS, as the BGE. The second method is an HPLC method with UV detection at 260 nm. The third method is an HPLC method coupled to amperometric detection which is carried out at an oxidation potential of +0.8 V. In both HPLC systems, the chromatographic separation is obtained on an RP C18 column using a mixture of ACN and an acidic phosphate buffer (25:75 v/v) as the mobile phase. A feasible pretreatment procedure with a methanol/water mixture has been implemented to achieve the quantitative extraction of the main soy isoflavones and of melatonin from the capsules. The results obtained with the three methods are in good agreement with each other and satisfactory in terms of linearity (r(2) >0.9996), precision (RSD <5.4%) and accuracy (recovery >97%). Thus, each of the three analytical methods seems to be suitable for the simultaneous analysis of the main soy isoflavones and melatonin in the new commercial formulation.     

A series of three-dimensional coordination polymers with general formula [{Ln(H2O)n}{Re6Te8(CN)6}] · xH2O (Ln = Eu,Gd, Tb,Dy, Ho,Er, Tm,Yb; n = 3, 4, x = 0, 2.5)

A series of new compounds containing rare earth cations (Eu to Yb) and paramagnetic cluster anion [Re₆Te₈(CN)₆]³⁻ was prepared and investigated. The X-ray structural analyses have revealed that the compounds [{Ln(H₂O)₄}{Re₆Te₈(CN)₆}] · 2.5H₂O; Ln = Eu (1), Tb (3), Dy (4), Ho (5), Er (6), Tm (7), [{Gd(H₂O)₃}{Re₆Te₈(CN)₆}] · 2.5H₂O (2) and [{Yb(H₂O)₄}{Re₆Te₈(CN)₆}] (8) are three-dimensional polymers based on Re–CN–Ln interactions. Measurements of magnetic susceptibility for 2 and 5 showed that effective magnetic moment (at 300 K) was 8.13 μ_B for compound 2 and 10.79 μ_B for compound 5 with weak antiferromagnetic ordering appeared at low temperatures.     

Dynamic properties of soy globulin adsorbed films at the air-water interface

In this paper we present surface dilatational properties of soy globulins (beta-conglycinin, glycinin, and reduced glycinin with 10 mM of dithiothreitol (DTT)) adsorbed onto the air-water interface, as a function of adsorption time. The experiments were performed at constant temperature (20 degrees C), pH (8.0), and ionic strength (0.05 M). The surface rheological parameters were measured as a function of protein concentration (ranging from 1 to 1x10(-3)% wt/wt). We found that the surface dilatational modulus, E, increases, and the phase angle, phi, decreases with time, theta, which may be associated with protein adsorption. These phenomena have been related to protein adsorption, unfolding, and/or protein-protein interactions (at long-term adsorption) as a function of protein concentration in solution. From a rheological point of view, the surface viscoelastic characteristics of soy globulin films adsorbed at the air-water interface are practically elastic. The main conclusion is that the dilatational properties of the adsorbed films depend on the molecular structure of the protein.     

Synthesis of 2D Germanane (GeH): a New,Fast, and Facile Approach

Germanane (GeH), a germanium analogue of graphane, has recently attracted considerable interest because its remarkable combination of properties makes it an extremely suitable candidate to be used as 2D material for field effect devices, photovoltaics, and photocatalysis. Up to now, the synthesis of GeH has been conducted by substituting Ca by H in a β‐CaGe₂ layered Zintl phase through topochemical deintercalation in aqueous HCl. This reaction is generally slow and takes place over 6 to 14 days. The new and facile protocol presented here allows to synthesize GeH at room temperature in a significantly shorter time (a few minutes), which renders this method highly attractive for technological applications. The GeH produced with this method is highly pure and has a band gap (E_g) close to 1.4 eV, a lower value than that reported for germanane synthesized using HCl, which is promising for incorporation of GeH in solar cells.     

Combined Subcutaneous Fat Aspirate and Skin Tru-Cut Biopsy for Amyloid Screening in Patients with Suspected Systemic Amyloidosis

Screening for systemic amyloidosis is typically carried out with abdominal fat aspirates with varying reported sensitivities. Fat aspirates are preferred for use in primary screening instead of organ biopsies as they are less invasive and thereby minimize the potential risk of complications. At Odense Amyloidosis Center, we performed a prospective study on whether the combined use of fat aspirate and tru-cut skin biopsy could increase the diagnostic sensitivity. Both fat aspirates and skin biopsies were screened with Congo Red staining, and positive biopsies were subsequently subtyped using immunoelectron microscopy and mass spectrometry. Seventy-six patients were included. In total, 24 patients had systemic amyloidosis (11 AL, 12 wtATTR, 1 AA), and 6 patients had localized amyloidosis. Combined fat aspirate and skin biopsy were Congo Red-positive in 15 patients (overall sensitivity (OS) 62.5%). Fat aspirates were positive in 14 patients (OS 58.3%), and the skin biopsy was positive in 5 patients (OS 20.8%). In only one patient did the skin biopsy add extra diagnostic information. The sensitivity differed between AL and ATTR amyloidosis—81.8% and 41.7%, respectively. Using skin biopsy as the only screening method is not recommended.